利用AD采集测试串接电阻电压实现阻抗测试；
Realizing the impedance test by sampling and testing voltage of series resistance with the AD convertor;
报道了一种适用于碲镉汞长波光伏探测器的由典型电阻电压（R-V）曲线提取器件基本特征参数的数据处理途径。
An data-processing method was developed to obtain the device parameters from the resistance-voltage(R-V) characteristics measured in long-wavelength HgCdTe photodiode.
文中将动态数据系统应用于电阻电压采样数据的处理，建立动态模型。该数学模型及有关判据，可用于监测与控制焊接过程。
The dynamic data system (a kind of time series analysis technique) is used in the processing of the data collection for electrode voltage and ARMA stochastic dynamic models established.
利用一个由恒流脉冲发生器和数据采集卡组成的简单测试系统测得制冷器在小电流下的电阻电压和塞贝克电压，通过这两个电压推导出ZT值、最大制冷温差。
The resistance and Seebeck voltages used to calculate the ZT and the maximum temperature difference are measured using a testing system composed of a DC pulse generator and a DAQ card.
向开关加上电压会促使带电的泡沫从金属中向上移动，这样从根本上降低了半导体的电阻和使它变成一整套的导体。
Applying a voltage to the device pushes charged bubbles up from the metal, radically reducing the semiconductor's resistance and making it into a full-blown conductor.
电阻是任何当电流通过时都能产生电压的元件。
A resistor is any device that, when you pass current through it, creates a voltage.
因为移动的电荷会产生电流，变化的磁通量会产生电压，新的设备会从电流中产生电压，像电阻一样，不过是以更加复杂、动态的方式。
Because moving charges make currents, and changing magnetic fluxes breed voltages, the new device would generate a voltage from a current rather like a resistor, but in a complex, dynamic way.
组装好电路后，记忆电阻的电压的节奏随着任意的外部电压脉冲而改变。
Wired up the right way, the memristor's voltage would vary in tempo with an arbitrary series of external voltage pulses.
泄漏电流是由测量电路和附近的电压源之间的寄生电阻通路产生的。
Leakage currents are generated by stray resistance paths between the measurement circuit and nearby voltage sources.
测试电气和电子设备和组件的连续性，电流，电压和电阻。
Test electrical and electronic equipment and components for continuity, current, voltage and resistance.
以氮气滑动弧为例，分析了其在一个周期内电弧电压、电流、电阻和功率的变化特性。
The arc voltage, current, power and resistance of a nitrogen gliding arc in one period were studied.
高阻电路的切换应用包括小电流、高电阻和高阻抗电压应用。
Switching applications of high impedance circuits include low current, high resistance, and high impedance voltage applications.
在任何电路中至少有三个量，它们是电压、电流和电阻。
There are at least three electrical quantities in any circuit, these are current, voltage and resistance.
IR测试系统中采用的开关卡的设计和类型取决于多个因素，包括测试电压、电阻数量级、准确度、共用连接，等等。
The design and type of switching CARDS used in an IR test system depend on several factors, including the test voltage, magnitude of resistance, accuracy, com mon connection, etc.
欧姆定律—在直流电路中，电压，电流与电阻的关系。
Ohm's Law - relationship between voltage, current and resistance in D. C. circuit.
注意，用这种方法计算电阻时，完全抵消了热电动势电压(VEMF)。
Note that the thermoelectric voltage (VEMF) is completely canceled out by this method of resistance calculation.
没有足以克服电阻的电压，电流就不会产生。
Without voltage sufficient to overcome the resistance, current will never flow.
虽然输入偏置电流是这种误差的常见来源，但是外电路产生的电流在源电阻上形成的电压降也能引起误差。
Although input bias current is a common source of this type of error, currents generated by external circuits can also result in errors due to voltage drops across the source resistance.
至此，我们已经讨论了专门针对电压、电流、电阻和电荷测量所要考虑的问题。
So far, we have discussed considerations specific to voltage, current, resistance, and charge measurements.
只使用具备适当容量的高级绝缘电线。尺寸过小的电线会造成电阻和随之的电压降落。
Use only high grade insulated wiring of suitable capacity. Undersized wires will cause resistance and consequent voltage drop.
关于屏蔽小电流、高电阻和高阻电压电路的更多信息，可参考第5章。
Further information on shielding low current, high resistance, and high impedance voltage circuits can be found in Section 5.
用于电焊机二次侧接线及连接电焊钳、电焊机的专用电缆，其特性是电阻大、电压低。
For the electric welding machine two secondary side wiring and electrode holder, welding connection cable, its characteristic is high, low voltage resistance.
电流的大小与电压成正比，与电阻成反比。
An current varies directly as the voltage force and inversely as the resistance.
如果被切换电流足够高，通道电阻会引起明显的电压降。
The channel resistance may cause a significant voltage drop if the current being switched is high enough.
而且，使用可调的电压源，还可以直接得到被测电阻对电压的依赖关系。
Also, with an adjustable voltage source, the voltage dependence of the resistance under test can be obtained directly.
跨接在电压源上的任何外部分流电阻都会使测量的电压衰减，如图2 - 3所示。
Any external shunt resistance across the voltage source will attenuate the measured voltage, as shown in Figure 2-3.
由于阻抗器的等效电阻为纯电阻，因此在调整电压的过程中不会产生谐波。
Because of the pure resistive nature of the equivalent resistance of impedor, no harmonic will be generated during the voltage regulation.
然后仪表通过同一套测试引线来测量电阻两端的电压，并计算出相应的电阻数值。
The meter then measures the voltage across the resistance through the same set of test leads and computes the resistance value accordingly.
由于流过齐纳二极管的泄漏电流会在电阻器上产生电压降，所以希望使用低漏电的齐纳二极管。
Since the leakage current through the zener diodes results in a voltage drop across the resistor, low leakage zener devices are desirable.
由于流过齐纳二极管的泄漏电流会在电阻器上产生电压降，所以希望使用低漏电的齐纳二极管。
Since the leakage current through the zener diodes results in a voltage drop across the resistor, low leakage zener devices are desirable.
应用推荐