推导出系统输出和电路参数关系公式。
The relation between output voltage and the circuit element parameters is given.
找出了影响提高器件脉冲峰值功率的电路参数。
The circuit parameters affecting the increase of peak pulse power of the device have been found.
以图形和计算方式给出了电路参数的确定方法。
Based on graphics and calculation, it put forward a method of the resonant parameter selection.
提出一种检测线性模拟电路参数单故障的新方法。
A novel approach for diagnosing signal parametric faults of linear analog circuits is presented in this paper.
首先运用全波方法提取互连线的频变等效电路参数。
The frequency dependent parameters of the interconnection lines are extracted by the full wave method firstly.
通过导纳圆实验数据拟合，获得相应的等效电路参数。
With admittance circle fitting to experiment data, equivalent circuit parameters can be obtained.
给出了实验结果，并提出了几种改进电路参数的方法。
Here also presents experiment results and prefers several methods to improve circuit's parameters.
本文提出了一种减少混沌测量电路参数漂移的新方法。
An improved method of chaotic measurement to reduce the drift of parameter is presented in the paper.
《电工学》中电路参数的计算是电路分析与设计的基础。
Circuit parameter calculation in the book "Electrotechnics" is the basis of the circuit analysis and design.
另外还确定了IGBT的缓冲电路参数、死区时间参数等。
In addition, the appropriate parameters of snubber circuits and dead-times for IGBT were worked out.
介绍了轨道电路参数模拟装置的理论依据、方案和技术特征。
This paper introduces the basic theory, configuration and the technical characteristics of the parameter simulation device for trunk circuit.
此外，通过模拟的手段，分析了各种电路参数对放电电流波形的影响。
Moreover, by the means of simulation, the influence of circuit parameters on the current wave were investigated.
在相同电路参数时，经模拟得到的放电管电流脉冲波形和实测的波形相一致。
The discharge current pulse of the laser tube obtained by simulation is consistent with that of experimental measurement on the same condition of circuit parameters.
熟练运用节点电压法与网孔电流法是灵活掌握电路参数计算方法与技巧的关键。
Expertly using node voltage method and mesh current method is the key of flexibly mastering circuit parameter calculation method and technique.
换流阀内可控硅端电压分布特性取决于可控硅器件性能和相应的缓冲电路参数。
Both performance of thyristor and parameters of snubber circuit significantly affect voltage distribution in HVDC thyristor valve.
提出了一种采用时基电路的新型空载节电装置，并给出了电路参数和应用实例。
In this paper, a kind of new type automatic idle energy saving unit is designed with time base circuit.
根据本征频率计算了石英音叉的动态等效电路参数，计算值在实测值的离散范围内。
Based on the inherent frequencies the dynamic equivalent circuit parameters are calculated and the result is within the discrete range of experimental values.
本文介绍了已研制成功的二元轨道电路参数测试装置的组成原理、技术性能及应用。
The paper introduces the compositive principles, technical features and the application of the developed dualistic rail circuit to parameter testing equipment.
本文分析了检测电路的原理，在此基础上设计了实际电路，计算并调试了电路参数。
Based on analyzing the principles of detection circuit, it is designed and its parameters are calculated.
声波测井换能器的激发响应由换能器振动时所表现出来的动态阻抗和激发电路参数决定。
Sonic transducer response is affected by the dynamic characters of electricity and mechanics of the sonic transducer.
并测量了与激光器输出特性相关的电路参数，为该激光光源性能的进一步优化提供了依据。
Then the circuit parameters related to the output characters of the laser were measured to supply the gist of the further optimization of the laser source.
定期在线检测电气化铁道轨道电路参数，可确保信号设备工作在最佳状态，避免行车事故。
The electric parameters of rail circuit must be measured periodically to check if the signal system is in good condition and to avoid accident.
本文利用非线性电路的非线性性质和替代原理，提出一种新的非线性电阻电路参数识别法。
A new method is proposed to identify the parameters of a nonlinear resistive circuit by making use of the nonlinearity of circuits and by the substitution theorem.
同时分析了电路的频率特性和噪声特性，给出了电路参数选择方法及电路稳定性检验办法。
The characteristics of frequency and noise are analyzed, and it is presented how the circuit parameters are selected and the stability is checked up.
结合激光器的等效电路和速率方程分析，避免了单独测量寄生网络和估计有源区电路参数。
The advantage of this method lies in that there is no need to measure the parasitic network separately and estimate the circuit parameters of active region.
分析了磁场反接制动的机械特性，给出了相关电路参数计算，最后给出了改进的电路设计。
Analyze machine characteristic of anti-connect field to stop-motion and parameter compute and design of circuit are given by study.
给出了调节设定逻辑电平阈值的计算公式和部分电路参数，使逻辑电平界限清楚，判断确切。
It supplies the account formulas and partial circuits parameters of the threshold value for adjusting and setting-up logic level. It makes logical level boundary clear and well-judged.
通过分析其谐振电路参数，可以获得谐振参数与电路参数之间的关系，从而有利于优化设计此电路。
By analysis the resonance parameters, the relation between resonance parameter and circuit configuration can be achieved which is helpful to optimize the circuit design.
通过分析其谐振电路参数，可以获得谐振参数与电路参数之间的关系，从而有利于优化设计此电路。
By analysis the resonance parameters, the relation between resonance parameter and circuit configuration can be achieved which is helpful to optimize the circuit design.
应用推荐