辉石之矿物标型特征与地质体的生成温度、压力呈相关性。
The mineral physics standard characteristics of different pyroxenes related to forming temperature and pressure of the geological bodies.
实验结果表明：水合物的生成温度与诱导时间无关，诱导时间不会改变水合物的生成条件；
The experimental results show that the formation conditions of the hydrate are independent on induction time.
自那以后，好几支试验队伍一直在想方设法生成温度较低的反氢原子，并使用巧妙配置的电场和磁场留住它。
Since then several teams have been trying to make colder antihydrogen and to hold on to it using clever configurations of electrical and magnetic fields.
其中的一些将很可能就是通常所说的可居住地带，那里的温度正好适合于液态水的生成。
Some of them will likely be in the so-called habitable zone, where the temperatures are just right for liquid water.
这些致癌物质与加热的温度和烹调的时间有着密切关系，温度越高，生成的致癌物就越多。
And between the temperature and the amount of time that it takes to cook, these carcinogens form. The higher the temperature, the more they form.
研究员说，在仅有覆盖几英里的区域内，急剧变化的风和温度就可以在几分钟之内生成龙卷风。
Researchers say that rapidly changing contrasts in wind and temperatures in an area just a few miles across can spawn a tornado in a matter of minutes.
我一直制造更多生成物，直到我想降低我的温度。
And I'm just going to make more products until I try to lower my temperature.
有时，较低的口模温度会在口模内表面上生成一个冷却的树脂层，这个树脂层慢慢地移出到口模出口，然后与本体料流分离，从而引起积料。
Sometimes lower die temperatures can create a cool layer of resin on the inner surface of the die that creeps slowly to the die exit and then separates from the bulk flow, causing buildup.
如果有更多高云生成，则大气将吸收更多能量，地球温度也将攀升。
If more high clouds were to form, more heat energy radiating from the surface and lower atmosphere toward space would be trapped in the atmosphere, and Earth's average surface temperature would climb.
结果表明：时间和温度是影响齐聚物生成的主要因素。
The results showed that time and temperature was the crucial factors affecting the oligomer formation.
过高温度导致生成半水物。
Excessively high temperature causes formation of hemihydrate.
外界环境中相对湿度的变化比温度变化对裂纹生成有更大作用。
Relative humidity changes have much greater effect on rice fissuring than that of temperature of environment.
唯一相关的因素，因此，对（NOx）的氮氧化物排放量在上述所有生成的燃烧温度特别高。
The only relevant factor, therefore, is the emission of nitric oxides (NOX) generated above all at particularly high combustion temperatures.
所以我们实际上并不需要输入，一定的热量，改变生成物，和量热计的温度之类。
So we don't really need to put in a certain amount of heat and change the temperature of the products and the calorimeter and so on.
烃源岩的成熟度反映了周围的压力和温度以及有利于生成油气的条件的持续时间。
The maturity of a source rock reflects the ambient pressure and temperature as well as the duration of conditions favorable for hydrocarbon generation.
生成作用取决于三个主要因素：有机质的存在丰富到足够产生烃类；适宜温度与足够的时间使源岩达到成熟。
Generation depends on three main factors: the presence of organic matter rich enough to yield hydrocarbons, adequate temperature, and sufficient time to bring the source rock to maturity.
在模拟大体积补偿收缩混凝土内部温度变化条件下，研究了钙矾石的分解与二次生成。
The decomposition and delayed formation of ettringite were studied under the temperature match curing (TMC)condition in shrinkage compensating massive concrete.
极低、高范围内的温度影响小穗生成、熟和最终籽粒产量。
Temperature within extremely low and high levels, affected spikelet formation, ripening, and final grain yield.
改变反应温度，研究了配合物的液相生成反应的热力学性质。
The thermokinetics of formation reaction was studied at different temperature by liquid-phase reaction.
可用于考察压力、温度、液体流量和流体组成对水合物生成规律的影响，并研究水合物浆液的流体动力学性质。
It was designed to study the kinetics of hydrate formation and flow characteristics of hydrate slurries under pressure Max.
可用于考察压力、温度、液体流量和流体组成对水合物生成规律的影响，及水合物浆液流体力学性质的研究。
It was designed to study the kinetics of hydrate formation and flow characteristics of hydrate slurries under pressure.
冷媒流量越大，冷媒温度越低，水合物越容易生成，蓄冷量也越大；
The cool storage capacity increases and the formation is easier with the increasing flow or decreasing medium temperature.
显微组织分析表明，含钛钢中生成了钛化物相，并且随着退火温度的提高，钛化物析出量增多。
Analysis on the microstructure shows that precipitation of compound containing titanium was found in the steel, and its amount increases with the elevation of annealing temperature.
本文用有限差分法对金属钛表面脉冲激光生成氮化钛薄膜过程的温度场进行了三维数值模拟计算。
In this paper, numerical simulation for TiN films generated on titanium surface using laser gas alloying (LGA) method is performed by finite difference method.
海洋天然气水合物的生成除了受温度和压力的影响外，还要受到孔隙水的化学组成、流体中气体的浓度及沉积物类型的影响。
Besides temperature and pressure, the controlling factors for gas hydrate stability also include pore water composition, gas concentration in the fluid and Marine sediment types in the seafloor.
TG曲线表明了生成这些化合物的温度范围。
The TG shows the temperature range of the new compound creation.
本系统主要实现四个功能：图像温度检测功能、动态数据库实时存储功能、参数曲线图生成功能和喷煤量的实时控制功能。
This system mostly realizes four functions: the inspecting temperature based on image, the storage on real time of dynamic data-base, creating parameter's graph and controlling the quantity of coal.
对混合渣油及其经固定床加氢处理后生成油的镍分布进行了研究，考察反应温度和加氢处理催化剂对油样中镍分布的影响。
The nickel distribution of residue feedstock and products obtained from fixed bed reactor were studied and focused on the effect of reaction temperature and various hydrotreating catalysts.
从氮氧化物的生成机理入手，通过分析生成方程序和条件，得到影响热力型氮氧化物的因素主要为温度和含氧量。
Begins with the formation mechanism of nitrogen oxides, by analyzing the equation and conditions, the main affects of nitrogen oxides 'formation is put forward, i. e. temperature and oxygen content.
如果这是一个大陆生成器，纬度可能是影响温度的主要贡献者。
If this were a continent generator, latitude might be a contributor to temperature.
应用推荐