建立了实现阈值控制电路的电流传输开关运算。
The operations of current transmission switch used to realize threshold-controlling circuits were established.
建立了实现阈值控制电路的电流传输开关运算。
The operations of current transmission switch used to realize threshold-controlling circuits are established.
微型化也意味着激活软件指令时的电流传输距离变短。
Miniaturization also means a shorter distance that electricity has to travel to activate software instructions.
提出了利用电流传输器设计新型电流型有源滤波器的新方法。
A new method to design a new type current-mode-active filters using current conveyors is presented.
该电路具有电源电压低、频带宽、电流传输精度高、及成本低廉且实用性好的特点。
The circuit has some advantages, such as low supply voltage, wide-band, the high accuracy of voltage and current transfer, low-cost, and good practical Properties so on.
根据电流传输机构，本文提出一种考虑了电荷积累、陷阱密度及其重心位置的击穿模型。
According to the mechanism of current transport, we suggest a breakdown model in which charge accumulation, trapping density and position of its center of gravity are all considered.
提出了由电压模式有源RC滤波器导出基于第三代电流传输器的电流模式滤波器的方法。
This article describes a new method of changing the variable of state active RC filter to current-mode filter base on the third-generation current conveyor.
该电路具有电压传输和电流传输的精度高、结构简单、易于实现及成本低廉且实用性好的特点。
The circuit has a characteristic of high accuracy of voltage transfer and current transfer, simple structure, easy realization, low cost, and good utility.
该电路具有频带宽、电压传输和电流传输精度高、结构简单、易于实现及成本低廉且实用性好的特点。
The circuit has wide frequency bandwidth, high voltage and current transfer accuracy, simple structure. For this reason, it is easy to be realized with low cost for universal applications.
该方法可以利用跨导线性电路、电流镜、电流传输器、开关电流电路等单元电路来分析常用电子电路。
The method can analyze electronic circuits by using Trans Linear circuits, Current Mirrors, Current Conveyers, Switched Current circuits in common use.
汇集到机舱底座的雷电流，传送到塔架，由塔架本体将雷电流传输到底部，并通过接入点传输到接地网。
Lightning electricity is collected in the base of engine, transmit to tower, from the tower to the base, and by earthing point to earthing net.
本文提出了两种基于MOCCII(多端输出的第二代电流传输器)的多输入多输出的电流模式滤波器。
Two kinds of current-mode filters with multiple inputs and multiple outputs based on MOCCII (second generation current conveyor with multiple-terminal outputs) are presented.
由于存在逆向电流，利用电流传输开关特性的改进型的电压泵(NCP - 1)的电压增益被大大减弱。
Because of the existing of reverse current, the output voltage of charge pump, NCP-1, which is utilizing charge transfer switches, is not as high as expected.
按100 000英里电线长度除以镜子转动的次数来计算，360度与144度之比是2.5倍，那么每秒时间内电流传输的距离就是250 000英里。
Just as many times 100, 000 miles, as 144 degrees are contained in 360 degrees (the entire circle), viz., two and a half times. Hence, the current travels 250, 000 miles in a second.
本文从降低热负荷的角度对CTB内部冷屏、超导电流传输线、电流引线、阀及冷却管路、外部盒体的设计进行了详细阐述，为最终结构的确定提供了理论依据。
Designs of thermal shield, superconducting busbar, current leads, valves and cooling pipes, and outer box of CTB are detailed described from reducing heat load point of view. They provide...
电流传感器是电力设备局部放电在线监测系统中的一个重要组成部分，其局部放电信号传输特性直接影响测量结果。
Current sensor is an important element for on line PD monitor of electric power equipment and its transfer characteristic has a direct influence on PD measurement.
通过对多输出的CMOS跨导器传输特性的研究，给出了实现二阶OTA—C滤波器的电路结构和电流传递函数。
The paper gives realization second-order OTA-C filter circuit structural and current transfer function of filter by researching the transmission property of multi-output CMOS trans-condutor.
一个新的机制(REDD)根据电流传感器节点的通信能力，提出了大规模无线传感器网络中的数据传输。
According to the communication capability of current sensor nodes, a novel scheme (REDD) is proposed for data delivery in large-scale wireless sensor networks.
该互感器以罗柯夫斯基线圈作为电流传感元件，以电容分压器作为电压传感元件，以光纤作为信号传输通道，借助有源电子调制和信号处理技术实现电流、电压的测量。
A Rogowski coil and a capacitive voltage divider are used as current sensor and voltage sensor respectively in the transducer and optic fibers are used to transmit signal.
该互感器以罗柯夫斯基线圈作为电流传感元件，以电容分压器作为电压传感元件，以光纤作为信号传输通道，借助有源电子调制和信号处理技术实现电流、电压的测量。
A Rogowski coil and a capacitive voltage divider are used as current sensor and voltage sensor respectively in the transducer and optic fibers are used to transmit signal.
应用推荐