如果元件或材料发生击穿，全部电压都会加到安培计的输入端，从而可能将其损坏。
If the component or material breaks down, all the voltage would be applied to the ammeter's input, possibly destroying it.
用一对二级管以反向偏执于正常方向的形式连接至电源端，来保护过高的输入电压。
Protecting against excessive input voltages using a pair of diodes to power supply reversibly biased in normal direction.
仪器内部电路和内部的偏移电压会在仪器的输入端引起输入偏置电流。
The input bias current flows at the instrument input due to internal instrument circuitry and the internal bias voltage.
如果输入端的交流电压很大，其一部分信号被整流，于是在被测的直流信号中产生了误差。
If the AC voltage at the input is large, part of this signal is rectified, producing an error in the DC signal being measured.
要确保输入端钳位电压足够的高，以避免由于源接点的非线性而产生的问题。
Make sure the compliance voltage is high enough to avoid problems due to source contact non-linearity.
只有A/C扩大器上的电压是来自输入端的正确电压时，初级输出（即A/C压缩机继电器）才会被激活开启。
It is only when the correct voltages are applied to the A/C amplifier from the key inputs that the primary output (the A/C compressor relay) will be energised.
图2 - 7说明分流电容对典型的高输入阻抗电压表输入端的影响。
Figure 2-7 demonstrates the effects of shunt capacitance loading on the input of a typical high impedance voltmeter.
再者，所用的放大器也要考虑在加到输入端的整个共模电压(范围内)输入偏置电流转换保持平滑。
Again, consider using AMPLIFIERs that exhibit a smooth input bias current transition throughout the applied input common-mode voltage.
这种电流的降低是由安培计的内阻（RM）引起的，此内阻产生了一个附加的电压降，称为输入端压降（VB）。
This reduction is caused by the internal resistance (RM), which creates an additional voltage drop called the voltage burden (VB).
这种稳定方法的一个不足是：输入端的有关电压噪声和失调电压增大会额外地增加输出噪声和失调电压。
One disadvantage of this method of stabilization is the additional output noise and offset voltage caused by increased amplification of input-referred voltage noise and input offset voltage.
这种技术在不需要增加功耗的基础上，通过把输出端的失调电压转移到差分放大器的其他节点，从而达到减小输入参考的失调电压的目的。
The technique transfers the offset voltage from the output to other parts of the differential amplifier and can greatly reduce the input-referred offset voltage without extra power consumption.
RL1上的电压为皮安计的输入端压降，通常小于1mV，所以产生的电流是相当小的。
The voltage across RL1 is the picoammeter voltage burden, normally less than one millivolt, so the resulting current will be quite small.
电压乘法器采用了三端输入方式和等温工作法式，以消除漏电影响和减小非平方律误差。
The input of this multiplier includes three terminals for eliminating the effect of leakage and the equal temperature operation mode for the converters is adopted to reduce the non-square law error.
在图3-13a所示的正确的连接方式之下，电压源的低端或者机箱端连到测量仪器的输入低端。
With the correct connection scheme shown in Figure 3-13a, the low or chassis side of the voltage source is connected to input LO of the measuring instrument.
检测器本身具有较高的分辨力，使彼此难以分辨的多个输入信号电压中的最大(小)者与其它输入电压间的差距在输出端加大变得易于分辨。
This detector has higher resolution, which makes the differences difficult to distinguish between the minimum (or maximum) input voltage and the rest enlarged and distinguished easier.
电压传感器的输入端与探针连接，电压传感器的输出端与计算机连接。
The voltage sensor has input end connected to the probe and output end connected to the computer.
本发明公开了一种以神经元电路为基本单元的电压比较器电路，它包括：一具有两个输入端和一个控制端的二选一电路，用于选择比较器的两输入信号之一；
The voltage comparator circuit using neural circuit as basic unit includes an either-or circuit with two input ends and one control end for selecting one of two input signals of comparator;
本发明公开了一种以神经元电路为基本单元的电压比较器电路，它包括：一具有两个输入端和一个控制端的二选一电路，用于选择比较器的两输入信号之一；
The voltage comparator circuit using neural circuit as basic unit includes an either-or circuit with two input ends and one control end for selecting one of two input signals of comparator;
应用推荐