介绍一种小尺寸的无刷直流电动机的设计。
用单片机实现的无刷直流电动机特性的优化控制。
Finally, the optimum control for the brushless DC motor has been achieved by using microprocessors.
本型电动机是专为高档跑步机配套的无刷直流电动机。
This type of motor is brushless DC motor and is specially designed for deluxe run-apparatus.
本型电动机为梳棉机自调匀整喂棉装置配套的无刷直流电动机。
This type of motor is brushless DC motor and is specially designed for autoleveller chute feed for cards.
提出了一种用无位置传感器的无刷直流电动机来作为电作动器的驱动电机的思想。
An idea is developed in the paper that position-sensorless BLDC motor is used as driver of EMA, with the advantages of maintenance and reliability besides small size and light weight.
本文对双极性调制的无刷直流电动机仿真分析了转速和调制频率对转矩影响同时给出仿真结果。
This paper simulates and analyses the torque pulsation because of the modulation frequency and speed variation under ambipolar pulse width modulation, at the same time the results are given.
系统的测试结果表明，基于DSP的无刷直流电动机控制系统，可以实现对电动机的全数字化双闭环控制。
The testing results show that the control system based on DSP can implement closed loop control the DC motor.
针对为磁悬浮飞轮(MSFW)转子提供旋转动力的无刷直流电动机(BLDCM)进行了可靠性方面的研究。
Brushless DC motor (BLDCM) as the key component of the flywheel, providing the power for rotor of magnetically suspend flywheel (MSFW) rotating, conducted its reliability.
以SPMC65 P 2404 A单片机为核心，设计了一种用于电动自行车的无刷直流电动机调速控制系统。
The design of the speed control system of brushless DC motor based on SPMC65P2404A is implemented, which used in the electric-bicycle.
本文采用了PC机、GMC2407运动控制专业平台来构成一个基于DSP的无刷直流电动机控制的试验平台。
In this paper, a brushless motor control platform which is based on DSP and made of PC and GMC2407 is adopted.
本课题基于无位置传感器技术，对应用于空调压缩机的无刷直流电动机系统做了一定的理论分析并进行了设计与实验测试。
Based on sensorless technology, the thesis has done some analysis theoretically and designed and tested the system of BLDCM used on air-conditioning compressor.
ML4428就是一种无位置传感器的无刷直流电动机控制器，是目前较先进的，集成度高的控制器，文中作了较详细的介绍。
ML4428 is a typical permanent magnet BLDCM controller without position sensor; it is an advanced high integrated controller, which was described in detail in this paper.
设计了以TMS320 LF 2407作为中央处理器的无刷直流电动机控制器，并将该控制器应用于混合动力汽车的驱动系统中。
A design of hybrid electric vehicle (HEV) brushless DC motor controller based on TMS320LF2407 with energy regeneration, which is used in the drive system of the HEV.
不足二盎司的自重，新的放大器却能够提供了广泛的电源电压范围，从而能驱动和控制规模在13毫米到30毫米的无刷直流电动机。
Weighing in at under 2 oz, the new amplifier is able to provide a broad supply voltage range, which makes the driver capable of controlling the smaller 13mm BLDC motors to the larger 30mm motors.
实验结果表明：在网络控制系统中无刷直流电动机转速响应快速，运行平稳，证明了这种新型控制系统的有效性和可行性。
The experimental result shows BLDCM response rapidly and run stableness in networked control system and proves the validity and feasibility of this control system.
无刷直流电动机在高性能驱动应用中具有良好的调整性能、高电压、高转矩、高体积比以及无电刷的优点。
Brushless direct current motors and have advantages of good adjustment performance, high voltage, high torque, high volumes ratio in high performance drive.
因此，对无刷直流电动机的应用，必须考虑其转矩脉动的抑制问题。
So the compensation of pulsating torque is very importance for the application of PMSMs.
本文是对无刷直流电动机做出深入的剖析与设计。
This paper intends to make a better on the Design of Brushless DC motor.
根据无刷直流电动机的特点和DSP芯片的功能，提出了基于DSP的控制方案。
According to the characteristic of BLDCM and the function of the chip, sensor control solutions which are based on DSP technology are presented.
阐述一种用于全电飞机机电作动系统的双绕组永磁无刷直流电动机。
A permanent magnet brushless DC motor was presented, which will be used for a Electro-Mechanical Actuator (EMA) in a All-Electric Aircraft(AEA).
文章重点阐述利用无刷直流电动机构建的井下压力闭环实验装置和以无刷直流电动机为控制核心的软件平台。
The paper places emphasis on the closed-loop system of pressure based on BLDC motor and the correlative software.
着重分析了电流参考信号超前角(滞后角)、系统参数和驱动方式对无刷直流电动机系统动态性能的影响。
The influence of the leading Angle (lagging Angle) of the current reference signal the parameters and drive mode of the system to the dynamic characteristics are analyzed.
本文正是基于这一考虑，对无刷直流电动机的控制技术与控制方法进行研究。
In view of above-mentioned reasons, this thesis makes a detailed study on the control technology and methods to BLDCM.
卫星姿控飞轮是由三相轮流换向无刷直流电动机驱动的，采用力矩控制(电流反馈)模式。
Satellite attitude control flywheel is driven by three-phase alternate commutating brushless DC motor, schema of which is torque control model (current feedback).
结果表明此无刷直流电动机的网络控制方案可行，为实现更复杂的远程控制提供了参考。
The result shows that the network control of brushless DC motor comes true, it provides reference for the more complex long-distance control.
依据永磁无刷直流电动机的数学模型及其转矩特性，分析了转矩脉动产生的多种原因，并介绍了各种有效的控制策。
According to the mathematical model and torque characteristics of permanent magnet brushless DC motor, the reasons that give rise to torque ripple have been analyzed in this paper.
分析了传统的PWM_ON调制方式对无刷直流电动机在非换相期间由于截止相的反并联二极管续流而导致转矩脉动的原因。
The torque ripple caused by diode freewheeling of the inactive phase during non-commutation state of PM brushless DC motor(BLDCM)when using the PWM_ON type of pulse width modulation was analyzed.
详细分析了目前电梯门机系统存在的问题，提出了以MSP430F149单片机为核心，无刷直流电动机为驱动机的系统方案。
The problems in elevator door-motor system and picks up the system scheme which adopts the DC brushless motor to act as driver motor based on MSP430F149 is analysed.
详细分析了目前电梯门机系统存在的问题，提出了以MSP430F149单片机为核心，无刷直流电动机为驱动机的系统方案。
The problems in elevator door-motor system and picks up the system scheme which adopts the DC brushless motor to act as driver motor based on MSP430F149 is analysed.
应用推荐