电极间距增大后，气隙的击穿电压增大。
The breakdown voltage of air gap increases with the electrode spacing increasing.
这个最小值就是，电极间距离的值，离子间距离的值。
And, this minimum here is what gives us the value of the inter-electrode separation, the inter-ion separation.
压电陶瓷电极间距离对梁的固有频率有较大的影响。
Influences of distances between electrodes on eigenfrequency of the linear beam are bigger.
实验研究干扰电场方向、强度和钢电极间距等对测量电位梯度的影响。
The effects of direction, strength of interferential electric field, as well as the arranged space between steel electrodes on measured potential gradient were investigated.
考察了脉冲电压峰值、电极间距、氧气鼓入量等因素对苯酚去除率的影响。
Effects of some factors, including peak voltage, electrode distance, oxygen bubbling etc.
着重讨论了相对光串扰与驱动电压、放电电极间距、电极宽度之间的关系。
The relation between relative light crosstalk and driving voltage, gap of discharge electrode, width of electrode, as well as the effect to restrain crosstalk with barrier ribs are also discussed.
通过控制电压、电极间距、温度等电解工艺条件，在钛合金表面沉积得到DLC膜。
DLC films can be deposited by changing technology, such as voltage, distance and temperature.
电极材质，离子膜，电极间距，氯化钠溶液浓度是影响酸性氧化电位水生成的重要因素。
It shows that electrodes material and distance, membrane, and NaCl density are four effective factors in acidic water electrolysis.
实验结果表明，在相同条件下，氢的析出电压和电压梯度受电极材料和电极间距的影响。
The results revealed that under the same conditions, hydrogen evolution potential and voltage gradient were affected by the electrode materials and the electrode spacing.
研究了脉冲能量、反应温度和电极间距等工艺因素对镍磷合金粉体尺寸、形貌及收得率的影响。
The Effect of sparking energy, reaction temperature and electrode distance on the powder size, shape and yield was investigated.
电容器的储电量取决于两个电极表面区域、电极间的绝缘性的强弱、绝缘材料以及两电极间距离。
The amount of charge that can be stored depends on the surface area of the electrodes, the strength and composition of the insulation between them, and how close they are together.
随着测量电极与点火电极间距的增加，电极附近温度依次降低，离子电流焰后区信号亦逐渐降低。
With the increase of the distance between ignition electrodes and detector electrodes, the current and temperature at the electrodes gap are decreased.
从结晶器施加电脉冲输入能量、钢液过热度、电极间距三方面，探讨电脉冲处理提高铸坯等轴晶率的效果。
The improvement of slab equiaxed crystal ratio by electric pulse on liquid steel in continuous casting mould at Pan steel slab castor No.
结果表明，放电单元采用大电极间距可获得正柱区放电，正柱区的形成是正离子在阴极鞘层区不断积累将电位抬高所致。
The results show that the long electrode gap leads to the positive column which is caused by the climbing voltage on the cathode surface due to the accumulation of positive ions.
为使输出能量稳定，则双电极对的间距有一最小值的限制。
To stabilize the output energy, the distance between two pairs of electrodes is limited by a minimum.
采用平板堆焊的方法及高速摄像系统，研究了双电极钛钙型碳钢焊条的焊芯间距对焊接工艺和电弧形态的影响。
The effect of span between two cores of lime-titania type carbon-steel electrode was investigated using the method of overlay welding on the plate work-piece and high speed camera system.
铜电极偶制备步骤，为利用黄光微影制程制作出相对间距为数微米的铜电极 偶。
The copper electrode couple preparation step prepares the copper electrode couples with a plurality of micrometers of relative spacing by a yellow-light photolithography process.
铜电极偶制备步骤，为利用黄光微影制程制作出相对间距为数微米的铜电极 偶。
The copper electrode couple preparation step prepares the copper electrode couples with a plurality of micrometers of relative spacing by a yellow-light photolithography process.
应用推荐