LCD自动显示电压低和充电状态。
当电压低于阈值时，未发现记录点。
电池温度感知器输入电压低于可接受范围。
Battery temperature sensor input voltage below an acceptable range.
开路电压低的主要原因是电解质致密性不够。
Low open-circuit voltage was attributed to poor density of electrolyte.
这种装置具有半波电压低，电反馈功率小等特点。
This device base such advantages that the half-wave voltage is lower and the electric feedback power is smaller.
由于输出电压低，所以使用时几乎不会产生电气杂讯。
Veru low feneration of electrical noise due to low-voltage output.
它具有工作气压高，维持电压低，阴极溅射率高等特点。
It has the characteristic of working on higher pressure and lower voltage and having a high cathode sputtering rate.
且工作电压低、功耗小，是CRT显示器的理想替代品。
As for it also has low working voltage and small power dissipation, it has became the ideal succedaneum of CRT.
电池电压低于5V时，电压量程按钮开关应打在5V档上。
When battery voltage is less than 5V, voltage range switch should be set to 5V.
新型液晶的特点是工作温度范围广，工作电压低和可靠性高。
The new liquid crystal feature wide working temperature ranges, low voltage operation and high reliability.
对于电压低于这一水平，必须降低其容量约为250伏电流。
For voltages below that level, its capacity must be derated at approximately 250 ma per volt.
当工作电压低于或高出标准时就有可能造成显示方面的故障。
When the operating voltage lower or higher than the standard display is likely to result in failure.
新型液晶的特点是工作温度范围宽，工作电压低和可靠性高。
The new liquid crystals feature wide working temperature range, low operation voltage and high reliability.
新型液晶的特点是：工作温度范围宽，工作电压低，可靠性高。
The new liquid crystals feature wide working temperature range, low voltage operation and high reliability.
第一副像素的阈值信号电压比第二副像素的阈值信号电压低。
The first sub pixel has a threshold value signal voltage lower than that of the second sub pixel.
其中采用的电动进样控制系统，具有控制电压低，控制灵活等特点。
There are characteristics, such as low control voltage, facility and so on, by using electrokinetic injection system.
高海拔地区电除尘器运行电流大、电场电压低，除尘效率往往不高。
In high elevation zones, the operational current of ESP is larger, the field voltage is lower and its collection efficiency is unsatisfactory.
在额定控制电源电压低于35%时，欠电压脱扣器应防止断路器合闸。
At rated control supply voltage less than 35% under-voltage should prevent breaker from closing.
在额定控制电源电压低于35%时，欠电压脱扣器应防止断路器合闸。
In case of the operation voltage less than 35% of the rated voltage, the under-voltage should prevent the breaker from closing.
加热器的供电电压低。可能连接到加热器的电缆直径过小或长度过长。
Low voltage supplied to the heater, indicating that cable diameter is too small or run is too long.
本发明的可控硅触发电压低，能在相应范围内自由调整且具有高热击穿电流。
The present invention has low trigger voltage of SCR, can adjust freely in corresponding range and has hyperpyrexia breakdown current.
电池在1c的电流下放电，当电池电压低于指定保护电压时，放电就会停止。
The battery should be discharged with 1c, the discharging should be shut off when the internal cell voltage becomes less than the specified protection voltage.
与同类光开关相比，这种开关具有开关时间短、衍射效率高和工作电压低的优点。
Compared with other similar optical switches, it has the advantages of short switching time, high diffraction efficiency and low operating voltage.
起始电压低于0.4 V，是一种输出电流范围又宽、稳定性又高的高性能器件。
It is a kind of excellent device with both high stability and wide current range.
用于电焊机二次侧接线及连接电焊钳、电焊机的专用电缆，其特性是电阻大、电压低。
For the electric welding machine two secondary side wiring and electrode holder, welding connection cable, its characteristic is high, low voltage resistance.
该电路具有电源电压低、频带宽、电流传输精度高、及成本低廉且实用性好的特点。
The circuit has some advantages, such as low supply voltage, wide-band, the high accuracy of voltage and current transfer, low-cost, and good practical Properties so on.
与以往十值电路的设计方法相比较，此设计方案具有编码效率高、供电电压低等特点。
Compared with the conventional design of ten-valued circuits, the design has the characteristics of high coding efficiency, low voltage supply, etc.
该方法具有放电电压低，陶瓷层结构致密与基体冶金结合，适用于多种金属材料等优点。
The method has some excellent characters, such as low voltage, fine and close texture, metallurgical bond with the substrate, suitable to various metal materials.
欠电保护功能：当检测到电池电压低于设定值时，提示性自动阀，运行的数据自动保存；
Owe protection function:when the battery voltage detected than setting , indicative of automatic valve, operation data automatically preserve.
在这种情况，注意到IC1的发光二极管没有打开是重要的，因为它两端电压低于阈值。
In this situation, it is important to notice that the LED of IC1 does not turn on because the voltage applied across it is below its threshold.
应用推荐