依据熔盐电化学模型讨论了熔灰腐蚀机理。
The corrosion mechanisms of melted ash are discussed on the basis of electro-chemical model of melted salts.
详细分析了质子交换膜燃料电池(pemfc)的电化学模型。
The electrochemical modeling of PEMFC is analyzed particularly.
结合质子交换膜燃料电池(PEMFC)发动机的工作原理，建立电化学模型。
With working principles of PEMFC engines, an electrochemistry model of PEMFC was established.
在腐蚀速率电化学模型和剩余强度评价的基础上，采用一定的预测步骤确定了不同腐蚀类型缺陷的剩余寿命。
The residual lives of corrosion defects of different types were got basing on the electrochemical models of the corrosion rates and residual strength evaluation.
根据热腐蚀的特点，吸收盐熔模型的合理成分，并考虑到热腐蚀与高温气体腐蚀的共性，提出热腐蚀的电化学模型。
The rational aspects of the fluxing model as well as the general characteristics existing in high temperature gaseous corrosion and hot corrosion are considered in the electrochemical model.
这本书不同于其它人因为主要内容被在用来确定有害和有利的电化学的事件的模型化和断定方法周遭组织。
This book differs from others in that the subject matter is organized around the modeling and predicating approaches that are used to determine detrimental and beneficial electrochemical events.
在单孔电极模型基础上定义了电化学反应的有效三相分界线长度概念，并给出了对应的计算方法；
Based on the mathematical model of the single pore electrode, the effective three-phase boundary length of the electrochemical reaction is defined and calculated.
研究了埋地管道体系的等效电路模型，为将电化学理论应用于管道涂层缺陷检测打下了坚实基础。
Equivalent circuit model corresponding to buried pipeline system is analyzed, which laid firm foundations of electrochemistry theory application to the detection of pipeline coating faults.
为提高扫描电化学显微镜（SECM）微定位系统的运动定位精度，对其压电工作台的数学模型和控制器设计进行了研究。
In order to improve the dynamic positioning precision of scanning electrochemistry microscope(SECM), the mathematic modeling and controller design of the piezo-stage are studied.
模型同时考虑了电化学动力学、水动力学和多组分传递。
The model accounts simultaneously for electrochemical kinetics, hydrodynamics, and multicomponent transport.
所建模型适合于所有液体电化学电池。
基于电化学理论和电解质溶液中的吸附理论，建立了包含电解液浓度、氧化电压和温度在内的实验参数动力学模型。
Based on the electrochemical theory and the theory of adsorption in electrolyte solution, a dynamic model is established, which contains the electrolyte concentration, applied voltage and temperature.
SGE对牙钙的溶出量的测定，采用电化学人工龋模型在离体条件下进行。
The effect of SGE on dissoluble Ca 2+ from teeth was determined in electrochemical artificial caries model in vitro.
推导了恶劣环境油井管电化学腐蚀的热力学模型，编写了具有自主知识产权的油井管腐蚀预测软件。
The thermodynamic model of galvanic corrosion of well tubulars under bad setting is deduced. Well tubular corrosion prediction software which has autonomous intellectual property is been programmed.
对渣相中氧离子迁移的电化学进行了研究，提出具有电化学特征的渣相氧离子流动力学模型此模型能较为全面地解释各种反应现象。
The electrochemistry of oxygen ion transport in slag has been studied and a kinetic model with electrochemical characteristic representing oxygen ion immigration has been worked out.
在电化学控制浮选研究中，需要建立包括电化学测量值在内的各种重要参数的数学模型。
In research on electrochemistry control flotation, it's necessary to develop the mathematical model for important parameters including electrochemistry measurement values.
模型综合考虑了电池内的流体流动、传热、多组分传递、电化学反应及电压-电流关系等。
The mathematical model simultaneously accounts for the fluid flow, heat transfer, multicomponent transport, electrochemical kinetics and voltage-current relations.
对自行设计制造的两类不同结构的板框式电化学反应器，通过流体停留时间分布测定，求得流动模型参数。
The flow model parameters were obtained from determining the fluid resident time distributions in two kinds of the different structural plate and frame electrolyzers that were self-designed and made.
作为电化学测试的初步应用，建立了基于电化学测试方法的电池分析模型系统。
Finally, an analytic PEMFC model based on electrochemical methods was constructed as a simple example for the application of electrochemical techniques.
针对甲醇电化学氧化过程中观察到的电化学振荡现象，建立了非线性动力学模型并对模型进行了线性稳定性分析和数值模拟。
We establish nonlinear dynamics model, make a linear stability analysis and numerical value simulation for the electrochemical oscillation phenomena observed in experiment.
应用电化学方法，对动脉模型T形分叉部位流场壁面剪应力进行测试研究。
In this paper, we attempt to study the wall shear stress in the flow field of a t bifurcation section of an artery model by using an electrochemical measuring technique.
给出了脉冲电化学加工极间平衡间隙的数学模型，并据此讨论了高频群脉冲电化学加工中，电源主脉冲频率与平衡加工间隙的关系。
Based on the model, the relationship between the main pulse frequency of supply power and the balanceable inter-electrode gap is discussed.
焦点将在描述电化学的系统的热力学和动力学的模型化和工程接近计画。
The focus will be on modeling and engineering approximation schemes that describe the thermodynamics and kinetics of electrochemical systems.
通过研究熔融碳酸盐燃料电池的传热传质和电化学反应机理，根据质能守恒原理建立了电堆的稳态温度模型。
Through studying the heat-mass transfer and multi-spices electric-chemical reaction, a steady temperature model was developed for molten-carbonate fuel cell stack.
通过研究熔融碳酸盐燃料电池的传热传质和电化学反应机理，根据质能守恒原理建立了电堆的稳态温度模型。
Through studying the heat-mass transfer and multi-spices electric-chemical reaction, a steady temperature model was developed for molten-carbonate fuel cell stack.
应用推荐