介绍了一台锻锤用煤气加热炉的设计、施工及使用情况。
Design, construction and using of a gas heating furnace for hammer forging have been introduced.
叙述了锻造用室状煤气加热炉的设计特点及其实际应用。
The designing characters and the application of the gas heating room-form furnace with automatic control used for forging process were proposed.
为了节能降耗，萍乡钢铁棒材有限公司使用高效蓄热式高炉煤气加热炉。
In order to save energy, the high efficacy stored heat furnace used blast furnace gas is applied in Pingxiang Iron and Steel Co.
介绍X -R控制图的基本控制原理，并运用该原理对煤气加热炉的温度进行控制。
To introduce the control principle of X-R control chart, and use the principle to control the temperature of coal gas heating furnace.
介绍了采用炼铁副产品高炉煤气为加热炉燃料的应用情况，总结了经验和教训。
This paper introduces that the blast furnace gas is used heating furnace, and summarizes serval experience.
介绍了加热炉在使用转炉煤气作为燃料时，对其流量、压力、加热温度和纯洁度的要求。
The requirement to flow, pressure, heating temperature and purity of converter gas used in reheating furnace were introduced.
实践证明，轧钢加热炉使用转炉煤气是可行的。
The practical production show that the converter gas can be used in reheating furnace of steel rolling.
高炉煤气作为高温加热炉单一燃料是节约能源和改善环保的重要技术措施。
The blast furnace gas as fuel of high temperature reheating furnace is an important technology for energy-saving and environmental protection.
双段式煤气发生炉适用于钢铁轧钢加热炉、玻璃池窑等，凡是要求400度到1500度以内的窑炉均可以利用其作为燃料供应设备。
Two-stage gas producer is made for steel rolling furnace, glass furnace. It can be used as fuel supply equipment for any furnaces which require temperature to be within 400-1500 degree.
改造后使加热炉提高了加热能力和加热质量，减少了板坯表面氧化烧损，降低了煤气消耗，经济效益显著。
As a result, the heating capacity and quality of heating furnace is improved, the slab surface oxidation burning loss is decreased and the gas consumption reduced and the economic benefit remarkable.
介绍燃热脏煤气在特钢加热炉上存在的问题和蓄热式燃烧技术在燃发生炉热脏煤气特钢加热炉上应用。
This paper introduces the problem of the hot coal gas used in the heating furnace and the application of the regenerative combustion in the heating furnace burning the hot coal gas.
通过对企业副产煤气的综合利用，降低了轧钢加热炉燃油消耗和锅炉动力煤消耗，煤气的放散率大幅度降低，为企业创造了较大的经济效益和社会效益。
Through utilizing the byproduct - gas comprehensively , decrease the energy consumption of rolling heating furnace and boiler, and reduce gas of system , so get more economic and social benefit .
北满特钢加热炉由烧煤气改烧油后，冷拔材表面产生严重增碳的现象。
When the fuel for the heating furnace of Beiman Special steel Corporation was changed from gas to oil, severe carbonization happened on the surface of cold-drawn steel.
从燃气的互换性以及燃烧特性参数等方面对水煤气作为原油输运加热炉替代燃料进行了可行性分析。
The feasibility of changing natural gas into water gas was discussed in aspects of flaming gas exchangeability and combustion characteristic parameter.
煤气发生炉点火前一定要吹扫加热炉内和烟道中可能残存的煤气。
Gas occurrence boiler ignition former must sweep of heating furnace and flue gas may remaining.
生产证明在高炉煤气中适当掺加部分混合煤气可改善加热炉工作状况，有效提高加热能力。
Practice proved that blend blast furnace gas and mix gas can be improve the heating furnace work condition and availably exalt heat (ability.)
启动风机将空气鼓入加热炉炉膛，使停炉时可能残存炉膛内的煤气吹净，风机吹扫5分钟后方可送气点火。
Start up fan will air into the furnace chamber, make drum boiler stop when the gas chamber may remaining purging and fan blowing off five minutes before commencement of ignition.
将煤气流量补偿值与模型计算的煤气流量设定值相加，一起传给加热炉仪表；
F. counting up the gas flow compensation value and a gas flow set value calculated by the model and transmitting the total value to a heating furnace meter;
将煤气流量补偿值与模型计算的煤气流量设定值相加，一起传给加热炉仪表；
F. counting up the gas flow compensation value and a gas flow set value calculated by the model and transmitting the total value to a heating furnace meter;
应用推荐