介绍一种新型电压负反馈电路，并研制了成本低、体积小的装置。
This paper introduces a newtyped voltage negative feedback circuit, and develops a low-cost and a small sized system.
本文讨论可控硅电压负反馈调速系统中电压调节器的设计和计算方法。
This paper deals with the design and calculation method of the voltage regulator used in the SCR regulating speed system with voltage negative feedback control.
首要的，你不能把电压负反馈功放机改成电流负反馈，几乎没有办法那么做。
First of all, you cannot turn a voltage feedback amp into a current feedback amp. there is just no way to do that.
从并联电压负反馈的角度，对输入电阻和输出电阻给出了下列4种方法的定量讨论。
From the negative feedback aspect of the parallel voltage, this paper quantitatively discusses input and output resistances by employing 4 methods.
由控制电路实现焊接程序的控制，带电枢电压负反馈的调速电路控制和调节送丝速度。
The control to welding procedure is realized by a control circuit, and wire feed rate is regulated and controlled by speed governing circuit with the armature voltage negative feedback.
采用电压负反馈法，控制主要由供电电网产生电源电压波动而引起的储纬器电机转速波动。
By means of negative feedback, the motor's speed fluctuation of the device, caused mainly by voltage fluctuation of power supply, can be controlled.
该调速系统以电压负反馈代替转速反馈，形成闭环控制，以比例积分调节器实现无静差调速，具有良好的性能。
It can research PWM regulating speed. In the system, voltage feedback instead of speed feedback, PI regulating no steady-state error. So it has a good dynamic and steady performance.
在功率输出级采用OCL互补对称功率放大电路，并对该功放电路增加电压负反馈，使得输出的正弦电压信号平滑而稳定。
At the power output, OCL complementally and symmetrical power amplifier is adapted. The output sine voltage becomes smooth and stable by adding voltage-negative-feedback to power amplifier.
利用“虚短”和“虚断”的概念来估算深度负反馈电路的电压增益。
Using the concept of virtual short circuit and virtual open circuit, the voltage gain of depth negative feedback circuit can be estimated.
该电路的反馈组态应是电压并联负反馈。
The feedback configuration of this circuit should be voltage parallel negative feedback.
采用数字信号处理器（DSP）控制器，设计了具有电压前馈和电流截止负反馈的转速闭环弱磁调速系统。
The speed adjusting system with field weakening with voltage feedforward, current closed negative feedback and speed closed loop was designed by adopting digital signal processor (DSP).
实现了对输出电压的负反馈调节及各种保护机制。
The negative feedback regulation of output voltage and various protective mechanisms are realized.
本文对模拟电子技术课程中有关“反馈”的判别方法，诸如正、负反馈，电压、电流反馈以及串联、并联反馈等做了详细的分析比较。
The determinant method of feedback, such as positive feedback and negative feedback, voltage feedback and current feedback, series feedback and parallel feedback, etc.
该带隙电压基准源电路中的深度负反馈运算放大器为低失调、高增益的折叠型共源共栅运算放大器。
A deep negative feedback operation amplifier used in band gap reference is a common source and gate folded cascade operation amplifier with a lower offset voltage and a higher gain.
该方法将实际输出电压和期望输出电压的比较偏差作为负反馈加到下一个采样周期的开关调制函数矩阵中。
The discrepancy between the actual output voltage and expected output voltage of the matrix converter is calculated and added to the switch modulation matrix in the next sampling period as feedback.
提出了一种新颖的利用负反馈环路以及RC滤波器提高电源抑制比的高精密CMOS带隙基准电压源。
In this paper, a novel high precision CMOS bandgap voltage reference which USES a negative back circuit and a rc filter to enhance the PSRR is proposed.
电压、电流真有效值变换精度高、速度快，电压真有效值负反馈闭环控制主回路网压波动补偿精度高；
The RMS converters of voltage and current have the advantages of high speed and precision, and with the feedback of RMS, the fluctuate of power voltage can be compensated at high precision.
由自感知电压引入速度负反馈闭环控制，并由假设模态法将位移按模态展开，求解了悬臂梁结构的动态特性；
The mathematical models based on the assumed modes method and a closed loop velocity feed back control law are developed to describe the flexural vibration dynamic behaviors.
它采用了电压闭环负反馈以及有效的PID调节环节和相应的超前校正环节，能保证很小的失真率和快速的动态响应能力。
The control circuit used very efficient PID modulation and anticipatory control so the power amplifier had little distortion and fast dynamic response.
该电路采用耗尽型NMOS管作电流源器件，结合负反馈，实现了稳定的电压基准。
A depleted NMOS transistor, which was used as current source, and a negative feedback loop constitute a stable voltage reference.
该电路的反馈组态应是电压并联负反馈。
The feedback configuration of this circuit should be voltage parallel negative feedba…
该电路的反馈组态应是电压并联负反馈。
The feedback configuration of this circuit should be voltage parallel negative feedba…
应用推荐