深入探讨了喷雾热解法的成膜机理。
The formation mechanism of the thin films prepared by spray pyrolysis was discussed.
这种方法比喷涂热解法还要简单，而且可蒸镀在任意形状的表面上。
It is suggested that this method is more simple in preparation of the transparent electro-conductive film of SnO2 on surfaces with any shapes in comparison with a number of known methods.
全面介绍碳纳米管的制备方法，包括电弧法、热解法、 火焰法等。
The methods for preparing carbon nanotubes including electric arc synthesis, pyrolysis and decomposition of hydrocarbon, and flame synthesis , etc.
地化录井仪是一种采用岩石热解法快速定量评价生油岩和储油岩的设备。
The geochemical logging instrument is an equipment which can fast quantitatively evaluate oil source rock and oil reservoir rock with pyrolysis method.
纳米碳管的制备方法主要有三种：电弧放电法、激光烧蚀法和有机物催化热解法。
The electric arc method is one of the most important methods in synthesizing carbon nanotubes, in addition to laser ablation method and catalytic decomposition of hydrocarbons.
其实相对于燃烧法它最主要的优点在于，至少在理论上，热解法能带动汽轮机从而发电。
But the main advantage of these technologies over incineration, at least in theory, is that syngas can power gas turbines to make electricity.
本文针对稀土氧化物超微粉末的研制，提出较好的制备方法：沉淀转化法和喷雾热解法。
Deposition inversion and pulverization pyrolysis are the better preparation methods on the study of rare earth oxide ultra micro powder.
并进一步研究了喷雾热解法中薄膜的形成过程和工艺参数对薄膜微观结构和性能的影响。
The influences of the spray parameters on the electrical and optical properties of the ATO films were evaluated and analyzed in details.
从动力学原理出发，以热解法为手段，测定了准噶尔盆地部分地区侏罗系烃源岩的动力学参数。
Based on the dynamic theory, dynamic parameters of Jurassic source rock in local Junggar basin were measured by means of pyrolysis process.
实验分析及应用效果表明，在渤海地区，储集岩热解法原油密度预测技术基本上可以替代原油分析技术。
The experiment results and application effects show that the forecasting technique of oil density with reservoir-rock pyrolysis data can largely replace the oil analysis technique in Bohai sea.
所制备的电极具有载铂量低、催化活性高的特性，比纯铂片对电极以及热解法制备的载铂对电极具有更高的活性。
The present electrode had the characters of low platinum loading and high catalytic performance which was higher than counter electrodes prepared by thermal decomposition and platinum foil.
对于固相合成和喷雾热解法两种方法制备出的样品进行了比较，确定了喷雾热解的制备方法可以使得组分混合的均匀从而导致样品对激发光有更加充分的吸收。
Two preparation methods are compared and confirm that the spray pyrolysis may have an average spread of the particle size distribution, which will lead to the effective absorption of the sample.
氰尿酸是高效除藻剂二氯异氰尿酸钠（钾）和三氯异氰尿酸的主要原料， 尿素热解法生产氰尿酸的传统工艺会产生大量的含氨气体和大量不同浓度的酸性废水。
Cyanuric acid is a main raw material for sodium dichloro-isocyanuric and trichloro-isocyanuric acid production which are high-efficient healthy reagents for eliminating algae germcide.
一步法主要包括电弧放电法、熔盐电解法、模板法和热解金属有机物法等四种。
One-step methods consist of arc-discharge method, electrolytic formation techniques, template-assisted method and pyrolysis of organometallic precursors, etc.
以不同原料，分别对制备高纯超细氧化铝粉的静态热分解法及喷雾热分解法进行对比研究，对影响粉体质量的诸因素作了具体分析与对比。
The effects of different raw materials and techniques on character of alumina powder were respectively compared and researched to pyrolysis and spray pyrolysis methods.
用氨基酸分析、热分析以及溶解法分析了丝素蛋白与环氧化合物(PGDE)在不同反应温度下形成的凝胶的微观结构。
The microstructures of gels prepared by reaction between silk fibroin and epoxide (PGDE) at different reaction temperature were studied by amino acid analysis, DSC analysis and dissolution methods.
讨论了反电极铂的两种制备方法：电化学法（恒电流法）和热分解法；
The two kinds of preparation methods of the counter electrode (platinum) were discussed: electrochemical (constant current law) and thermal decomposition.
通过对5种不同的DNA模板提取方法的比较，选定了操作简便、快速、费用低廉的热裂解法。
Through comparison among 5 different methods of DNA template extraction, heat-lyse treatment was selected for its easy-operation, low-cost and celerity.
采用了流体域与固体域耦合求解法计算耦合换热。
The coupling heat transfer was calculated using fluid area and solid area coupling solution.
经与光线踪迹法、离散传递法的计算结果比较表明，谱带模型与有限体积解法相结合能处理多场耦合下非灰介质内的辐射换热。
The numerical simulation results indicate that the finite volume method and spectral band model is suitable to deal with coupled radiation-conduction heat transfer of non-gray medium.
用碘化物热分解法由铪加工残料生产铪晶棒。
The hafnium crystal bar was produced by the iodide decomposition method from wast material of processing.
本文以镜面反射成像理论为基础，提出了一种空间辐射致冷器表面热耦合视因子的积分解法。
Based on the theory of the specular image technique, a method of integral solution used to solve the view factors between the thermal coupling surfaces of a space radiant cooler is introduced.
讨论了梯度材料在热冲击下强度问题的有限元解法。
The finite element method for the strength problem of C/M FGM underthe thermal shock loads is established.
研究了采用液相热分解法由双环戊二烯（DCPD）制备环戊二烯（CPD）的实验条件。
The preparation method of cyclopentadiene (CPD) from bicyclopentadiene (DCPD) with liquid phase thermal decomposition method is studied.
求出了薄板稳定换热方程的基本解并论述了这类问题的边界元解法。
Fundamental solutions to steady heat transfer equation of thin plates are derived and the formulation of boundary element method is described.
对催化热分解法制备的巴基管进行表面预处理化学镀、巴基管增强铜基复合材料粉末冶金法制备工艺作了的研究。
In this paper, the non-electro-plating process of carbon nanotube and the powder-metallurgy production of nanotube reinforced Cu-matrix composite is studied.
对催化热分解法制备的巴基管进行表面预处理化学镀、巴基管增强铜基复合材料粉末冶金法制备工艺作了的研究。
In this paper, the non-electro-plating process of carbon nanotube and the powder-metallurgy production of nanotube reinforced Cu-matrix composite is studied.
应用推荐