蒸汽机使热转变为能。
哈格尔施泰因说，目前商业上热转变电的设备只能达到这个极限的大约十分之一。
But current commercial thermoelectric devices only achieve about one-tenth of that limit, Hagelstein says.
用增塑剂分散的聚氯乙烯树脂和含有沥青的橡胶并用的密封胶是两个不同类型的热转变体系。
Plasticizer used in polyvinyl chloride resin and dispersed with asphalt and the rubber sealant is used in two different types of thermal changes in the system.
核反应中释放出来的能被转变为热。
The energy released by the nuclear reaction is transformed into heat.
随焊接热输入和激光功率密度的增大，焊缝截面由钉形向近X形转变。
With increase of heat input and laser power density, the cross section of the weld transformed from nail shape to near X shape.
但得益于经常账户盈余的转变，使得新兴市场减少了对“热钱”的依赖，而远不如从前脆弱了。
But they are a lot less vulnerable than they used to be, thanks to the shift into current account surplus that has left them less reliant on "hot money".
实验表明，产物的乙酰基含量受合成温度和反应时间影响，其热致液晶的相转变温度和温域随乙酰基含量变化。
The experimental results indicated that reaction temperature and time were influence on acetyl content of APC products. Liquid crystalline phase transition changed with acetyl content .
利用DSC的热分析法探讨了蔗渣浆黑液在蒸发浓缩中的相转变过程。
The phase change phenomena of bagasse black liquor in its thickening was studied by using DSC(differential scanning calorimetry).
研究基于热传输理论的熔融金属从液体转变到固体状态变化过程是铸件凝固研究的重要分支。
Research on that metallic melts transforms from liquid to solid state based on heat transfer theory is an important discipline in casting solidification.
本文利用热模拟试验机对高性能耐火耐候建筑用钢WGJ510C2的奥氏体连续冷却转变（CCT）图进行了测定和分析。
Thermo-simulation was used to analyze the continuous cooling transformation(CCT) diagram of high grade of fire-resistant and weatherability construction steel WGJ510C2.
通过对非晶态样品的热分析，确定了它的晶化温度、玻璃转变温度和低温弛豫温度。
The thermal analysis was used to determine the crystallization temperature, the glass transformation temperature and low temperature relaxation temperature of the amorphous samples.
声音通过液体或固体时，就转变为热。
Passing through a liquid or a solid, sound is changed into heat.
论述了示差扫描热分析(dsc)和热重分析(TG)在研究非晶态合金退火转变动力学方面的应用。
Applications of differential scanning calorimetry (DSC) analysis and thermal gravity (TG) analysis in the study on kinetics of annealing transformation of amorphous alloys have been discussed.
用差示扫描量热仪与扭辨分析检出了四氟乙烯-六氟丙烯共聚物熔体中的转变。
The transition in the melt of FEP copolymer was detected by differential scanning calorimeter and torsional braid analysis techniques.
LC9铝合金在773K热扭转中显微组织由粗大的柱状晶转变为细等轴晶。
The coarse column-like grains of LC9 alloy are changed into fine nearequiaxed oneS during torsion at 773K.
采用热分析法研究了无机添加剂对硝酸铵晶型转变的影响，并用高分子表面处理剂对硝酸铵进行表面处理。
The effect of inorganic additives on an's crystal pattern transition is studied by DSC method, and the surface treatment of an is investigated by polymer surfactant.
在热模拟试验机上研究了控轧控冷工艺对微合金化低碳贝氏体型非调质钢组织性能的影响，并探讨了贝氏体转变机制问题。
The effect of TMCP parameters on microstructure and property was studied, and a controversial question about bainite transformation mechanism also was discussed.
计算结果表明，热脉冲作用下，转变时体系平均温度高于平衡计算熔点，结构转变是过热熔化过程，系统不可能发生从晶态到非晶态非平衡转变。
The results show that the average system temperature is higher than the calculated equilibrium melting point of cu while the transformation occurs which should be an overheated melting process.
研究中发现在连续升温过程中合金液发生了结构转变，其转变程度与升温速率、热历史和合金组成等因素有关。
The structure change is presumed in liquid PbSn alloys, and depends on the heating rate, thermal history and components and so on.
另外，依据泡核激活机制的转变并结合界面汽化热阱效应对沸腾滞后进行机理分析。
The boiling hysteresis mechanism has been analyzed on the base of the interfacial vaporization heat sink effect and the change in activation way of boiling nuclei.
不同工况下的数值结果证实了换热效果较好的流动形态会随着粘性阻力的增加而发生转变的观象。
The results of the numerical simulation prove that the preferable flow pattern will change by the increase of power consumption.
介绍了差示扫描量热法(dsc)测定玻璃化转变温度在食品中的一些运用。
Differential Scanning Calorimetry (DSC) was used to study glass transition and determine the Tg, some examples were given to in this article.
随应变速率升高，真应力-真应变曲线特征从“平缓”型向“锯齿”型转变，材料热变形软化特征增强。
As the rise of the strain rate, the feature of the true stress - true strain curve changed from "flat" to "serration", and the thermal deformation softening feature was reinforced.
利用dsc热分析法表征了添加剂对防爆硝酸铵晶型转变的影响。
The effect of various additives on crystal phase transitions of anti-explosive ammonium nitrate was presented using the DSC.
化学转变中的液化、气化和热解技术是目前主要研究方向。
The chemical conversion techniques, e. g. liquefaction, gasification and pyrolysis, are the main orientation for research and development.
化学转变中的液化、气化和热解技术是目前主要研究方向。
The chemical conversion techniques, e. g. liquefaction, gasification and pyrolysis, are the main orientation for research and development.
应用推荐