通过实例，对模拟电子技术教学中应用等效电路变换的教学方法进行了探讨。
In this paper, using the equivalent circuit's conversion, the teaching method of analog electric technology is discussed through the examples.
内置智能电路，能自动变换充电器的输出极性以适应电池的正极和负极。
With the intelligent circuitry inside, it can automatically transform the charger output polarity to suit for the battery anode and cathode.
针对采用的生物传感器内阻高、信号弱、双极性等特点，用预处理电路对模拟信号进行了变换。
A preprocessing circuit is designed for analog signal transformation because of large inner impedance of biosensor and bipolar signal.
相乘器是由非线性元件组成，可以实现两个信号的相乘，完成频率变换的电路。
Multiplier is the circuit which is conformed of nonlinear elements and can make two signal multiplied so that it can implement frequency transformation.
采用德国西门子IGBT变频，电压反馈串联谐振电路。变换效率高达97.5%以上。
Adopt IGBT frequency conversion of German Siemens and voltage feedback series resonance circuit. The conversion efficiency is reaching up to above 97.5%.
两种等效电路可以通过简单的电源变换来实现相互转换。
The two equivalents may be obtained from one another by a simple source transformation.
该文系统地讨论二极管工作在开关特性下所组成电路的频率变换的工作原理。
This paper tries to discuss the work principle of frequency transformation on the circuit where diodes work on on-off speciality.
最后，设计了变换器的硬件电路和软件流程。实现了以TMS320F 2812DSP芯片为控制核心的样机。
And then, designed hardware circuit and software flow, realized a sample using TMS320F2812 DSP as kernel controller.
介绍一种旨在提高信号传输可靠性而设计的信号转换电路，它将电压信号变换成电流信号进行传输。
This paper introduces signal switchover circuit that transforms voltage signal to current signal in order to improve signal reliability.
本文提出了一种离散余弦变换电路VLSI实现的可测试性设计。
In this paper, a VLSI implementation method of design-for-testability for DCT is presented.
本文在对相位噪声的概念、产生及其相关测量方法研究的基础上，设计出一种低噪声频率变换电路。
This paper presents a new type of low noise frequency conversion circuit based on the research of phase noise conception, generation as well as relativity measurement method.
设计了复合储能系统功率变换单元电路拓扑，阐述了该复合储能系统的工作原理并制定了数字化控制策略。
Design of the hybrid energy storage system power conversion unit circuit topology, the energy storage system of the compound of the working principle and developed a digital control strategy.
本法避免了冗长的数学推导，仅应用了电路的等效变换概念。
These approaches only use the concept of equivalent transformation of circuits, and avoid the tedious mathematical derivation.
给出了基于这一方程出发设计的立体显示坐标变换电路。
It also gives the three dimensional display coordinate conversion circuit which is on the equation.
相对于降压式谐振开关电容变换器，升压式谐振开关电容变换器构成方式不同，潜电路发生条件也有较大区别。
Comparing to step-down resonant switched capacitor(RSC) converter, the composing principle of step-up RSC converter is different, so their sneak circuit conditions are not same.
尽管传统的单端正激变换器有诸多优点，如电路结构简单、元件数量少、输出纹波小等，但是也有其缺点。
But, despite its merits, the traditional single-ended forward converter has some shortcomings, such as simple circuit, low parts count, low output ripple, etc, it also has some shortcomings.
在此基础上，通过分析光伏阵列和光伏电池的关系及电路等效变换，建立任意功率级的PV仿真模型。
On the basis of this model, PV-array simulation model with any power output has been built by equivalent conversion of circuit according to the relation between PV cell and PV array.
函数发生器MAX038是具有整机功能的、将波形的产生和变换电路综合在一起的集成芯片。
The function generator MAX038 has complete machines function, the integrated chip synthesize of undee produce and transfer circuit.
在此基础上设计了三值ecl极性变换电路。
Then, the ternary ECL polarity transformation circuits are designed.
通过对几种电路的性能比较，提出了适合航天应用的DC - DC变换器的最佳拓朴结构。
Based on the comparison of the performances of some circuits, an optimal topology of the DC-DC converter suitable for aerospace electronic systems is proposed.
新加入的是直流路网中用斩波器和中间电路电压可调的功率变换装置。
Major innovation is the power conversion with chopper and controlled converter DC-link in direct current networks.
适用于信号偶合等极性需反转或变换的电路。
Used in circuits what polarity is reversed, such as signal coupling, etc.
对用负阻抗变换电路同圆锥螺旋天线相结合，构成的有源接收天线进行了理论分析。
An active receiving antenna consisting of conical helix antenna and a negative impedance changing circuit is analyzed in this paper.
本文对用一种负阻抗变换电路同电小天线导线相结合构成的有源天线进行了理论分析。
An active antenna consisting of electrically small antennas and a negative impedance changing circuit is analyzed in this paper.
其中包括信号的调制电路、电光变换、光检测器、均衡放大器和滤波器等。
It is Consisted of modulation circuits, electrical optical converting, photodetector, equalizing amplifier and filter etc.
根据冲击型探地雷达的原理，窄脉冲发生电路是探地雷达的一个重要的基本单元电路，它是组成脉冲发射电路和取样变换电路的重要组成部分。
According to the principle of impulse GPR, the short pulse generator is an important basic circuit of GPR, it is an important part of radiation excitation and sampling circuit.
围绕多电平变换器，新型电路拓扑及相关调制策略层出不穷。
Novel topologies and modulation strategies concerning multilevel converters are emerging continuously.
我们在最后的结论中提出了一个构想：构造少数几个对数域电路基元，再利用电路基元来简化用于连续小波变换实现的模拟电路设计。
In the final conclusion, we propose a ideal: by constructing few cells of log-domain circuits we use these cells to simplify the design of analog circuits for implementation of the CWT.
本文介绍了相量变换原理及其在正弦电路功率分析中的应用。
The phasor transformation and its applications in the AC power analysis are introduced in this paper.
本文介绍了相量变换原理及其在正弦电路功率分析中的应用。
The phasor transformation and its applications in the AC power analysis are introduced in this paper.
应用推荐