软件的主要功能是对制冷剂热力学参数进行查询，本软件将对制冷装置设计计算问题起到简化作用。
The main function of this software is inquiring about refrigerant thermodynamics parameter, it will work simplification function to the design and calculation of refrigeration equipment.
介绍了弹性针织物产生干收缩的原因及热力学的、化学的和与时间有关的参数对弹性针织物干收缩的影响。
The causes for dry shrinkage of elastic knit are described. The influences of thermodynamic, chemical and time-relative parameters on dry shrinkage of elastic knit are analyzed.
水和蒸汽的体膨胀系数和压缩率是反应堆热工水力、传热学和工程热力学中常用的参数之一。
Volumetric expansion coefficient and compressibility of water and steam are important parameters usually applied in the reactor thermal hydraulic, heat transfer and engineering thermodynamics.
推导出了按电动机功率，通过热力学逆运算，确定压缩机结构参数的计算公式。
The calculating formula of determining compressor structure parameter is derived by thermodynamic counter calculation based on motor power.
通过对其他热力学参数计算，确定出驼路沟钻矿床成矿流体具有中低盐度、低密度、弱还原-还原性的特点。
According to calculating other thermodynamic parameters, the ore-forming fluids in ores are characteristic of low-middle salinity, low density and weak deoxidize-deoxidize.
热力学参数表明，吸附过程是自发的和吸热的。
Thermodynamic parameters depict the endothermic nature of adsorption and the process is spontaneous.
本文从动力-热力学方程出发。得到反映热带气旋强度变化的参数和几个物理因子。
In this paper the parameter and some physical factors, which reflect the intensity change of tropical cyclone, are derived from dynamical and thermodynamics equations.
本文用核磁共振法测定了高氯酸铊-18冠6-水体系的各个热力学参数。
The thermodynamics parameters for the reaction of 18-crown-6 with Tl( I ) in water were determined by using NMR.
本课程从可压缩流体动力学的基础开始讲起，内容包括控制方程、热力学背景知识和特性参数。
The course begins with the basics of compressible fluid dynamics, including governing equations, thermodynamic context and characteristic parameters.
利用地质地球化学热力学计算了成矿的物理化学参数。
The physicochemical parameters of mineralization were calculated by geologic geochemistry thermodynamics.
在实验室条件下，用内蒙天然碱进行了包钢铁水的预处理试验，研究了铁水脱磷、脱硫和脱铌的热力学和动力学参数。
Thermodynamic and kinetic parameters in removing phosphorus, sulphur and niobium from hotmetal using natural soda ash have been studied in laboratory experiments.
这些损伤机理都与锻模的工作情况以及锻模材料的热力学性能参数有关。
These damage mechanisms is relevant to the work circumstance and thermodynamics function of the forging die's material.
测定了不同温度下该反应的结合常数、结合位点数及结合热力学参数。
The binding site number n, apparent binding constant K_(A) and corresponding thermodynamic parameters were measured at different temperatures.
同时也计算了热力学参数。
相变对矿物和岩石的物理性质有重要影响，会导致电导率、弹性波速、热力学、流变学参数的异常和产生相变磁效应等。
It exerts an important influence on mineral physical properties, such as resulting in the abnormalities of conductivity, elastic wave velocity, thermodynamics and magnetic effect and so on.
利用差分法反算了热力学参数。
Different method is used for back-calculating the thermodynamics parameter.
两个光散布（有弹性和动态）和扩散的影响，象直接取决于的那样表现一个阶段的特性的热力学的参数说明稳定，被详细考虑。
The effects of both light scattering (elastic and dynamic) and diffusion, as directly depending on the thermodynamic parameters characterizing the one-phase state stability, are considered in detail.
热力学参数的计算表明，从烯醇式到双酮式构型的转变是一个吸热过程。
The calculation of the thermodynamic parameters shows that the transformation from enol to keto form is endothermic process.
本文针对初温、流量一定且不循环使用的低温余热，提出确定其动力回收系统参数的热力学原则。
Thermodynamic principle of heat recovery system for low temperature waste heat with a given initial temperature and flow and for non-cycling operation is proposed in the article.
根据对所测热力学参数的分析，讨论了反应产物的可能结构。
The probable structure of products was discussed in accordance with the analysis of the thermodynamic quantities.
建立了催化反应的动力学数学模型，获得了催化反应相关的热力学和动力学参数。
The catalytic mechanism was proposed and the kinetic mathematical model of the catalytic reaction for obtaining the thermodynamic and kinetic pa.
测定了不同温度下该结合反应的结合常数，结合位点数，热力学参数。
The binding constant, the number of binding sites nand thermodynamic parameters were measured at different temperatures by fluorescence quenching method.
计算关联式具有较高的精度，热力学参数计算误差小于1% ，迁移特性参数误差小于4 %。
The calculation shows a high accuracy while the error is low than 1% in thermodynamic properties and 4% in thermophysical properties.
通过全线型分析方法求得速率常数及有关有热力学参数。
The rate constants and other thermodynamic parameters were obtained by complete line shape analysis.
根据该衍生物和牛血清白蛋白结合的热力学参数，确定了二者之间主要为疏水作用力。
The hydrophobic interaction was the main force according to the thermodynamic parameters of combine for this chrysin derivative with bovine serum albumin.
本发明提供一种测量方便的、可用于化工高纯度体系多级分离过程的热力学参数整定方法。
The invention provides a method convenient for measuring and suitable for setting the thermodynamic parameters in the multi-stage separation process of the high-purity system.
另外，在我们所制备的薄膜中还得到了氮化硼的另一高压相-爆炸结构氮化硼(E -BN)，并初步研究了其生长的热力学参数。
On the other hand, Explosive Boron Nitride (E-BN), another high-pressure phase of BN, was obtained in the resultant films. We also studied the thermodynamic parameters of the growth of E-BN films.
依据化学动力学中热力学参数与平衡常数关系得到烧蚀产物平衡常数与温度的简单关系式；
Then, the equations of balanceable constant and temperature are obtained according to the thermodynamics parameter in the chemical dynamics theory.
依据化学动力学中热力学参数与平衡常数关系得到烧蚀产物平衡常数与温度的简单关系式；
Then, the equations of balanceable constant and temperature are obtained according to the thermodynamics parameter in the chemical dynamics theory.
应用推荐