高分子电解膜是高分子燃料电池的关键材料之一。
Polymer electrolyte membrane (PEM) is a key material that strongly affects the cell performance, cost and application prospect of the PEM fuel cell.
质子交换膜燃料电池采用全氟磺酸固体聚合物膜为电解质。
Proton exchange membrane fuel cells use a perfluorosulfonic solid polymer film as electrolyte.
然后，在猫眼石结构表面用电沉积法镀上一层镍膜，之后把猫眼石蚀刻掉，再经过电解抛光，增加这些镍膜空隙度。
After that, a layer of nickel was electrodeposited on the opal, which was then etched away. The porosity of the nickel layer was then increased using electropolishing.
必须先做除锈及去氧化膜处理，一般使用化学抛光或电解抛光。
Must do derusting and to oxidation film processing, generally use chemical polishing or electrolytic polishing.
目的：了解电解质和电压因素对氧化膜成分、形态和稳定性能的影响。
Objective: To know the effects of electrolyte and voltage on the property of anodic oxide films.
质子交换膜燃料电池采用固体聚合物膜为电解质，简化了电池的水和电解质管理；
Proton exchange membrane fuel cells use a perfluorosulfonic solid polymer film as electrolyte that simplifies management of water and electrolyte.
膜中虽然保持了电池的大部分电解液，但必须使10%的隔膜孔隙中不进入电解液。
Membrane while keep the battery in the bulk of the electrolyte, but must make 10% don't enter the electrolyte membrane pore.
膜电解法制备氯化镍溶液同时生产镍粉，是一种新型的氯化镍和镍粉制备方法。
It is an new kind of method to make nickelous chloride solution and produce nickel powder by membrane electrolysis at the same time.
采用具有选择透过性的均质阴离子交换膜进行金电解。
A homogeneous anion exchange membrane with selective permeability was been applied to gold electrolysis.
本文叙述了阳极氧化工艺对稀土铝锰合金电解着色膜物理化学性能的影响。
The influence of technology of anodic oxidation on the physicochemical properties of rare earth Al-Mn alloy electrolytic coloured membrane is recited.
研究了ADC12铝合金表面微等离子体氧化法制备黑色陶瓷膜的电解液成分和电参数等对膜层性能的影响。
Influences of main parameters such as composition of electrolyte and electrical parameters in preparing black ceramic coating by microplasma oxidation on ADC12 aluminum alloy were studied.
采用电解复膜-光蚀技术研究了LD2 铝合金薄壁管材变形和再结晶组织特征。
The structure characteristics of deformation and recrystallization for LD2 Aluminium alloy tube were investigated by means of an electrolytic coating film-light etching technique.
本文分别利用聚电解质多层膜的压缩和热压技术两种方法构建了聚合物微结构。
The fabrication of micro-structures on polymer surfaces has been fulfilled via patterned compression of polyelectrolyte multilayers (PEMs) and thermal pressing method (TPM) respectively.
超级电容器主要由极化电极、集电极、电解质、隔离膜、引线和封装材料几部分组成，各部分的组成、结构均对其性能有重要的影响。
It consists of polarized electrode, collector, electrolyte, separator, lead and packing material, and its performances are affected by the composition and structure of each component greatly.
从阴极膜、固体电解质膜、阳极膜三个方面概述了近年来薄膜锂电池关键材料的研究进展。
The research progress in key materials of thin-film lithium battery in recent years was summarized in three aspects: cathode film, solid-state electrolyte film and anode film.
并用电解复膜原理和光蚀效应对研究结果进行了讨论。
The results were discussed from the principle of electrolytic coating film and light etching effect.
当电解质通过荷电镶嵌膜时，阴、阳离子分别通过其对应的交换单元。
When the electrolytes pass the membrane, anions and cations can flow in parallel through their respective exchange elements.
在应用研究中，本文结合离子膜电解槽控制的实际课题，设计了集优化、GPC控制和前馈为一体的先进控制系统。
As the part of application research of the thesis, an advanced control system combined with optimization, GPC and feedforward is designed for the project of ion exchange membrane electrolytic bath.
离子交换膜电解技术，由于膜的离子选择透过性，在分离无机离子和浓缩酸碱方面具有良好的发展前景。
The ion exchange membrane electrolysis has good development because of iron permselectivity of membrane in separating abio-iron and concentrating acid and alkali.
介绍了离子膜电解槽在生产运行过程中的腐蚀现象，讨论了产生腐蚀的原因。
The corrosion phenomenon of ionic membrane electrolyzer in production process was introduced. The reasons of corrosion were also discussed.
介绍了离子膜电解盐水系统中黏性酸碱不溶物的成因和危害以及解决措施。
Results, harm and solution of viscous acid-base insoluble object in ionic membrane electrolysis brine system were introduced.
以离子膜电解槽为例，介绍了串级控制系统的形成，分析了串级控制系统的工作过程、结构及特点。
Taking electrobath of hydronium film as an example, this paper introduces the form of cascade control system, and analyzes its working process, structure and characteristics.
该实验为膜电解钠碱法脱硫的应用提供了依据。
This experiment offered a basis for the application of membrane electrodialysis sodium alkali for desulfurization.
结果表明，铝阳极氧化膜经磷酸溶液交流扩孔后，氧化膜的电解着色性能发生了明显变化。
The results show that, after being treated by ac phosphoric pore broadening, the electrolytic coloring performance of the anodizing aluminium film varies obviously.
质子交换膜燃料电池(PEMFC)采用质子交换膜(PEM)作为电解质。
Polymer electrolyte membrane (PEM) is used as the electrolyte in polymer electrolyte membrane fuel cell (PEMFC).
介绍了采用新工艺精制离子膜电解槽盐水的工艺概况、特点及参数。指出了存在的问题及注意事项。
Process, characteristics and parameters of refined brine by new process for ionic membrane electrolyzer were introduced. The existing problem and points for attention were pointed out.
介绍了复极式离子膜电解装置整流设备的电压值偏高的现状。
The present status of high voltage of rectification equipment in bipolar type ion-exchange membrane electrolyzer was introduced.
对电解液中的各组分在成膜过程中的作用及电解工艺参数对成膜过程和膜层性能的影响进行了研究探讨。
The influences of electrolyte components and preparation parameters on the film-forming process as well as properties of oxidation film were discussed.
质子交换膜电解分解成氢气和氧气的纯净水。
PEM Electrolysers decompose pure water into hydrogen and oxygen.
质子交换膜电解分解成氢气和氧气的纯净水。
PEM Electrolysers decompose pure water into hydrogen and oxygen.
应用推荐