实验结果验证了电路分析和实现。
Experimental results verify our circuit analysis and implementation.
实验结果表明，此测量电路能够满足酸碱溶液浓度测量分析的需要。
The experiment result shows that this measuring circuit is able to meet the needs of solution concentration analysis.
分析了其电路拓扑结构、工作原理，并给出实验结果。
This paper analyzes its circuit topological structure, principle of operation, and gives experimental result.
理论分析和实验结果标明，硬件电子电路工作正常，产生的工作信号符合工程度要求，CCD输出的模拟信号准确无误。
Theory analysis and experimental result indicated that electronic circuit worked normally, working signals conformed to the project requirement and the CCD analog signals were accurate.
通过对电路的理论分析和实验测试，并与传统的CMOS与非门比较，认为该两种ULG。
Through theoretical analysis, experiments and comparison with traditional CMOS gates, it is considered that either of the two practical circuits for ULG.
分析了在解码电路实验中，测量波形产生误差的原因，提出了采用有线电视系统传送信号的实验方法。
This paper analyzes reason of measure waveform produce error in decode circuit, put forward experiment means of adopt closed circuit television system transmit signal.
分析了电路波形及实验数据、对实验研究过程中的多频率峰值、谐波干扰和幅值干扰等进行了分析和处理。
A detailed analysis about the circuit waveform and experimental data is also given the multi-frequency peak value and the frequency interference during the experiment are all analysed and processed.
根据冲击电流计测直螺线管磁场的实验电路原理，利用数值计算方法，对减少测量的系统误差进行了理论分析。
According to circuit principle of the experiment of measuring magnetic field in straight solenoid by impact galvanometer, theory analysis on reducing system error is done by using numerical method.
结合数字电路实验教学实践，分析实验常见故障成因并提出排除实验故障的方法。
This paper analyses the common causes for the breakdown in digital circuit experiments and gives measures to the elimination according to experimental teaching practice.
给出电路接口方式、测量误差分析及实验结果曲线，液滴体积随液滴生长过程呈现良好线性关系。
Interface circuits, error analysis and experimental result graphs are presented. Excellent linearity between the drop volume and drop growth is achieved.
并对电路的线性度和故障检测能力进行了实验和分析。
Experiments upon the linearity and fault detecting capacity of the circuit are performed and the results are analyzed.
作为文中的一个例子，用FD - FDNR电路组成一个谐振回路，实验表明其频响特性与理论分析相一致。
As an example, a resonant loop is composed of forward differential FDNR circuit. The experiments show that the characteristics of its frequency response coincide with the theoretical analysis.
通过对主电路波形的实验分析验证了该方案的可行性。
The feasibility of the project is validated by analysing the experiment results of main circuit wave.
本文论述采用计算机辅助教学中的实验模拟方法来分析RLC串联谐振电路。
This arTicle introduces the experimental simulation of Computer-Assisted instruction to analyse RLC series resonant circuit.
介绍基于PSPICE电路分析程序的自动优化设计系统及其在对数视频放大器设计中的应用和实验结果。
The automatic optimal design system is based on the circuit analysis software-PSPICE. In application, a video log amplifier is designed and the results are presented.
通过分析确定了实验电路的方案。
Through the analysis it confirmed the experimental circuit's project.
提出了一种能改善气敏元件性能的新型取样电路，并对取样电路的特性作了理论分析和实验对比。
A new sample circuit is proposed in this paper to improve the properties of gas sensor, and the properties of sample circuits are analysed theoretically and compared experimentally.
利用该算法对线性预测系统的自相关数字电路进行了实验，并对算法的时间复杂性做了分析。
By utilizing this algorithm, we did an experiment about autocorrelation data circuit of linear forecast system and analyzed the tune complexity of the algorithm.
分析了所用的PWM驱动电路的输出电压和电流波形，并给出实际应用电路以及实验结果。
Analyzes the waveform of output voltage and current of PWM drive circuit, and also gives practical application circuits and test results.
本文研究了一种精密线性pwm电路及其误差模型，实验结果验证了理论分析的正确性。
This paper presents a new high linear PWM circuit and its error models verified with experimental results.
采用电路理论分析、差放理论分析、“虚短”理论分析及实验的方法对差分式放大电路进行了研究。
Research is made into the differential amplifier circuit by means of circuit theory analysis, differential amplifier theory analysis, "virtual-short" theory analysis and experiment way.
并对该电路做了理论分析和工频实验，在应用方面做了初步探讨。
Theoretical analysis is made and test result under the condition of power frequency for this circuit is also given.
对电路实验中继电接触器控制线路进行了研究分析，并提出由逻辑函数实现其控制的方法。
The article analyses control circuit of relay contactor in electric circuit experiment and puts forward to control it with logic function.
详细分析了电路的工作原理和特性，并给出了实验结果。
The principle and characteristic of the circuit are analyzed in detail, the experiment result is given.
文中分析了系统的工作原理，设计了硬件电路和双模控制算法。最后给出系统实验结果。
Also, this paper analyses the system working principle, the design of hardware circuits and the double-mode control algorithm, with the experimental results given eventually.
介绍了MATLAB的特点，在电路测试与实验中采用MATLAB语言进行电路的分析与设计，并通过实践论证了它的可行性。
This paper briefly introduces the characteristics of MATLAB, analyzes and designs the circuit in circuit testing and experiment using MATLAB and testifies to its feasibility through our practice.
详细地分析了其电路工作原理和参数的选择方法，并给出了实验结果。
The theory of circuit and how to select circuit parameter are analyzed in detail and the experiment result is given.
给出了电路元件的设计公式和必须满足的条件，最后用实验证实了理论分析的正确。
The formula and the necessary condition for component design in the circuit are given. Finally, the correctness of theoretical analysis is verified through experiments.
介绍了电容式称重传感器的结构，具体分析了其测量电路，提供了相应的实验数据。
The paper mainly introduces the structure of a capacititive weighing sensor, analyzes the measuring circuit in detail, and provides with the relevant experimental data.
介绍了电容式称重传感器的结构，具体分析了其测量电路，提供了相应的实验数据。
The paper mainly introduces the structure of a capacititive weighing sensor, analyzes the measuring circuit in detail, and provides with the relevant experimental data.
应用推荐