在合适的烧结条件下，可得完全致密的透明石英管。
Under a proper sintering, the complete densified and transparent silica tubes can be obtained.
研究了合金在真空烧结和热等静压烧结条件下的显微组织和力学性能。
The microstructure and mechanical properties of the alloy under the conditions of vacuum sintering and hot isostatic pressing sintering were investigated.
随着烧结条件的不同，介电常数几乎不变，但介电损耗以及介电常数的温度系数则较为敏感。
The dielectric constant was almost a constant, while the dielectric loss and temperature coefficient of dielectric constant were sensitive to the sintering conditions.
同样的烧结条件下，钛酸钡陶瓷的PTCR效应随b 2 O 3蒸汽掺杂源的浓度升高而升高。
Given the same sintering condition, doping with higher level of the vapor B2O3 source results in the higher PTCR effect.
因此，必须采用烧结性良好的UO_2粉末和合适的成型烧结条件以使开口孔隙度和细孔隙度降至最低。
So that, it is necessary to adopt very sinterable UO2 powder and suitable pelleting and sintering conditions to minimize open porosity and small porosity.
将CBZP系列粉体干压成型，用无压烧结制成CBZP系列陶瓷，研究了烧结条件对致密化程度及其力学性能的影响。
The ceramic of CBZP series were made by pressing and sintering, the affection of sintering conditions to mechanic character were investigated.
文摘：就重钢烧结原料条件下配加印度多尼矿替代部分澳矿进行了试验室研究。
Abstract: the sintering pot tests with addition of Indian iron fine ore were conducted under the material condition of Chonggang.
针对石钢的原料条件，进行了烧结配加扬迪矿的试验研究，分析了配加扬迪矿对烧结各项指标的影响以及工业生产应用后的实际效果。
The trial research of adding Yangdi ore in sintering material is conducted based on the Shi Steel's conditions, the influence to do so on various sinter index analyzed as well as practical result.
在实验室条件下，进行了全褐铁矿的烧结实验研究。
In the condition of laboratory test, sintering experiments were carried out with full limonite blend.
在不同原料、不同碱度和不同燃料配加量的条件下，在实验室的烧结杯上做了球团烧结法实验研究。
A pot grate tests were conducted in the laboratory using different kinds of materials with various basicity and rate of solid fuel.
研究了不同燃料分加比例和分加条件对混合料造小球团及烧结过程的影响。
The influence of different fuel adding rate and different fuel adding method on process making micropellet in sinter mixture was given.
炉篦条是钢铁生产的重要设备——烧结机台车上的易损备件，它的工作条件十分恶劣，损耗比较大。
The bar grate is a very important component for the sintering equipment in the metallurgical industry and it is also vulnerable.
烧结试验是指导烧结设计、生产工艺条件优化的基础，也是烧结研究的重要组成部分。
The sintering experiment is not only base for guiding design and optimization of technics condition but. al- so the important constitute part of sintering investigation.
结果显示，在本试验条件下，碱度为1.6左右的烧结矿不具有混合控制图的线性关系。
The analysis indicates that sinters with alkalinity in the neighborhood of 1.6 do not exhibit the linearity as shown in the hybrid control diagram.
采用石灰石烧结熟料自粉化方法对从粉煤灰中提取氧化铝进行了研究，系统探讨了熟料烧成条件对氧化铝溶出率的影响。
It is studied on extracting alumina from fly ash by the way of limestone sinter and self powdering, discusses the influence of the sintered conditions of powder on alumina leaching.
随着烧结生产工艺的改变，机头电除尘器的工况条件也发生了变化，作为大型钢铁企业，排放达标对环保尤为重要。
Changes in sintering technology result in variation in working conditions for an electrical precipitator at the head of sintering machine.
以含硼铁精矿作为烧结添加剂，在本钢炼铁厂生产条件下，研究了含硼铁精矿对烧结矿质量的影响。
The influence of boron-bearing iron concentrate as additives on sinter quality under the production condition of the iron making plant of BX STEEL was investigated.
分析了喷涂层梯度液相烧结的基本条件 ，并观察了其显微组织及其结合性能。
The basic condition of gradient liquid phase sintering, the micro structure and the poperty of coating bonding are discussed.
通过烧结杯试验，找出了宣钢原料条件下烧结矿合理化学成分、烧结矿低硅条件下各种化学成分的控制范围。
With sintering pot test it is found out the reasonable chemical component in sinter under the condition of Xuan Steel as well as the control range of various components for low-silicon sinter.
烧结试验是指导烧结厂设计和生产工艺条件优化的基础，也是烧结研究的重要组成部分。
The sintering experiment is not only the base for guiding design and optimization of producing technique conditions but also is the important part of sintering investigation.
通过烧结铁圆柱试样单向压缩试验，验证了粉末冶金烧结材料广义塑性屈服条件的合理性和适用性。
Based on the single axial compression of sintered iron cylinder specimens, the rationality and applicability of generalized yield criterion are validated for sintered powder metallurgy materials.
在高碱度条件下，运用正交组合分析手段，对钒钛磁铁精矿的烧结工艺进行烧结实验研究分析。
Using analysis methods of orthogonal combination under the conditions of high alkalinity, sintering process on Vanadic Titanomagnetite are researched.
并就简化模具结构设计的优缺点与前后三次激光选区烧结（SLS）的成型工艺条件和收缩率进行了探讨，提出了SLS技术的现状、发展趋势与方向。
The advantages and disadvantages of simplifying the mould structure, and the molding condition and contraction rate of the successive SLS three times are discussed.
采用松装烧结技术在不同条件下制备出多孔钛板。
The porous titanium plates were prepared by loose powder sintering technology.
本文按唐山钢铁公司烧结工艺条件，对冀东矿配加罗伯河矿进行了烧结杯试验研究。
This paper studied the sinter pot test of adding Robe River Ore to Ji - dong Concentrate under the sintering-operating condition of Tangshan Iron and Steel Company.
结果表明：钽阳极块中的氧含量主要由原料钽粉中的杂质氧含量所决定，且与阳极块的压制、烧结及赋能条件等相关；
Results show that the oxygen content is dependant on the impurity oxygen content of the in Ta powder and is related to the anode sheet compaction, sintering and property.
通过一系列技术措施的实施，烧结机利用系数得以提高，为高炉增铁节焦创造了条件。
As the implementation of these technical measurements, the productivity of sinter machine was increased, and was helpful for increasing BF output and energy saving.
进行了在不同原料条件下实行固体燃料分加的烧结试验研究。
Experimental studies have been conducted on feeding the solid fuel into sintered material sequentially in the different stages in light of different material conditions.
进行了在不同原料条件下实行固体燃料分加的烧结试验研究。
Experimental studies have been conducted on feeding the solid fuel into sintered material sequentially in the different stages in light of different material conditions.
应用推荐