在少齿差内啮合传动中，存在多对接近啮合的小间隙齿面于理论啮合点左右，轮齿受力产生的微小变形使得某些对齿面相互接触进入啮合状态。
In small tooth difference of inner meshed transmission, there were a few pairs of tooth faces which were apart from each other for a small gap beside the contact point generated by two meshed teeth.
一般齿轮齿形曲线在一点邻域的高阶阶戴劳级数展开后，会发现齿面啮合点邻域间隙为2阶无穷小。
The common gear tooth profile curve launches after neighborhood higher order step taylor's series, can discover the tooth face meshing point neighborhood gap is 2 step infinitely greats.
结果表明，齿面弹性变形引起的齿轮轮齿的微小转动对啮合点的最终位置有一定的影响。
The results show that the micro rotational Angle induced by the tooth surface elastic deformation has definite effect on meshing points.
推导了进入双点啮合区的法面啮合角公式，采取了独特的剃齿刀修形方式，从设计和修形上下功夫杜绝剃齿中凹的产生。
And the normal engagement angle of approaching double-point tooth area is deduced. The special dressing method of shaving cutter has been adopted.
推导了进入双点啮合区的法面啮合角公式，采取了独特的剃齿刀修形方式，从设计和修形上下功夫杜绝剃齿中凹的产生。
And the normal engagement angle of approaching double-point tooth area is deduced. The special dressing method of shaving cutter has been adopted.
应用推荐