车缝部、电压部、丝印部为一体，从而降低各种做工成本。
Sewing, voltage, printing department for work, so as to reduce the cost of all.
就象漏源极电压的例子那样，用这种方法也可以找出漏极电流的哪一部分对电磁干扰频谱产生影响。
As in case of drain-source voltage this method allows to associate the elements of the drain current waveform with its contribution to the whole spectrum.
如果输入端的交流电压很大，其一部分信号被整流，于是在被测的直流信号中产生了误差。
If the AC voltage at the input is large, part of this signal is rectified, producing an error in the DC signal being measured.
其中两个探针提供恒定的电流，而另外两个探针测量一部分样品上的电压降。
While two contacts supply a constant current, the other two contacts measure the voltage drop across a portion of the sample.
第一部分讨论各种谐波问题，如使供电电压畸变，降低功率因数，增加能量损耗，干扰通讯系统等。
The harmonic problems, such as distorting supply voltage, decreasing power factor, increasing energy loss, interfering with communication systems etc. are discussed in the part one.
本论文建立了剪式微喷的结构理论模型，分析了在动态电压作用下端部的变形；
The theoretical model of shear mode micro jet is established and the edge displacement under dynamic driving voltage is analyzed .
由于切换的是高阻抗，所以切换小电流(5.3.1部分)和高阻抗电压(5.2.3部分)时采用的技术也同样适用。
High impedances are being switched, so some of the same switching techniques used when switching low current (Section 5.3.1) and high impedance voltages (Section 5.2.3) are equally applicable here.
第二部分研究了在氩气作保护气体的情况下，用变极性TIG焊方法焊钢时，焊接电流、电压的变化情况和电弧形态的变化。
The second is, when steel is welded by means of VPTIG of argon, the changes in current, voltage and arc shape.
其中包含了缝隙之间的内（外）部互耦以及介质的影响。缝隙之间的内（外）部互耦是从缝隙的口径电压出发、将缝隙等效为磁流源、通过互易原理而获得。
The expressions of external and internal coupling were derived from the reciprocity theorem by analysing slot voltage distribution in this paper, which invoked magnetic current to slots.
第二部分是在非对称的双量子点中电压调控的慢光效应。
The second part involves voltage controlled slow light effects in asymmetry double quantum dots (QDs).
三套常用的电压和电流（VA部对）可预置，从而使快速安装电源供应器的输出。
Three sets of frequently used voltage and currents (VA pairs) can be preset, thereby enabling quick setup of the power supply output.
第三部分研究了在氦气作保护气体的情况下，用变极性TIG焊方法焊铝时，焊接电流、电弧电压的变化情况和电弧形态的变化。
The third is, when Al is welded by means of VPTIG method of helium, the changes in current, voltage and arc shape.
使端部的两个电极（11、12）的电位相等，并在中间电极 （13）与端部电极（11、12）之间施加电压。
Potentials of two electrodes (11, 12) at two ends are equaled and voltage is applied between the intermediate electrode (13) and the end electrodes (11, 12).
该机的直流牵引部采用具有电流反馈和电压反馈的双闭环调速系统。
The d. c. traction portion of which comprises current and voltage feedback to form double closed-loop speed adjustment system.
磷扩散层还充当用于提升电压的后表面场以及具有低电阻率的后接触部。
The phosphorus-diffused layer also serves as a back surface field to raise the voltage and a back contact with low resistivity.
输出部蓄积能量线感应区域内产生的电荷，输出与蓄积电荷量相当的电流信号或电压信号。
The output part stores the charge occurring in the energy line sensing area and outputs a current or voltage signal equivalent to the amount of the stored charge.
计算了换流变压器阀侧绕组在极性反转试验电压下端部电场的分布情况，并对计算结果进行了分析。
The end electrical field distribution under polarity reverse test voltage of valve winding in converter transformer is calculated. The results are analyzed.
电磁兼容性。第4- 11部分：试验和测量技术。电压磁倾角、短暂中断及电压随变抗扰性试验。
Electromagnetic compatibility (EMC) - Part 4-11: testing and measurement techniques - voltage dips, short interruptions and voltage variations immunity tests.
本文针对汽车照明系统的用电环境，分成三部分设计和分析了不同电压结构的驱动电源。
This paper aims at the surroundings of automobile light system, divided into three parts, designs and analyses drivers with different voltage structures.
第三部分逆变电路，输出所需交流电压；
The third part introduces inverter circuit, it provides two needed sine output voltage.
承包商可以选择在涂敷日用低于本规范第6部分规定的电压来进行漏涂检查，按照他们自己的操作程序。
The contractor may elect to holiday test on the day of application, using a lower voltage than specified in Section 6.0 of this specification, for his own control procedure.
写入驱动器通过全局线响应数据信号，使用正常驱动电压驱动第二局部线。
A writing driver drives the second local lines using a normal-driving voltage in response to a data signal through a global line.
本文提出用全部节点电压实部和虚部作为状态定量的最优潮流计算模型。
The paper proposes a model for optimal load flow calculation in which the real and imaginary parts of all the node voltages are used as state variables.
操作电压和气压要求请见技术数据第七部分。
Operating voltages and air pressure requirements are listed in Section 7 Technical data.
第一预解码开关阵列用以接收数字数据，当数字数据在一第二范围内时预解码部 份数字数据以及输出电压。
The first pre-decoding switch array is used for receiving the digital data, and pre-decoding the partial digital data and outputting the voltage when the digital data are within a second range.
而其它零部件，例如固态绝缘及电气强度测试则要求能够耐受更高的瞬态电压(详见iec 60664-1)。
Other parts of the insulation system, for example requirements for solid insulation and for electric strength testing, must be capable of withstanding the higher transient voltages (see IEC 60664-1).
写入驱动器在预定周期期间，使用具有电平高于正常驱动电压的过驱动电压驱动第二局部线。
The writing driver drives the second local lines using an over-driving voltage having a higher level than that of the normal-driving voltage during a predetermined period.
采用本实用新型所述合成绝缘子，能够有效改善复合绝缘子的高压侧端部电压和表面场强分布。
The synthetic insulator can effectively improve the high-pressure side end voltage and the surface field distribution of the composite insulator.
高电压试验技术第二部分：测量系统。
来自美国交通部的分析称，他们调查了更大范围的突然加速问题，他们对部分车内数据进行分析，检测电压是否发生变化。
The DOT's analysis - part of a wider SUA review - has analysed in-car recorders to see whether any voltage variations were detected.
应用推荐