接地电阻测量是接地施工中的一个重要环节。
Measurement of the grounding resistance is an important tache in grounding construction.
电路绝缘电阻测量。
在进行高电阻测量时,电路的建立时间特别重要。
The settling time of the circuit is particularly important when making high resistance measurements.
提出了一种用球形热敏电阻测量气流速度的方法。
Presents a method to measure the wind velocity with the thermistor as the velocity sensor.
本文主要分析电缆质检中导体直流电阻测量的不确定度。
This paper analyses uncertainty degrees of measurement of direct-current resistance in the cable quality inspection.
此方案成功地应用于变电站接地电阻测量变频电源控制电路中。
This project is applied to the control circuit of the frequency converter power source of for measuring ground resistance in an electric substation.
但是,正是这种宽广的通用性,也给电阻测量的应用带来了麻烦。
This very universalness, however, also causes the greatest headaches in resistance measurement applications.
当合理选用测量元件时,电阻测量的最大误差可在0.3%以下。
The maximum error of resistance measurement is within 0.3%, if proper measuring elements were chosen.
该测试在两个不同的电压之下进行电阻测量,然后计算出电压系数。
This test makes resistance measurements at two different voltage levels, then calculates the voltage coefficient.
在动电位法极化电阻测量中,选择合适的电位扫描速度十分重要。
A simple method of selecting potential sweep rate is given in the paper.
很多低电阻测量是在诸如开关、连接器和继电器接点等器件上进行的。
Many low resistance measurements are made on devices such as switches, connectors, and relay contacts.
结合工作站内部集成的导体电阻测量系统,可以实现阴极保护的功能。
It also can realize a cathodic protection function when the workstation is combined with a conductor resistance measurement system integrated in the workstation.
基于可补偿引线电阻影响的三线制铂电阻测量电路提出了一种高精度测温方法。
Based on a 3 wire platinum resistor measuring circuit, in which the lead wire resistance can be compensated, a high precise temperature measuring method is stated.
完成了导电环动态接触电阻测量系统的总体设计,包括硬件电路设计和软件设计。
The design of measuring system of dynamic contact resistance is achieved, including: hardware design and software design.
电容器漏泄测量和多芯电缆绝缘电阻测量是切换容性负载容易发生问题的两类应用。
Capacitor leakage measurements and insulation resistance measurements of multi-conductor cables are two applications where switching capacitive loads may be a particular problem.
当切换低压信号并进行低电阻测量时,可通过偏移补偿的方法消除热电效应偏移电压。
When switching low voltages while making low resistance measurements, the thermoelectric offset voltages may be canceled by using offset compensation.
各种低阻测量的应用:接点电阻测量、超导体电阻测量以及导电材料的电阻率测量等。
Low resistance measurement Applications: Contact resistance, superconductor resistance measurements, and resistivity measurements of conductive materials.
本文介绍用单片机作在线电阻测量的原理、线路和提高在线电阻测量精度的几种措施。
This paper describes the working principle of single chip microcomputers in dynamic resistance measurement, the circuits and various methods of improving measurement accuracy.
通过微型计算机的电阻测量部来测量箔(112)的第一部位和第二部位之间的电阻。
A resistance between a first place and a second place of the foil 112 is measured by a resistance measurement section of a microcomputer.
分析了布极方式对稳态接地电阻测量带来的测量误差,提出了多电极法的新型布极方式。
This paper present a new electrode arrangement by analyzing errors in grounding resistance measurement under steady voltage.
使用微欧计进行电阻测量必须采取四线技术以使测试电缆和连接器带来的误差减至最小。
Measurements made using the micro-ohmmeter are always performed using the four-wire technique in order to minimize errors caused by test leads and connections.
电阻测量是数字多用表的基本功能之一,减小误差提高测试精度是测量设备追求的目标。
Resistance measurement is a fundamental function of digital multimeter. The development of this device aims for reducing the error and improving testing accuracy.
用于测量所述燃料电池堆的电力负载上的高频部件的电阻的至少一个高频电阻测量装置;
The membrane humidification is measured at system shut-down by a high frequency resistance sensor that detects membrane humidification and provides the measurement to a controller.
如果使用分离的电流源和电压表来进行低电阻测量,则必须检查每台仪器的非欧姆接触情况。
If using a separate current source and voltmeter to make low resistance measurements, each instrument must be checked for non-ohmic contacts.
可以使用第3.2和3.3节所介绍的低电压和低电阻测量工作中使用的技术来测量电阻。
The resistance is measured using the techniques described in Sections 3.2 and 3.3 for low voltage and low resistance measurements.
对电梯绝缘电阻测量方法提出改进设想,同时对《关于绝缘电阻测量的质疑》一文提出异见。
This paper introduced an improvement of measuring the insulating - resistance of elevator, also some different opinions are provided about the query of measuring the insulating-resistance.
注意,这种测量方法是两线电阻测量,而使用静电计电压表和外部电流源则可以进行四线测量。
Notice that this is a two-wire resistance measurement compared to using the electrometer voltmeter and external current source, which can make a four-wire measurement.
用动态接触电阻测量系统进行了电磁继电器失效检测试验,监测了其触点闭合过程的接触压降。
The contacts voltage of counterpart contacts in the close course of electromagnetic relay is observed and recorded in its failure tests using dynamic contact resistance measurement system.
用动态接触电阻测量系统进行了电磁继电器失效检测试验,检测了其触点闭合过程的接触压降。
The contact voltage-drop of counterpart contacts in the closing course of electromagnetism relay is observed and recorded in its failure test using dynamic contact resistance measurement system.
用动态接触电阻测量系统进行了电磁继电器失效检测试验,检测了其触点闭合过程的接触压降。
The contact voltage-drop of counterpart contacts in the closing course of electromagnetism relay is observed and recorded in its failure test using dynamic contact resistance measurement system.
应用推荐