泄漏电流是由测量电路和附近的电压源之间的寄生电阻通路产生的。
Leakage currents are generated by stray resistance paths between the measurement circuit and nearby voltage sources.
即使小电流导体和附件电压源之间的高阻通路也会产生明显的漏流。
Even high resistance paths between low current conductors and nearby voltage sources can generate significant leakage currents.
切换和测量具有高内阻的电压源会受各种误差的影响，包括偏移电流、寄生漏泄通路，以及静电干扰。
Switching and measuring voltage sources with high internal impedance are subject to a number of errors, including offset currents, stray leakage paths, and electrostatic interference.
在测量仪器上附加电流和电压源功能，为各种低电平测量应用提供了额外的灵活性。
Adding current and voltage sourcing capabilities to a measuring instrument provides an extra degree of versatility for many low level measurement applications.
有了这种屏蔽，由静电电压源和耦合电容产生的噪声电流就经过屏蔽流到地，而不再流过信号线。
With this shield in place, the noise current generated by the electrostatic voltage source and the coupling capacitance flows through the shield to ground rather than through the signal conductors.
对于这种应用，单台仪器提供了电压源和小电流测量功能。
For this application, a single instrument provides both the voltage sourcing and the low current measurement functions.
拥有更低峰值电流和场效应晶体管漏源极开通电压的800伏特准谐振设计展示出一次侧传导电磁干扰降低的优势。
The 800v quasi resonant design with lower current peak and lower drain-source voltage during turning on of the MOSFET demonstrates advantages in conducted EMI spectra regarding the primary side.
如果使用分离的电流源和电压表来进行低电阻测量，则必须检查每台仪器的非欧姆接触情况。
If using a separate current source and voltmeter to make low resistance measurements, each instrument must be checked for non-ohmic contacts.
在很多方面数字源表仪器与源-测量单元是类似的，包括电流和电压源，电流和电压测量以及扫描等性能。
The SourceMeter instrument is very similar to the source-measure unit in many ways, including its ability to source and measure both current and voltage and to perform sweeps.
注意，这种测量方法是两线电阻测量，而使用静电计电压表和外部电流源则可以进行四线测量。
Notice that this is a two-wire resistance measurement compared to using the electrometer voltmeter and external current source, which can make a four-wire measurement.
该系统包括用来提供流过样品的电流的6220型电流源和用来测量产生的电压降的2182A型纳伏表。
The system includes a Model 6220 Current Source to supply the current through the sample and a Model 2182A Nanovoltmeter to measure the resulting voltage drop.
采用恒流法，可以使用静电计电压表和电流源或者只使用静电计欧姆计来测量高电阻。
High resistance measurements using the constant-current method may be made using either an electrometer voltmeter and current source or just an electrometer ohmmeter.
图2 - 39所示为静电计和由电压源及电阻器串联组成的电流源相连接。
Figure 2-39 shows an electrometer connected to a current source that consists of a voltage source in series with a resistor.
在很多测试应用中，二极管的电压和发出的光可以利用大小固定的电流源同时测出来。
In many test applications, the voltage and light output of the diode can be measured simultaneously using a fixed source current value.
对两种预电离源的放电电压和电流进行测量，得到瞬态信息。
The transient discharge voltage and current of the two pre ionization sources were measured also.
从辩证逻辑、形式逻辑、电流源模型和电压源模型等方面，阐明半导体限流猜想是不正确的。
From the points of view of dialectical logic, formal logic current and voltage source models, this paper addresses that the current limiting conjecture is not correct.
所有真实的电压源和电流源都具有内阻，所以它们都表现出约翰逊噪声。
All real voltage and current sources contain an internal resistance; therefore, they exhibit Johnson noise.
补数键控的新版本为你的工具箱增加电容器、感应器和交流电压源！现在你可以画出和时间形成函数关系的电流和电压。
This new version of the CCK adds capacitors, inductors and ac voltage sources to your toolbox! Now you can graph the current and voltage as a function of time.
该模型由一个电压控制电流源、一个电压控制电压源和一个电压源构成。
It consists of a voltage-controlled current source, a voltage-controlled voltage source and a voltage source.
基于补偿原理，利用变压器的受控电压源和受控电流源模型，分析了该系统的稳压原理。
Based on compensation concept, the principle of this system is analyzed by utilizing the controlled voltage source and controlled current source model of a transformer.
由于采用了一种新型的低损耗无源缓冲电路，开关管和主二极管的电流电压应力较小，并降低了能量损耗，提高了工作效率。
Since the novel low-loss passive snubber circuit is used, the low current and voltage stress, low energy loss and high efficiency properties are achieved.
文章主要介绍程控正弦功率电压源和电流源校表仪的原理。
This paper describes the principle of sin voltage source and current source that can be programme controlled.
与负载匹配状况的合理选择是电压源和电流源经常遇到的问题。
The reasonable choice of matching state of voltage source or current source is a common problem in measurement.
基准源模块广泛的应用于模拟和混合电路中，如A/D、D/A转换器，电压调谐器，电压表，电流表等测试仪器以及偏置电路。
Reference sources are widely used in analog and mix-mode circuits, such as A/D, D/A converters, voltage regulators, measurements, instrumentation circuits, and bias circuits.
应用电路理论的基本定律分析理想电压源的并联和理想电流源的串联。
With the basic laws of circuit theories, it analyzes ideal voltage source's parallel connection and ideal current source's series connection.
设计了基准电压源和电压微调电路，为adc提供参考电压和电流，而且能进行一定范围内的微调。
Design a bandgap voltage reference circuit and a voltage-modifying circuit to provide precise voltage and current reference for the referred ADC.
二是正弦波网络：主要包括正弦量化的电流源整列和开关网络，电流电压转换器，二阶低通滤波器；
The second part is to design the sine wave networks circuits which is composed of sinusoidal current source array and switches, current to voltage converter (I-V converter), two staged LPF, etc.
基准源作为其中关键模块之一，不仅需要为系统提供精准的偏置电压和偏置电流，差分基准源还将为其提供比较电平和残差电压，它的性能将直接影响到系统指标。
Reference is the key part of ADC, not only providing the bias voltage and current for the system but also playing the part of the compared voltage and subtracted voltage.
一个理想的电流源将提供没有力气短路和方法无限的能源和负载电阻接近无穷大电压(开路)。
An ideal current source would provide no energy to a short circuit and approach infinite energy and voltage as the load resistance approaches infinity (an open circuit).
本文分析了电流传送器的基本镜像电流源和电压跟随器模块电路。
The paper analyzes the fundamental part circuit of current conveyor, the current mirror and the voltage follower.
应用推荐