图论和神经网络是电路与系统的重要组成部分。
Graph theory and neural networks are important parts of circuits and systems.
新的建模技术是当前电路与系统理论中重要的研究课题。
New modeling technology is the most important subject in current circuit and system theory.
国际上一向认为，对非线性电路与系统进行符号分析是十分困难的。
It's long worldwide known that it's extremely difficult to process symbolic analysis in nonlinear circuits and systems.
以电子计算机为基础的电子设计自动化技术已广泛应用于电路与系统的设计中。
Has widely applied take computers as the foundation electronic design automation technology to the circuit and in the system design.
近年来，微波毫米波技术在电路与系统的小型化、高集成等方面提出了前所未有的挑战。
In recent years, microwave and millimeter-wave technology has issued unprecedented challenges on the miniaturization and high integration of circuits and systems.
低温共烧陶瓷(LTCC)技术是实现微波电路与系统小型化、高密度的重要组装和互连技术。
Low temperature co-fired ceramics (LTCC) becomes an important packaging and interconnecting technology for realizing microwave circuit and system's miniaturization and higher density.
采用传统的电路与器件的模型进行电路设计与模拟，已难以适应复杂的大规模电路与系统的设计需要。
Using the traditional model of circuits and devices to circuit design and simulation can no longer meet the needs of complex large-scale Integrated circuit design.
电力电子电路与系统中的复杂行为已经成为近年来电力电子学研究中的一个重要分支，受到了广泛的关注。
Researches on the complex behavior of power electronic circuits and systems have become an important branch in power electronics, and received great attention.
与腔QED系统相比，研究人员可以在许多领域定制电路。
In contrast to cavity QED systems, the researchers can custom tailor the circuitry in many areas.
新的集成电路条，更聪明的能让一台机器多功能运行的软件，更精巧的减少能量消耗与二氧化碳排放的冷却系统。
New processing chips, clever software that lets one machine do the work of many, and smarter cooling systems can all reduce energy consumption and thus carbon-dioxide emissions.
挠性电路皮肤甚至能够将人工肢体与神经系统相连接。
Stretchable electronic skin could connect an artificial hand to the nervous system.
详细阐述了系统的总体设计方案，给出了界面模块与89c51接口电路，最后介绍了软件设计方法及程序流程图。
This paper detailedly introduces the whole design scheme of the system, the circuit on interface module and 89c51, the method of the software design and program flow chart.
本文主要介绍8259a与32位单片机80960 KB的接口电路设计，为该单片机中断系统的扩展提供一种方法。
This paper mainly introduces interface circuit design of 8259a and 32 bit single chip microcomputer, provides a method for extension of 80960kb interrupt system.
与现有预处理仪的对比试验表明，设计的电路各项性能均优于现有预处理仪，可以应用到试车系统中。
By contrastive experimentation, it was indicated that the circuit designed excelled the existing equipment in many performances and could be applied to the engine test system.
利用一种新的电路模型系统研究了约瑟夫森结与谐振器的耦合效应。
Taking advantage of a new circuit model, we studied the coupling effect of resonator-coupled Josephson junction.
概述了控制系统的电源电路、驱动电路、显示电路与软件设计及信号采集的方法。
The power supply circuit, driving circuit, display circuit, software design and signal collection of the control system are outlined.
本文从构造汉字自动输入系统出发，着重阐述了IF—800微型机与C_(1000)光导摄象机的接口电路。
This paper start from structuring automatic input system of Chiuese characters, describes interface of vidicon camera C1000 to IF-800 microcomputer.
大量的实验结果表明：与基于模拟器的方法相比，采用该系统可以快速综合出可制造的深亚微米cmos模拟单元电路。
It has been demonstrated that compared to simulator-based method, manufacturable deep sub-micron CMOS analog circuits can be synthesized using this system in a short run time.
作为模拟电路与数字电路的接口电路，高性能的模数转换器对整个设计系统的实现非常重要。
As a special interface connected with analog and digital circuits, high performance analog-to-digital converter is much more important in whole system design.
这些微器件与信号调节和处理电路集成后，组成了可执行分布式实时控制的微电子机械系统(MEMS)。
These micro transducers can be integrated with signal conditioning and processing circuitry to form micro-electro-mechanical systems (MEMS) that can perform real-time distributed control.
以TMS320F2812作为主控CPU，以IR2110作为驱动芯片，完成了导弹舵机伺服控制系统的硬件设计，进行了控制器主电路的分析与设计。
The missile rudder servo controller adopts TMS320F2812 as main CPU, IR2110 as drive chip. Each part of main circuit is analyzed in detail.
把非线性系统的微分几何理论与混沌系统的同步控制目标相结合，设计了蔡氏电路混沌系统的标量混沌信号同步控制的非线性反馈控制器。
Combining the nonlinear control system theory and the aim of chaos synchronization, we designed a nonlinear feedback controller for synchronizing the scalar output signal of Chua's Circuits system.
给出了系统设计方案，其存储器技术的应用以及CRT驱动电路与光笔输入系统设计思想。
The design scheme for display operating, the application of memory technology, the design ideas for CRT drive circuit and light pen input system have been given.
硬件部分主要包括应变电阻片、信号检测电路、数据采集与处理系统等。
The part of the hardware includes strain resistance, signal detecting circuit, data acquisition and processing system, etc.
讨论了系统的构成、硬件电路与软件设计。
We will discuss system structure, hardware circuit and software design.
然后，在这一结论的基础上对原先的实验电路进行了结构的优化，使用软开关技术与谐振技术使输出电压、电流满足电源系统的基本要求。
Then we improve the circuit of the experiment based on the conclusion, make the current and voltage better using of the technology of soft switching and series resonance.
介绍了其传感网络的信号处理与放大电路及其数据处理系统。
The signal processing and amplier circuit of sensing net and its data processing system are introduced.
采用基于双dsp结构的有源滤波器可以大大改善滤波性能，并能抑制LC电路与电网之间的谐振，提高补偿系统动态性能。
The active filter based on dual DSP can improve the performance of filtering, restrain the resonance between LC circuit and electrical network, and improve dynamic performance of compensation system.
利用太阳能供电的超低功耗电路的设计与实现；系统软件以及硬件设计中的可靠性等问题。
Very low power consumption circuit is realized through solar energy, the design of the reliability problem is related to the system software and hardware.
通过与不同的接口电路板的连接，可构成多种应用系统，也可构成其它专业课程的智能控制单元。
By means of it, some teaching experiments for hardwares such as monolithic processor systems and peripheral interface devices, and software programming experiments can be conveniently carried out.
应用推荐