由于电容在充电过程中，其电压不断改变，其等效负载也在较大的范围内变化，因而对充电电路的负载特性提出了较高要求。
Because the capacitor voltage always changes in the course of charging, and the equivalent load also changes in a large range, the load characters of charging circuit are required strictly.
该文基于TCSC的开关函数模型并借助MATLAB仿真工具，提出了研究电容电压过零点特性的数字仿真方法。
Based on switch function model of TCSC and MATLAB, the digital simulation method in researching zero-crossing point characteristic of the capacitor voltage is put forward.
这些关键应用所考虑的其它因素包括：元件封装设计、工作电源范围和钽器件优异的电容-电压（CV）特性。
Otherconsiderations for these critical applications include component package design, working voltage ranges and the advantageous CV levelsof tantalum devices.
分析了直流侧电感和电容滤波的整流器的谐波特性，进而把它们分为电流和电压型谐波源。
The harmonic characteristics of a rectifier with a DC filter inductor or capacitor are analyzed and then relevantlythey are classified into current type and voltage type harmonic source.
给出反偏电压、光谱响应、暗电流、极间电容、极间阻抗、位置分辨率和位置线性特性等性能的测试结果。
Several test results, such as reverse voltage, photo sensitivity, dark current, terminal capacitance, terminal impedance, position distinguishability, position Iinearity, were reported in the paper.
本文中还探讨了结电导—电压特性以及结电导对结电容测量的影响。
We also studied the junction conductance-voltage characteristics as well as the influence of junction conductance on the junction capacitance measurements.
最终的目标是从真空断路器机械特性方面入手，降低操作并联电容器组时的重燃率、并减小操作过电压危害。
The aim is to reduce the reignition rate and over-voltage damage from the perspective of the mechanical characteristics of the vacuum breaker switching shunt capacitor Banks.
本文分别讨论了常规冲击电压发生器在大电容负载和小电感负载下的输出特性，和不同级球隙过电压的同步特性。
In this article, we discussed the output capability of the typical impulse voltage generator with a large capacitance load or a small inductance load, and the synchronization capability.
结果表明，合适的快淬速度不仅可以大幅度的提高放电容量，而且明显的改善合金的循环稳定性和放电电压特性。
The results show that proper quenching not only increase discharge capacity greatly but also can improve cycle stability and discharge voltage property.
然而，要使用电容器就必须明白其特性：包括电容值、额定电压值、温度系数以及泄漏电阻等。
However, to be useful, they must be characterized for capacitance value, voltage rating, temperature coefficient, and leakage resistance.
功率变换器主电路采用电压电流双闭环瞬时值反馈控制方式，电容电压和电流瞬时值控制环提高了系统的稳定性、硬特性、稳态特性及动态特性。
The voltage and current real-time feedback control method is adopted, which improves the stability, the stiffness, the static characteristics, and the dynamic characteristics of the system.
当电容器上所施加电压高于额定工作电压时，电容器的漏电流将上升，其电气特性将在短时内劣化直至损坏。
When capacitor is used at higher voltage than the rated voltage, leakage current increases, characteristics drastically deteriorate and damage in a short period may occur as a result.
当电容器两端的电压变化时，电容器内部能产生电流的特性称为电容。
The property to produce a current in a condenser, when the voltage across it changes is called capacitance.
MOS结构高频C-V（电容-电压）特性测量是检测MOS器件制作工艺的重要手段。
The principle of MOS capacitance measurement based on the method of high frequency detection is presented.
移相电路主要是由电容器的电流超前电压90度这一特性。
Rc phase-shift circuit current mainly by the capacitor voltage is 90 degrees ahead of this feature.
结果表明，适当的淬火，不仅增加了放电容量很大，但也可以改进的循环稳定性和放电电压特性。
The results show that proper quenching not only increased discharge capacity greatly but also can improved cycle stability and discharge voltage property.
由于有电压穿过电容，电容能维持其充电特性，从而维持其电介质层。这就是回答煲机问题的关键所在。
Because of the difference of DC voltage across it, it maintains its charge which in turn maintains its dielectric layer. And this is the key that answers the long burn-in question.
由于有电压穿过电容，电容能维持其充电特性，从而维持其电介质层。这就是回答煲机问题的关键所在。
Because of the difference of DC voltage across it, it maintains its charge which in turn maintains its dielectric layer. And this is the key that answers the long burn-in question.
应用推荐