大部分人都知道，扬声器不是纯粹的电阻性负载。
As most of us are aware, speakers are not pure resistive loads.
通常的脉冲发生器只是在电阻性负载时才能得到陡的上升沿。
General pulsers can obtain sharp risetime only when it is used for a resistive load.
即使对于电阻性负载，屏蔽电缆的电容也可能会导致继电器触点焊接。
Even with resistive loads, the capacitance of a shielded connecting cable may cause relay welding.
斜槽电机的电阻性负载和阻感性负载时的实验波形，并对实验结果进行了分析。
The relative analysis of both the pure resistor load and resistor-inductance load are given also.
利用数字显示时间继电器、交流接触器、断路器以及电阻性负载设计了一个简易的触头材料实验电路。
The simple experimental circuit contact material is designed using time relays with digital display, contactors, switchgear and resistive load.
对加速性应力试验，所选的负载电阻要能够吸收比电源额定值较高的电流。
For accelerated stress testing, the load resistance may be selected to draw a level of current higher than the rated current of the power supply.
电容器漏泄测量和多芯电缆绝缘电阻测量是切换容性负载容易发生问题的两类应用。
Capacitor leakage measurements and insulation resistance measurements of multi-conductor cables are two applications where switching capacitive loads may be a particular problem.
阻性负载，功率因数为1 。采用特制合金电阻。
使用终端电阻也有不利的一面，它（额外地）加重驱动器的负载，增加装置的复杂性，改变偏置条件和造成系统日后修改困难更大。
There are disadvantages of termination as well. Termination increases load on the drivers, increases installation complexity, changes biasing requirements and makes system modification more difficult.
实际结果表明，电路对电阻性或电感性负载均具有较好的控制性能。
Practical application demonstrates that the circuit has good performance with resistive or inductive load.
而且目前人们在实验和理论分析中都将示波器作为纯电阻负载来研究光电导开关的输出电脉冲特性，这样就有失精确性。
Also, at present, people always treat storage oscilloscope as pure resistance when they study the output characteristic of PCSS's in experiments and theories, which makes the results not be accurate.
而且目前人们在实验和理论分析中都将示波器作为纯电阻负载来研究光电导开关的输出电脉冲特性，这样就有失精确性。
Also, at present, people always treat storage oscilloscope as pure resistance when they study the output characteristic of PCSS's in experiments and theories, which makes the results not be accurate.
应用推荐