图1漏电电流随电压变化的函数图。
Diagram 1: Evolution of leakage current as a function of test voltage.
电池应放在干燥的地方，以免漏电。
Batteries should be kept in dry places lest electricity should leak away.
清除绕组端部污秽后，泄漏电流正常。
After cleaning the winding end, the leakage current becomes normal.
用试验(校)灯来寻找漏电。
向有关人员汇报漏电风险。
电池一定要放在干燥的地方，以免漏电。
Batteries must be kept in dry places for fear that electricity leak away.
体电阻率：表示直接通过材料的泄漏电流。
Volume resistivity: leakage of current directly through the material.
医疗或低漏电流需求，集成设计电子设备。
Medical or low leakage current requirements compact design electronic equipment.
保护技术是降低泄漏电流的非常有效的方法。
Guarding is a very effective way to reduce leakage currents.
老练电压对铝电解电容器容量和漏电流的影响。
The effect of aging voltage on the capacitance and leakage current of al electrolytic capacitors.
泄漏电流将在此回路中流动，但是不影响测量。
A leakage current will flow around this loop, but won't affect the measurement.
在传统系统中电流加石灰会引出漏电配位的问题。
Current liming in a traditional system can present problems with fault coordination.
闪光灯用焊片式产品，具有低损耗，低漏电等特点。
For photoflash lug type low loss factor and low leakage current.
闪光灯用焊片式缩体产品漏电流小可减少电池消耗。
For photoflash lug type miniaturized low leakage current reduces battery consumption.
进行了电站保护接地的局限性和漏电保护的必要性分析。
Analyzed the limitation of protective earth and necessity of leakage protection for electric power plant.
测量高电阻时两个最常见的误差来源是静电干扰和泄漏电流。
The two most common error sources when measuring high resistance are electrostatic interference and leakage current.
试验结果表明，该漏电保护装置满足了快速性和稳定性的要求。
The test result showed that the leakage protector meets with requires of rapidity and stability.
正如图1所示，而从电压Uc开始，漏电电流迅速增加，击穿电压达到Ue。
As shown in Diagram 1, as from the voltage Uc, the leakage current increases very swiftly and the breakdown voltage is reached for value ue.
经过实验测试，系统实现了选择性漏电保护和其它主要的保护功能。
After the experiment, the system has realized the selective leakage protection and other main protection function.
所提出的T型复位开关有效避免了积分期间复位开关漏电流的影响。
The proposed T-type reset switch avoids the leakage current influence effectively during the integrating period.
泄漏电流是由测量电路和附近的电压源之间的寄生电阻通路产生的。
Leakage currents are generated by stray resistance paths between the measurement circuit and nearby voltage sources.
外部的分流电阻，例如：漏电的电缆和肮脏的绝缘子也可能引起负载误差。
External shunt resistances, such as leaky cables and dirty insulators, may also cause loading errors.
这类应用可能包括电容器的漏电流、二极管反向漏电、电缆或薄膜的绝缘电阻等。
Some of these applications may include leakage current of capacitors, reverse diode leakage, or insulation resistance of cables or films.
在另一些情况下，漏电可以用给定电压(通常为工作电压)下的泄漏电流来表示。
In other cases, leakage may be expressed as a leakage current at a given voltage, usually the operating voltage.
电气强度试验包括在测试过程火线和地线同时短路的情况下测量被测设备的漏电量。
The Dielectric Withstand test consists in measuring the current leak of a device under test, while phase and neutral are short circuited together.
通过分析和计算说明老式煤电钻综合保护装置在漏电保护和执行电路中存在的问题。
The problems in leakage protection and executive circuit of synthetical protection set in coal electric drill have been analyzed and calculated.
通过分析和计算说明老式煤电钻综合保护装置在漏电保护和执行电路中存在的问题。
The problems in leakage protection and executive circuit of synthetical protection set in coal electric drill have been analyzed and calculated.
应用推荐