介绍了CAD技术在星载电子设备热分析中的应用和相关热分析系统的特点。
This paper introduces the application of CAD technology to thermal analysis of electronic equipment on satellite and the characteristics of thermal analysis system.
介绍了一种高精度、多功能，以PC机为主机构成的热分析系统，并给出了系统的软、硬件设计及应用。
This paper introduces a high precision, multi function PC Computer thermal analysis system and its hardware, software and application.
本文通过分析目前制冷行业换热设备设计的现状和流程，构建了换热设备CAD系统的系统模型。
The model of CAD system is constructed after analyzing the actuality and process of heat-exchange equipments' design in refrigeration industry.
本文通过对计算数据和实验数据的分析，确定了回热过程及回热时间对系统性能的影响。
In this paper, by analyzing the experimental data and dynamic calculation data, the influences of heat recovery process and heat recovery time on system performance are analyzed.
焊缝氢含量的测试分析表明，阵列式射流冲击热沉系统可以改善接头的残余应力分布，防止冷却水侵入焊缝。
The hydrogen contents investigations show that the FSW process with array jet impingement sink appaatus can prevent the joints form the effect of colding water.
通过系统地分析窖温、风温以及热流，发现了沟窖几个重要的热工问题。
Some thermotechnical problems are revealed through systematic analysis of temperature, air flow as well as heat flux in cellar.
同时，提出和分析了制冷系统中热、质自动反馈平衡的观点，并以试验做了验证。
The view of heat and mass auto-feedback equilibrium has been found, explained and verified by test.
采用会计模式和矩阵模式热经济学方法对回热循环微型燃气轮机系统进行了分析和研究。
The accounting model and matrix model of thermoeconomics are implemented to study the micro gas turbine with heat recuperator .
以汽轮机功率方程和锅炉吸热量方程为基础，并将机组的整个回热系统视为一闭口热力系统，通过对其的热平衡分析，得到了高加切除对机组热经济性影响的计算模型。
By heat balance analysis of the whole regenerative system, which is regarded as a closed thermodynamic system, the calculation model on the influence of HPs removal on heat economy of unit is derived.
介绍研制的红外热象仪计算机图象处理与分析系统。
TIPS image processing and analyzing system for infrared thermal imaging system developed was introduced.
实验采用凸平直线非稳腔，将凸面镜和增益介质热透镜效应等效为望远镜系统进行分析。
In the experiment we used convex-plane unstable resonator, and analysis the convex mirrors and gain medium thermal lens as a telescope system.
本文根据这种情况，定性分析空调系统热回收装置的影响因素。
This article according to this kind of situation, qualitative analysis air-conditioning system heat recovery installment influence factor.
通过方差分析送风参数对桌面工位空调送风系统工作区热舒适性的影响，发现送风量是影响工作区热舒适的最显著的因素。
From analysis of variance to check the influence that supply parameters of the desk TAC system impress to the task area, the supply air volume is the most significant factor.
本文的目的就是对壁板的热颤振特性进行系统深入的分析和研究，为高速飞行器的壁板结构的防颤振设计和壁板颤振抑制的研究建立理论基础。
The aim of this thesis is to analyze the panel flutter mechanism and establish a mechanical model for panel flutter analysis and this work is the basis of panel flutter control studies.
介绍了现有无线数据通讯技术的实用性、可靠性、安全性，分析了该技术在热网监控系统中应用的可行性。
This paper analyzes the practicability, reliability, and security of wireless data communication technology, and the feasibility of its application in thermal power grid supervisory system.
对太阳热水系统热及经济性能的分析是系统设计合理的关键。
The thermal and economical analysis is the key of designing the solar water heating systems.
最后分析了系统误差，并计算了系统误差对热变形测量结果的影响。
Finally the system error was analyzed and its effect was calculated to the measuring result of thermal distortion.
本文利用半导体激光器的热阻模型，研究分析了密集波分复用系统中光源的波长控制技术。
This paper introduced a thermal resistance model of semiconductor laser diode, and analyzed wavelength control technology of laser diode in dense WDM system.
在对智能网关面临的系统级失效问题进行深入分析的基础上，提出并实现了智能网关的双机容错热备份系统设计方案。
By detailed analysis of systematic failure in the Intelligent Gateway, we propose a fault tolerant design scheme of dual module hot spare, and make it into use.
本文在分析研究了蒸汽冷凝水回收系统的各种形式和设备之后，针对印染企业的蒸汽冷凝水回收系统进行了热经济性分析。
Based on the analysis of the forms and facilities of the SCWR system, the status of SCWR was investigated in the industry of printing and dyeing.
本文介绍了冻干机的热回收系统并进行了热回收的能量分析。
The paper describes the heat recovery system of freeze-dryer and its energy analysis.
本文针对车辆热系统进行了车辆热特征的分析，提出了车辆热系统的设计方案。
This thesis develops the method for analysis of the thermal feature, and presents the design method for the thermal system of vehicles.
通过对理想状态下玻璃热钢化的分析与推导，给出一个相应的系统的数学描述。
By analysis and deduction of the tempering of glass in ideal conditions, this paper intends to give a corresponding mathematic description systematically.
利用光学傅立叶分析的方法可以把热成像系统看作线性滤波器，并建立热成像系统的静态性能模型。
The thermal imaging system can be regard as a linear filter and its static performance model can be established by optical Fourier analytical method.
这项研究表明，双倒易边界元方法能够很好地处理这类问题，这类数值分析有助于热储能系统的优化热设计。
This shows that DRBEM can better solve these problems, and this numerical analysis is useful for the optimized design of thermal storage systems.
本文对集中供热系统热网特性进行了分析，在此基础上，阐述了循环泵的特性及其对供热系统的影响。
Based on the analysis to the characteristic of the district heating system, this paper expatiate the influence of the performance of circulating-pump to heating system.
本文还对激活表面及热清洁工艺进行了系统地分析，确定出了最佳的表面清洁温度及时间。
The activation surface and the process of heating cleaning have also been analyzed systematically and the optimum temperature and time for surface cleaning have been determined in the paper.
结合工程实例，分析了利用集中式空调系统冷凝热制备生活热水的设计方案。
The design scheme for preparing domestic hot water by using condensation heat from centralized air-conditioning system is analyzed with engineering example.
对废塑料的软化特性、差热分析及热态造粒工艺进行了系统的研究。
The research of the softening characteristics, DTA(differential thermal analysis)and granulating for waste plastics was described.
单组元肼分解发动机的热控制与热分析是空间推进系统重要组成部分。
Thermal control of monopropellant catalytic decomposition hydrazine engines in important portion of space propulsive system.
应用推荐