首先采用点电荷模拟，形成离子交换剂内孔配基模拟表面，构筑蛋白质-介质配基模拟表面体系。
Firstly, based on the analysis of pore radius and ligand distribution, the net of charged points were used to construct a simulated system of protein - adsorbent porous surface of ion exchangers.
该法还可推广于模拟电荷法及有限元法中。
In addition, the annular elements may be extended into the FEM and the Charge Simulation Method.
本文采用电荷耦合器件（CCD）获得了对模拟信号的连续可变延迟，并以CCD为中心部件构成了相关检测系统。
The changed delay for analog signals is obtained continuously with the charge coupled devices in this paper. The CCD's correlation-detection system is made.
模拟结果表明，该电荷泵的增益提高了大约14%。
Simulation results show that the charge pump gain is increased by 14%.
为了进行外加场强的计算，文中还简介了用模拟电荷法计算棒——板间隙场强的方法。
The charge simulation method for the calculation of the electric field intensity in the rod-plate gap is also briefly introduced.
通过模拟束流的传输过程，观察空间电荷效应对束流产生的影响，进一步对注入系统的元件参数进行适当的优化，从而对束流包络进行控制。
The infection of the space charge was observed by simulating the transmission of the beams, and the parameters of the system were optimized to control the envelope of the beam.
利用数值模拟方法研究了加速场强、注入相位、束团大小、形状、电荷等因素对束流横向发射度产生的影响。
The effect of field strength, initial phase, bunch shape and charge on electron beam transverse emittance is also explored by numeric simulation method.
本文基于最优化理论，利用模拟电荷法对一个小型的交叉场天线（CFA）进行了场的数值分析，得到CFA周围的电场、磁场及玻印廷矢量的分布。
In this paper, we introduce the basic theory and the design of CFA, and analyze the field of CFA by CSM on the basis of method of optimization.
利用有限差分法对有限长导体棒电荷面密度进行了数值模拟。
Applying the finite difference method, the numerical simulation of the surface charge density of a finite conductor stick is presented.
对简易式电荷放大器和模拟扫描器的原理也作了扼要介绍。
It also manes a brief introduction of the principle of the simple charge amplifier and the analogue scanner.
本文对三沟道体电荷耦合器件(BCCD)在X光区的光电特性进行了数值模拟。
In this paper the photoelectric characteristics of the three channel bulk charge coupled device (BCCD) are simulated in the region of X ray.
通过数据说明它较矩量法或模拟电荷法单独计算有效。
Numerical results show that it is more effective than moment method or simulation charge method when they are used separately.
模拟和测量结果显示磁场对MIG的束流有影响，MIG的束流也与阴极温度和空间电荷效应有关系。
Simulation and measurement result indicate that magnetic field influence the beam current of MIG, and the beam current of the MIG depends on the cathode temperature and space charge effect.
该电路的模拟部分包括电荷放大器、后级放大电器、相关双取样与采样保持电路、积分器、单位增益缓冲器。
The analog part includes self-test circuit, charge amplifier, post-amplifier circuit, CDS and S/H circuit, integrator, unity gain buffer.
本文提出用优化模拟电荷法结合优化增量方程，通过交替修正优化电荷的电量和位置参数来优化电极形状。
In this paper a new approach for optimising electrode contour is described, which combines the correction of coordinates and magnitudes of optimization charges with Optimized Charge Simulation Method.
从电荷复合理论出发，对叶绿体光诱导延迟荧光的产生机制进行了简化的理论模拟。
Based on the charge recombination theory, the mechanism for delayed fluorescence origin is theoretically analyzed in this paper.
用蒙特·卡洛法及数值解析法对电荷中和、电流中和过程进行了模拟计算并解释了实验结果。
Simulations of charge neutralization using Monte-Carlo and current neutralization process using numerical analysis have been done, and explanations of experimental results have also been made.
采用理论分析和粒子模拟的方法研究了阴极发射电子初始能量和二维效应对二极管空间电荷限制流的修正。
The 2-d effect and the initial energy influence of emitting electrons on space-charge-limiting current in diode are studied by PIC simulation and theoretical analysis.
该模型模拟计算结果与采用等效电荷方法数值计算结果相一致。
Simulation results are consistent with those of numerical method of equivalent charge distribution (ECD).
模拟结果与电荷漏斗模型相吻合。
The results of simulation are consistent with the model of charging funnel.
数值模拟结果表明，在放电期间恰当地调整电极上的驱动电位，可以改变介质层表面电荷积累，获得较高的壁电压。
The results show that after triggering discharge, the wall charges can be varied by adjusting the driving waveform, and the high wall voltage can be obtained.
文中提出用高斯列主元消去法与最优化方法相结合的技术求解模拟电荷方程组，是提高精度和保证收敛的一种有效算法。
The combined method of gnass elimination and optimization is used to solve the equation of charge-simulation, and it is an effective method for increasing the accuracy and assuring the convergence.
一些复印机，其中大部分是老式模拟复印机，采用了带正电荷的硒鼓和纸张，碳粉和负电荷。
Some copiers, mostly older analog copiers, employ a positively charged drum and paper, and negatively charged toner.
笔者应用模拟电荷法对球一板电极电场进行了计算，并用MATLAB语言编制了计算软件。
In this paper, this method is used to calculate electrical field of ball-plate electrode and board and use MATLAB language to program calculation software.
基于粒子模拟方法，对三维空间电荷力的计算采用全三维塑性宏粒子模型。
Super particle model is used to compute the 3-d space charge forces based on PIC.
基于粒子模拟方法，对三维空间电荷力的计算采用全三维塑性宏粒子模型。
Super particle model is used to compute the 3-d space charge forces based on PIC.
应用推荐