每行还通过继电器触点的漏泄电阻和电容耦合到每一列。
Each row is also coupled to each column through the relay contact leakage resistance and capacitance.
我做的测试超小阻值的仪器，一般用来测试开关继电器的接触电阻！
I do ultra-small resistance test equipment, the general used to test the relay switch contact resistance!
抖动，说明极有可能是消磁电阻损坏，如果没有响声则可能继电器及其控制电路有问题。
Jitter, that is very likely damage degaussed resistance, in the absence of sound may be the relay and control circuit problem.
其实，这是原则，是受雇于电器电阻炉。
In fact, it is the principle of electrical resistance that is employed by electrical heaters.
检查一下控电板和设备体上的那些电器设备，看看他们的绝缘电阻和绝缘强度是否合格。
Check whether the insulation resistance and the dielectric strength of the electric devices attached to the panel and equipment body are sufficient.
很多低电阻测量是在诸如开关、连接器和继电器接点等器件上进行的。
Many low resistance measurements are made on devices such as switches, connectors, and relay contacts.
如果负载电阻被直接连接到伏特计的输入端子，通过继电器触点的电流会产生电压降，测得的电池电压将存在误差。
If the load resistor was connected directly across the voltmeter input terminals, the current through the relay contacts would cause a voltage drop and the measured cell voltage would be in error.
按照国家标准GB4706.1- 1998的要求，在家用电器领域取消了绝缘电阻的试验。
According to National Standard of GB4706.1-1998, Isolation Resistance test has been canceled in home appliance field.
利用电阻应变片、动态压力传感器、滑环式引电器和磁带记录仪等，录取叶片振动应变和动叶出口压力信号，然后回放磁带，做信号处理。
Using resistance strain gage, dynamic pressure sensor, slip ring and tape recorder, the blade vibration strain and exit pressure signals of rotor blades are recorded and then processed.
消除了焊接处的电阻，有利于减少电能消耗，提高了电器性能，节省了材料，缩短了生产周期。
The resistance at welded parts is thus got rid of, which reduces power consumption, improves product function, saves materials and shortens production time.
该电阻器的阻值要保证被测装置发生故障时的短路电流不会超过开关卡上任一组继电器的最大电流指标。
The value of this resistor is chosen such that, in the event of device failure, the short circuit current will not exceed the maximum current specification of the relays on either set of switch cards.
对四边形和方向圆特性阻抗继电器躲线路最大潮流的能力进行了详细分析，提出了距离保护负荷限制电阻的整定原则和整定方法，并给出了整定建议值。
It puts forward the setting principle and method of load limiting resistor of backup distance protection and gives the propositional setting value of load limiting resistor.
预测继电器触点接触电阻的研究对于预测其接触可靠性，乃至预测其整体可靠性均具有非常重要的意义。
The prediction study on the contact resistance of relays is very significant to that on the contact reliability of relays, even to the whole reliability.
此类继电器能够增加系统安全性，并对三相交流接地电阻或接地配电系统进行可靠的低级接地故障检测。
They provide system security and immediate reliable low level ground fault detection on three-phase AC resistance grounded or grounded electrical distribution systems.
为此，提出了在继电器两端并联一个电阻器或者电容器的改进方案，使其起到降低输出继电器两端激励电压的作用。
Therefor, it is suggested that a resistor or a capacitor be connected with the relay in parallel to lower the exciting voltage at both ends of the output relay.
金属氧化物避雷器作为电力系统过电压保护的主要电器，其保护特性非线性电阻片的残压决定。
As the main appliance for overvoltage protection in electric system, the characteristic of Metal Oxide Surge Arresters (MOA) is decided by the unit residual voltage of non linear resistance.
电器触点间的接触电阻包括收缩电阻和薄膜电阻。
The contact resistance between contacts is composed of contraction resistance and velamen resistance.
分析了箱式电阻炉电气系统的工作原理及其局限性，介绍了采用交流固态继电器对电气系统进行改造的原理和实践。
This paper analyzed the working principle and limitation of electrical system of box resistor-stove. And introduced the principle and practice to remake this system with ac SSR.
在这种情况下，串联电阻就应该尽量靠近继电器，以限制电缆电容充电时的电流。
In this case, the series resistor should be placed as close to the relay as possible to limit the current when charging the cable capacitance.
在多点温度巡回检测系统中，多路切换部件干簧继电器接触电阻的变化是影响系统精度的主要因素。
In multiple-channel scanning thermometrical system, the change of connecting resistance of tongue relay is the main factor which influences the system precision.
用动态接触电阻测量系统进行了电磁继电器失效检测试验，监测了其触点闭合过程的接触压降。
The contacts voltage of counterpart contacts in the close course of electromagnetic relay is observed and recorded in its failure tests using dynamic contact resistance measurement system.
该继电器具有保护弧光电阻及适用于带串联补偿电容线路的正、反向动态特性曲线。
The dynamic characteristic of the relay increases its tolerance to fault arcing resistance and it can be used on transmission lines with capacitance compensation.
正常状态下，残留在泄露和过热感应器和各自的输出继电器上的电阻会被释放。
Under normal conditions the resistance remains between the leakage and over-temperature sensitivities, and both output relays are de-energized.
用动态接触电阻测量系统进行了电磁继电器失效检测试验，检测了其触点闭合过程的接触压降。
The contact voltage-drop of counterpart contacts in the closing course of electromagnetism relay is observed and recorded in its failure test using dynamic contact resistance measurement system.
经查是与四通阀线圈串联的控制继电器触点接触不良，电阻增大，致使电压降低。
The check is in the series of coil and four-way reversing valve control relay contact resistance increases, the bad, the contacts the voltage reduced.
以往来说，典型电路保护将继电器、可恢复式保险丝、与金属氧化物压敏电阻组合来保护防止损害。
Previously, a typical protection circuit would include a relay, resettable fuse and MOV combination to protect against the above combination of threats.
由电子元，器件组成的综合继电器不进行绝缘电阻的测定。
No measure to insulation resistance comprehensive relay composed of electronic device.
即使对于电阻性负载，屏蔽电缆的电容也可能会导致继电器触点焊接。
Even with resistive loads, the capacitance of a shielded connecting cable may cause relay welding.
即使对于电阻性负载，屏蔽电缆的电容也可能会导致继电器触点焊接。
Even with resistive loads, the capacitance of a shielded connecting cable may cause relay welding.
应用推荐