批料组合物中 K_2O的量对熔体中腐殖土的偏析有影响。
The amount of K_2O in the batch composition has an effect on the segregation of humite in the melt.
梵山富含磷的岩浆经历了解体，因此产生了三种不混溶的液体：高岭土岩浆，叠合岩浆和磷酸盐熔体。
The Fanshan phosphorus-rich magma experienced unmixing and hence produced three sorts of immiscible liquids:pyroxenitic magma, syenitic magma and phosphate melt.
这种突然加速在熔体中引起应力。
反应共混物熔体呈假塑性流体特征。
The melt of blends exhibits the characteristics of pseudoplastic fluid.
熔体和气体前沿的速度和位移均急速上升。
The velocity and displacement of gas front and melt front increase dramatically.
对微碳铬铁熔体真空脱碳处理有一定参考意义。
This may be the reference for the processing of decarbonization of low-carbon ferrochromium melt in vacuum.
你也许需要降低最后一节机筒的温度来冷却熔体。
You may also have to lower the last barrel zone to cool the melt.
在样品进入下一个熔体前必须把熔体从样品上擦掉。
The melt must be wiped off the sample before it enters the next melt .
在样品进入下一个熔体前必须把熔体从样品上擦掉。
The melt must be wiped off the sample before it enters the next melt.
分析了高频磁场作用下铝熔体连续处理时夹杂的去除效率。
The inclusion removal efficiency for the continuous processing of aluminium melt with the high frequency magnetic field is analyzed in the thesis.
或者把两个词在一起门前人群发出了你的身体，形成完整的熔体。
Or perhaps putting two words together in front of a crowd sends your body into complete melt down .
采用改进的座滴法分别测定了铝熔体与石墨、镀铜石墨的接触角。
The sessile drop technique is used to measure the contact Angle between molten aluminum and graphite or copper coated graphite.
新的研究表明：北极海冰的熔化速度超过了预期而这应归咎于熔体池。
New research has revealed that melt-water pooling on the Arctic sea ice is causing it to melt at a faster rate than computer models had previously predicted.
证明随着熔体洁净度增大，单位体积中的晶粒数将先增加，然后减少。
The results showed that with the increase of cleanness of the melt, the number of grain per unit volume increased at first, and then decreased.
解决方法要么是减少口模出口应力，要么是减少组分从熔体中分离的倾向。
Solutions are either to reduce die-exit stress or to reduce the tendency for components to separate from the melt.
她还补充到“在考虑了熔体池的影响后电脑模型也能够展现出冰川加速熔化的原因了。”
"The inclusion of the melt ponds in the models goes towards explaining why the sea ice in the Arctic melts faster than the models can predict," she says.
然而，此聚合物的假塑性不如低密度聚乙烯好，因此在加工时的熔体粘度较高。
However, the polymers are less pseudoplastic than LDPE, so melt viscosities are higher during processing.
丙纶是聚丙烯纤维的商品名称，它是由丙烯作原料经聚合、熔体纺丝制得的纤维。
Polypropylene is the trade name of polypropylene fiber, which is by the polymerization of propylene as raw material by the melt spinning of fibers obtained.
温度降低时，熔体黏度大，机头压力增加，挤出制品压的较密实，形状稳定性好。
The head pressure increases when the melt viscosity and temperature decreases, so the products will have good shape and favorable stability.
研究了聚酯熔体在螺杆输送、管道输送过程中及静态高温状态下齐聚物含量的变化。
The change of oligomer content was analyzed at static high-pressure state during polyester melt transfer course in screw extruder and pipes.
检查物料的树脂是否过度潮湿或者树脂降解，检查是否存在熔体破裂或者排气不良。
Check for excessive moisture in the resin and for resin degradation, possible melt fracture, or inadequate venting.
使用有限元软件ANSYS，把熔体流动计算结果作为参数，计算了枝晶的受力状态。
Based on FEM software ANSYS, the dendrites stress states are computed using the results of the melt flow as computing parameters.
玄武岩熔体的粘度-温度关系和析晶性能是研究玄武岩纤维制备过程最重要的物性参数。
The viscosity and crystallizability of basalt melt are the most significant parameters in studying basalt fiber.
显而易见，只讨论熔体输送而不讨论物料熔融，对全面研究双螺杆挤出理论是很不够的。
It is obviously that only taking account of melt handling without considering material melting is not suitable to study twin screw extrusion theory thoroughly.
在纺丝过程中，要严格控制煤沥青熔体的粘度、纺丝温度、压力、卷绕速度等主要参数。
The main parameters of viscosity, spinning temperature, pressure and winding velocity for coal tar pitch fluid should be rigidly controlled during spinning.
在纺丝过程中，要严格控制煤沥青熔体的粘度、纺丝温度、压力、卷绕速度等主要参数。
The main parameters of viscosity, spinning temperature, pressure and winding velocity for coal tar pitch fluid should be rigidly controlled during spinning.
应用推荐