提出一种串联电池组电压测量新方法：光电继电器取代机械继电器选通各节电池电压；
The paper puts forward a new method to measure series battery voltage, mechanical relay is replaced by photoelectric relay to select each battery voltage.
在详细研究了CAN现场总线技术的基础上，本文提出了蓄电池组电压数据采集系统的设计。
On the basis of research in CAN-bus technique, this thesis proposes design of voltage data acquisition system in storage battery.
电压控制的装置出现错误可能会导致蓄电池组充电过度，这反过来可能会加速放电，比正常情况更严重。
A fault in the voltage-control mechanism may thus cause a battery to become overcharged, which, in turn, might precipitate a deeper discharge than normal.
以常见的2200mAh、3.6V电芯为例，一些小本可能采用4节串联方式组成电池组，其电压为14.4V，容量2200mAh。
To common 2200mAh, 3.6V batteries, for example, some small series may be composed using four batteries, its voltage is 14.4V, Capacity 2200mAh.
此外，给nimh蓄电池组充电是个麻烦的过程，因为随着存储电能总量的增加，必须谨慎减少电压。
Also, charging a NiMH battery is a tricky business because the voltage has to be carefully reduced as the amount of energy being stored increases.
电动机的能量来源于一组506磅的锂电池组，捷豹公司表示，在240伏电压下，一次充满电只需要6小时。
Power for the electric motors comes from a 506-pound lithium-ion battery pack, which Jaguar claims takes a full charge in just 6 hours at 240 volts.
一个典型的电池组含有的电池可能有96个之多，就充电至4.2V的锂离子电池而言，总共能产生超过400v的电压。
A typical pack might have a stack of 96 batteries, developing a total voltage in excess of 400v for Li-ion batteries charged to 4.2v.
系统简单经济，经过试验，在要求的电压和温度指标下，能可靠、准确地对串联电池组进行监测。
Tests show that the system is able to supervise and measure serial battery reliably and accurately at request voltage and temperature.
电动汽车蓄电池组由多个蓄电池串联组成，电压的测量有一定困难。
Since the batteries used in the EV are in series, it is difficult to test the voltage of every single battery.
根据测得的各节电池的电压曲线，选择性能相近的电池组成优化的串联电池组。
According to voltage curves batteries with similar performance are selected for better series battery.
阐述了阀控式密封铅蓄电池组中各单电池的浮充电压值是服从正态分布规律的。
The values of floating charge voltage for all cells in the VRLA group were as the law of normal distribution.
电压、电流显示值的校准修正功能：可对电池组总电压、单体电池电压、电流进行校准、修正。
The adjustment and correction of current and voltage function: It can adjust and correct to battery total voltage, single cell battery voltage and current.
最后还搭建了一套蓄电池数据采集调试系统，本系统基本完成了课题的目标，实现了蓄电池单体电压、蓄电池组总电压、蓄电池电流和蓄电池温度数据的监控。
Then a battery wireless data acquisition system is set up at the end of the dissertation. The system can monitor the single battery voltage, the total voltage, current and temperature of the battery.
系统中每个串联单元的直流电压可在电池组端电压的基础上进一步提高，并允许多组电池并联接入。
The DC voltage of each serial module can be boosted based on the battery output voltage and the parallel connection of battery groups is allowed.
通过这三个参数可以知道，我们购买的电池其实是一个电池组，由许多单节的电池通过并联和串联得到的电池组，通常电压越高容量越大的电池体积也越大。
From parts above we can know battery we usually buy is battery unit which can be series or parallel connected in several sets. Battery volume increases with the capacity.
串联蓄电池组的电压一般较高，为电压检测带来了困难。
An improved voltage measurement circuit for series batteries was proposed.
本论文工作的突出之处：在系统硬件设计方面采用了一种新的测量蓄电池组中单体电池电压的采样电路；
The outstanding of this study is: for system hardware design, a new voltage measuring circuit, which is used to measure the voltage of the individual battery of batteries is designed;
本论文工作的突出之处：在系统硬件设计方面采用了一种新的测量蓄电池组中单体电池电压的采样电路；
The outstanding of this study is: for system hardware design, a new voltage measuring circuit, which is used to measure the voltage of the individual battery of batteries is designed;
应用推荐