当增加重复频率时,输出与泵浦激光重复频率完全一致的激光脉冲,但也将在一个泵浦脉宽中出现多个激光脉冲输出。
Increasing the repetition rate, the output laser has the same repetition rate as the pump laser, but more sub-pulses will be output in one pump pulse.
结果表明:在较低气压和较高的射频功率下制备的a - C膜质量较好,同时,激光重复频率对膜生长也有显著影响。
As a result, lower working pressure and higher RF power is helpful to prepare good a-C film, meanwhile, laser repetition has evident influence on films growth.
试验建立起了凹坑深度与脉冲功率密度、激光平均功率、脉冲重复频率和离焦量之间的关系曲线。
Crater depth versus pulse power density, average laser power, pulse repetition frequency and focal distances are built up through experiment.
通过计算揭示出影响激光输出功率的主要因素是峰值电子温度,而重复频率的限制主要取决于初始电子密度。
The calculation indicates that the main parameter effecting laser output power is the peak electron temperature, while the limitation of repetition rates is related to the initial electron density.
本课题主要是针对LD泵浦固体激光器的高重复频率的电光调q系统的研究与设计。
The topic of this article mainly research and design about LD pumped solid laser high repetition frequency Q-switch system.
通过使用具有高强度和高重复频率的激光照射透光绝缘膜来形成穿透开口。
A penetrating opening is formed by irradiating a light-transmitting insulating film with laser light having high intensity and a pulse high in repetition frequency.
高重复频率脉冲激光高达240千赫。
激光功率和其它特性可优化在不同的重复频率范围。
Laser power and other characteristics can be optimized in different repetition rates.
这是一种可用于连续,重复频率脉冲及单脉冲激光光束传输特性的分析测量方法。
The method is usable for CW Iaser beam, repetition pulsed laser beam and single pulsed laser beam.
讨论考虑激光探测非线性和脉冲重复频率等因素时,激光导引头角跟踪回路的数学模型,并在MATLAB下对该模型进行仿真。
In this paper, the impact of non-linear laser detect and impulse repetition frequency on Angle tracking loop is studied. A more accurate system model is proposed and emulated in MATLAB.
在双调q激光器中,声光器件用于控制脉冲的重复频率,同时允许激光晶体储存能量以保证反转粒子数被完全吸收。
In this doubly Q-switched laser, the AO Q-switch is used to control the pulse repetition rate and allow the laser medium to store energy to ensure that the population inversion is fully saturated.
主电极间正常的辉光放电以及使混合气快速流动且不被污染是重复频率TEA CO_2激光器实现高平均功率输出的重要条件。
The normal glow discharge between the main electrodes and the rapid flow of the unpolluted gas mixtures are necessary conditions for the output of high average power for TEA CO2 laser.
实验结果表明,高重复频率激光器是实现高地面分辨力的机载三维信息采集的重要保证。
The experimental results show that the laser is an important assurance for doing 3 - D airborne information acquisition with high ground resolution.
激光二极管泵浦的高重复频率调Q固体激光器在激光通信、光存储、打标、焊接和测距雷达等方面已经获得了广泛应用。
The high repetition rate LD pump Q-switch solid state laser has been widely used in a lot of fields, such as the laser communication, optical storage, marking, welding and ranging radar.
实验表明,采用非线性放大复合环形镜构成复合腔光纤激光器,有可能获得高重复频率的锁模脉冲。
It is suggested that using a NACLM as a passive mode locking element, generation of ultrashort pulses of very high repetition rate is promising with a fiber laser.
实验表明,采用非线性放大复合环形镜构成复合腔光纤激光器,有可能获得高重复频率的锁模脉冲。
It is suggested that using a NACLM as a passive mode locking element, generation of ultrashort pulses of very high repetition rate is promising with a fiber laser.
应用推荐