如果电流切断，线圈就返回到原来位置。
Should the current be cut, the coil would return to its original position.
电流切断了，我们必须把它重新接通。
用另外两根电极在电流切断后测量电位。
A potential is measured across the other two electrodes after the current is shut off.
在检测到待机信号时，单片机控制继电器开关，将电流切断，家电完全断电，消除了待机功耗，达到节能的目的。
When detecting standby signal, microcomputer gives structure to relay switch to cut off the current, then standby power is eliminated so as to realize energy saving.
我们能看到，所有细节的空间动画分布，就在你打开电流和切断的时候。
We can actually see spatially all the details in the field animated as you turn the current on and off.
为了减少危险，比如电流，他先切断了电源。
To cut down the dangers such as electrical current, he cut off the electric source first.
因为一旦能量的来源被切断了，电流就会被切断——就好像当你关上开关，切断电流的时候，灯泡会立刻熄灭一样。
Because the source of the energy stops, the electrical current stops - just as a light bulb turns off when you switch off the electricity running to it.
因为一旦能量的来源被切断了，电流就会被切断——就好像当你关上开关，切断电流的时候，灯泡会立刻熄灭一样。
Because the source of the energy stops, the electrical current stops -just as a light bulb turns off when you switch off the electricity running to it.
过电流保护装置：试样击穿时在0.1S内切断电源。
Over current protection device: when the sample breakdown in the 0.1s cut off the power.
断路器具有很强的灭弧能力，既能切断负荷电流，也能切断短路电流。
Interrupter circuit breaker has a strong ability to both cut off the load current, but also cut off the short-circuit current.
如果电线的状况不明或是处于高压，应请专业人员切断电流或移走电线。
If the wire is of unknown or high voltage, get professional help to shut off the current or move the wire.
所谓限流就是熔断器在短路电流达到峰值之前就将其切断的功能。
The current limit is fuse in short circuit current peak before cutting off its function.
在电流过大或设备有故障时，能自行熔断以切断电路的保护电器。
In the current is too large or equipment failure on their own to cut the fuse protection of electrical circuits.
低压供用电系统中为了减少发生人身电击事故和接地故障切断电源时引起的停电，必须加装剩余电流动作保护装置。
In order to reduce the power cut off which caused by electric shock accident and earth-fault power cut off, it must install residual current operated protective device.
塑壳断路器塑壳断路器能够自动切断电流在电流超过跳脱设定后。
Molded case circuit breaker a molded case circuit breaker automatically interrupts the current flowing through it when the current exceeds the trip rating of the breaker.
低压或高压开关- - -用于当水压降低到预先设置的最低值或超过预先设置的最高值时，切断控制电流。
Low or high pressure switch - turns off control circuit when water pressure drops below a set minimum, or above a set maximum.
当你切断电流，电磁场就消失了。
And when you turn the current off, the magnetic field collapses.
将衬底中设置的开关器件导通，并且向与开关器件电连接的熔丝施加编程电流从而切断熔丝。
A switching device disposed in a substrate is turned on and a program current is applied to a fuse electrically connected to the switching device, thereby cutting the fuse.
下面金属线，携带电力负荷，因此防御闪电，闪电可能切断电流或损坏设备。
Lower wires, which carry the power load, are thereby protected against lightning, which might shut off the current or damage equipment.
当电路出现故障使回路电流增大时，过载保护PT C热敏电阻的电阻值因自热温升而出现阻值阶跃，直至把电路切断。
When the circuit breaks down and the return circuit current increases, the resistance of restricting overloading protection PTC Thermistor goes up sharply for being warm, until the circuit is cut off.
温控器开启后，通往电机的电流就会被切断。当电机温度冷却下来后，温控器将自动重新启动电机，泵设备又恢复正常运转。
When the thermostats open, power to the motor is interrupted. When the motor has cooled down, the thermostats automatically reset and the pump can resume normal operation.
并联跳闸装置- - -一旦控制装置监测到故障发生或电流过载，将自动切断所有连接热水器的所有电源，最大限度保护热水器。
Shunt trip disconnecter - provides maximum protection by interrupting all power to the system in the event of a control sensed malfunction or overcurrent.
在工作中，如果控制激光器温度的温控器失效，恒流源自身的过热保护功能可切断驱动电流，强迫激光器停止工作，确保了激光器的安全使用。
During the work, if the temperature controller is invalid, the excessive heat protect circuit can cut the driving current, and force the laser to stop work to insure the safety of lasers.
KA5为跳闸报警继电器。当设备产生偏励磁、可控硅故障、过电流等故障时，KA5吸合，断路器分励线圈得电跳闸，切断主电源。
When there are bias excitation, controllable silicon failure, over current and other failures, KA5 gets absorbed and breaker loop trips by powered on so as for switching off main power supply.
①分别接通各个接触器，依次拨通相应的限位开关和过电流继电器常闭触头，查看其切断控制电流的能力。
Respectively through the various contacts, in order to dial the corresponding limit switches and over current relay normally closed contacts, to see the ability to cut off the control current.
修理时，要切断电流。
修理时，要切断电流。
应用推荐