在这个房间里没有蓄电池，只有电流转换器。
There are no accumulators in this room, just current transducers.
用不同的电流转换器看一下问题是否还存在。
Let's use a different current converter and see if the problem still persists.
外部电流转换器扩大了准确监测的电流范围。
External current transformer extends current range for accurate monitoring.
用不同的电流转换器看一下问题是否还存在。
I think we can find the result with the changed converter in a couple of days.
根据我们的经验，可能是电流转换时的发生故障。
Based on our experience, it might be a malfunction in the current converter.
提出了一种新型的CMOS电流转换电路的设计方法。
This paper presents the design method of a novel CMOS current conversion.
辅助开关实现零电流转换，它可以采用低成本的晶闸管。
The auxiliary switch operates with zero-current-switching(ZCS), which can use low-cost thyristor.
电压到电流转换器接收控制电压并生成第一电流和第二电流。
The voltage-to-current converter receives a control voltage and generates a first current and a second current.
发动机采用高压直流电驱动，电流转换通过直流-直流转换器实现。
The motor is powered by high voltage DC supply and the current from the fuel cell system is regulated via a DC DC converter.
介绍了在控制电路中，采用DJ 1电流转换装置的线路图，并进行了分析。
Introduction is made to the control circuit with adoption of DJ1 current switching device's circuit, as well as analysis.
对于直流电流测量﹐在电流通道串联一电流分流器﹐将电流转换成直流电压信号。
For DC current measurement, a current shunt is place in series in the current path and convert the current to a DC voltage signal.
结果发现：在电流过零处，等离子体未完全熄灭，使得电流转换后不需要第二次击穿。
The results show the plasma density is not completely lost during current reversal, therefore, there were no need for second breakdown after the current reversal.
从一个电流转换到另一个电流只需简单的一个按钮﹐或者在一个可以调节的频率下自动切换。
Changing from one preset current to another can be simple as pressing a button, or switch automatically at an adjustable frequency.
再者，所用的放大器也要考虑在加到输入端的整个共模电压(范围内)输入偏置电流转换保持平滑。
Again, consider using AMPLIFIERs that exhibit a smooth input bias current transition throughout the applied input common-mode voltage.
在微电流测量技术中，主要是考虑在有效抑制噪声的条件下对从微电流转换来的电压信号放大方法的研究。
The most important technique is voltage amplifier design in study of micro current measurement on condition that noise is restrained.
如果从一种装置到另一装置的瞬变电流过大，实际瞬变时间可以根据转化速率，通过分割电流转换的方法计算。
If the transient from one setting to another is large, the actual transient time can be calculated by dividing the current transition by the slew rate.
将采样得到的电机定子电压和电流转换为数字量后输入到转速估计系统来估计转速，并跟实际测得的转速进行对比。
The sampled stator voltages and currents were conversion to digital quantity and given to speed estimation system for estimating speed, then contrast it with the actual measured motor speed.
介绍了一种新型的电流转换器am402，详细阐述了其内部结构和工作原理，并给出了AM 402在测控电路中的具体应用。
This paper introduces a new current converter AM402 and detailedly discusses the inner structure and the working principle.
介绍了一种新型的电流转换器am402，详细阐述了其内部结构和工作原理，并给出了AM 402在测控电路中的具体应用。
This paper introduces a new current converter AM402 and detailedly discusses the inner structure and the working principle. And also shows the concrete application of AM402 in test control circuit.
高效发电机。一种发电机系统包括三相ac电机和应用低导通电阻MOSFET开关的有源整流器电桥，用于将来自电机的AC电流转换为DC电流。
A generator system that includes a three-phase ac machine and an active rectifier bridge employing low on-resistance MOSFET switches for converting the ac current from the machine to a DC current.
该系统的积分环节可采用运放作为核心器件，通过适当选择电阻和电容大小与线圈的互感匹配，将0～500A的电流转换为0～10V的电压进行测量；
The intergral implement of this scheme can use operational amplifier and change current of 0-500A to voltage of 0-10V by selecting resistance and capacitance properly.
设计电流模脉冲宽度调制直流转换器时，人们广泛采用斜坡补偿电路来消除谐波振荡。
In the design of current-mode PWM DC-DC converters, the slope compensation method is widely used to prevent sub-harmonic oscillation.
设计电流模脉冲宽度调制直流转换器时，人们广泛采用斜坡补偿电路来消除谐波振荡。
In the design of current-mode PWM DC-DC converters, the slope compensation method is widely used to prevent sub-harmonic oscillation.
应用推荐