powerfail：只在init收到电源故障信号时执行命令。
Powerfail: Only execute the command if init receives a power fail signal.
提出了一种随机共振自适应算法，并运用于中频电源故障信号检测，取得了较好的效果。
A random resonance self-adaptive algorithm is stated and used for fault signal detection in medium frequency power supply with good result.
powerwait：只在init收到电源故障信号时执行命令，并且等待进程终止后再继续扫描inittab文件。
Powerwait: Only execute the command if init receives a power fail signal, and wait until the process terminates before continuing to scan the inittab file.
对系统硬件设计的DSP 3．3V电源的获取、电压电流采样模块、IGBT驱动、一般I／O信号的处理、故障监测和串口通信电路进行了研究分析。
The overall hardware design scheme is performed, such as DSP 3. 3V power, voltage and current sampling module, IGBT driving circuit, I/O signal processor, fault detection module and COM circuit etc.
提出了一种随机共振自适应算法，并运用于中频电源的故障信号检测，取得了较好结果。
An adaptive stochastic resonance algorithm is proposed and used in detecting the fault signal of intermediate frequency power source. The result is preferable.
选择性漏电保护是指当电网发生漏电故障时，能够有选择地发出故障信号或切断故障支路电源，而非故障部分继续工作。
The selectivity leakage protective system can give out alarming signal or cut off the fault branches selectively when the leakage fault happens, and the non-fault branches are working normally.
选择性漏电保护是指当电网发生漏电故障时，能够有选择地发出故障信号或切断故障支路电源，而非故障部分继续工作。
The selective leakage protective system can give out alarming signal or cut off the fault branches selectively when the leakage fault happens, and the non-fault branches are working normally.
最终查出造成机组事故的根本原因是可控硅励磁装置供电电源无工作状态监视信号及故障报警信号；
The final basic cause that resulted in the failure is no working state monitoring signal and failure warning signal of power supply source of controlled silicon excitation device.
论文中给出了抑制极电源的负反馈控制回路，设计了故障检测电路和开关柜的状态、控制信号流程图。
The paper presents the suppressor supply's feedback control circuits and also its fault detection circuit. As to the status and control signals, the control logic and interface board were designed.
论文中给出了抑制极电源的负反馈控制回路，设计了故障检测电路和开关柜的状态、控制信号流程图。
The paper presents the suppressor supply's feedback control circuits and also its fault detection circuit. As to the status and control signals, the control logic and interface board were designed.
应用推荐