目的是探讨角膜老年环与血脂及动脉硬化的关系。
The objective was to assess the relationship between cornea arcus senilis and blood fat & arteriosclerosis.
装配后调整钢环与铜垫间的工作间隙。
After the assembly, work break between adjusting steel ring and copper pad's.
目的探讨角膜老年环与血脂及动脉硬化的关系。
Objective To assess the relationship between cornea arcus senilis and blood fat & arteriosclerosis.
多氮杂大环与许多金属离子能形成稳定的络合物。
Polyazamacrocycles are known to form stable metal chelate complexes.
本文介绍一种简易的活塞环与气缸套磨损试验方法。
A simple testing method of wear resistance for piston ring and cylinder sleeve is introduced.
约82 %的分枝点a位于环区或环与茎的连接部位。
About 82% of the branch point "a" s are situated in loops or.
分别安装在环与齿轮的设计为不需要任何设置或调整。
The separately mounted ring and gear are designed to function without any setup or adjustments.
通过调整压环与锚头之间的距离来确定锚杆的锚固长度。
The anchorage length of bolt can be controlled by adjusting the distance of anchor-boot and pressing ring.
绕线时，绕线环与铁芯相对运动，将二次线直接绕在铁芯上。
At winding, the winding ring and iron core move relatively to directly wind the secondary wire onto the iron core.
第二点是，人们必须将一些控制环与顺序逻辑控制更紧密地集成。
The second is where you have to integrate the loop closely with the sequential logic.
该方法考虑了闭气环与衬套之间的摩擦力，比常规方法更接近实际；
Taking into account the friction force between obturator ring and liner, this approach is closer to the real condition than the conventional one.
邮编悬挂盖双打作为一个防雨罩和收纳在钩环与排水孔封闭口袋内。
Zip suspension cover doubles as a rain cover and stows in a hook-and-loop closed pocket with drain holes.
特氟龙材料的活塞环与活塞熔接成一体不仅减磨效果好，同时能减少噪音防止内泄。
Teflon Piston-ring integrated with piston, not only reduce the friction and noise, but also avoid inner-leakage.
主要讨论对左（右）理想满足半极大条件的环与对零因子满足极大条件的环的性质。
In this pater , the proterties of the rings that satisfs the semi-maximum condition for left (right) ideal and maximum condition for zero-factor are discussed.
压电磨削测力平台结构优化设计的核心是弹性环与传感器三向刚度相互匹配的问题。
The mutual matching of rigidity from three directions between elastic ring and sensor is the core of problem of structural optimization design of piezoelectric milling force-measuring platform.
为了方便理解与掌握，首先先介绍系环与圆环逃脱的过程，然后在说明完整的流程。
To make this easier to follow, first I'll explain knotting the ring on the rope and removing it from the knot, then explain the complete routine.
结果表明：由于粘性的存在，使得涡环与自由表面的相互作用与无粘情形相比有许多不同。
The results show that the interaction between a viscous vortex ring and a free surface is different from the inviscid one.
本文介绍的电流环与RS- 232接口的方法大大提高了串行通信的距离和抗干扰能力。
The method of current transmitter interfacing with RS-232 in this article enormously advances the ability of serial communication and anti-disturbance.
从数学上证明关系环与系统复杂性关系模型，它表明，系统复杂性是由关系环引起和支配的。
It mathematically deduces the model of the relationship between relationship cycle and system complexity which shows that system complexity is caused and dominated by relationship cycle.
本文采用有限元数值方法和理论解析方法，对护环与转子本体配合面上的压力分布做了分析计算。
The pressure distribution on the surface of interference fit of retaining ring and rotor body is calculated by both finite element method and analytical method.
机械密封主要的是靠装在轴上的动环与固定在泵壳上的静环之间端面作相对运动而达到密封的目的。
The main mechanical seal is installed in the shaft on the dynamic in Central and fixed pump shell on the static ring for the relative motion between the end to achieve the objective of sealing.
机械密封主要的是靠装在轴上的动环与固定在泵壳上的静环之间端面作相对运动而达到密封的目的。
Mechanical seals are on the main shaft is installed in the dynamic ring in the pump shell and fixed up the static ring for relative movement between the face and achieve the purpose of sealing.
与中性态相比，带电态下其分子结构表现在C - C键的键长及环与环间的扭转角发生显著的改变。
Comaring with the neutral states, the bond lengths and the inter ring twist angles of the charged states are changed obviously.
实际控制效果进一步表明，双环与力矩补偿相结合的复合控制策略可有效减小系统多余力矩，控制稳态误差。
The actual control further shows that the control strategies combining double loops torque compensation allow an effective reduction in surplus of the system and better control of steady-state error.
工业的分散成为趋势。 目前，上海的工业企业主要集中在工业园区，形成了三环与“1+3+9”的格局。
In Shanghai metropolitan area, industry shows a dispersetrend, and shapes three rings and "1+3+9" pattern.
工业的分散成为趋势。 目前，上海的工业企业主要集中在工业园区，形成了三环与“1+3+9”的格局。
In Shanghai metropolitan area, industry shows a dispersetrend, and shapes three rings and "1+3+9" pattern.
应用推荐