低漏电流有助于延长电池使用寿命。
清除绕组端部污秽后，泄漏电流正常。
After cleaning the winding end, the leakage current becomes normal.
医疗或低漏电流需求，集成设计电子设备。
Medical or low leakage current requirements compact design electronic equipment.
体电阻率：表示直接通过材料的泄漏电流。
Volume resistivity: leakage of current directly through the material.
保护技术是降低泄漏电流的非常有效的方法。
Guarding is a very effective way to reduce leakage currents.
其中有些测试工作包括各种泄漏电流的测量。
Some of these tests include a variety of leakage current measurements.
贮存超过2年的电容器，其漏电流可能增大。
Leakage current of the capacitors that have been stored for more than 2 years may increase.
老练电压对铝电解电容器容量和漏电流的影响。
The effect of aging voltage on the capacitance and leakage current of al electrolytic capacitors.
泄漏电流将在此回路中流动，但是不影响测量。
A leakage current will flow around this loop, but won't affect the measurement.
闪光灯用焊片式缩体产品漏电流小可减少电池消耗。
For photoflash lug type miniaturized low leakage current reduces battery consumption.
测量高电阻时两个最常见的误差来源是静电干扰和泄漏电流。
The two most common error sources when measuring high resistance are electrostatic interference and leakage current.
这些二级管一定要好的，在最高操作温度时漏电流要尽量低。
These diodes had to be good; leakage had to be low at the highest operating temperature.
所提出的T型复位开关有效避免了积分期间复位开关漏电流的影响。
The proposed T-type reset switch avoids the leakage current influence effectively during the integrating period.
泄漏电流是由测量电路和附近的电压源之间的寄生电阻通路产生的。
Leakage currents are generated by stray resistance paths between the measurement circuit and nearby voltage sources.
介绍了泄漏电流在线监测装置的原理、信号抽取方案和软硬件设计。
This paper introduces the principle, scheme of signal extraction, design of the software and hardware about the on-line monitoring device of the leakage current.
在分析泄漏电流频率特性的基础上，提出了数据采集卡的选取原则。
The selection principles of DAQ card are proposed on the basis of analyzing the LC frequency characteristics.
当电缆的长度增加时，其电缆电阻、电容和泄漏电流等参数也会变化。
Parameters like cable resistance, capacitance, and leakage currents change as cable length increases.
通过实验研究了闪速存储器存储单元中应力诱生漏电流(ILC)产生机理。
The generation mechanism of stress induced leakage current (SILC) in flash memory cell is studied by experiments.
界面层的存在使介电系数、自发极化、矫顽电压、漏电流都与薄膜的厚度有关。
Dielectric constant polarization coercive voltage and leakage current have relations with the thickness of thin films because of the interface layer.
这类应用可能包括电容器的漏电流、二极管反向漏电、电缆或薄膜的绝缘电阻等。
Some of these applications may include leakage current of capacitors, reverse diode leakage, or insulation resistance of cables or films.
在另一些情况下，漏电可以用给定电压(通常为工作电压)下的泄漏电流来表示。
In other cases, leakage may be expressed as a leakage current at a given voltage, usually the operating voltage.
实验室的应用证实，该系统的设计比较成功，是一套研究绝缘子泄漏电流的有效工具。
The system has been implemented in the laboratory and proved to be a successful-designed tool for insulator leakage current monitoring.
灯具泄漏电流测试线路中隔离测试变压器次级接地问题直接影响着测试结果的准确性。
The earthing of secondary circuit of an isolating test transformer on the circuit for luminaire leakage current test strongly influences the accuracy of test results.
主要检测设备：6 位半数字表、泄露电压测试仪、泄漏电流测试仪、耐压测试仪等。
While the main detection machine includes: 6-figure table, leak voltage tester, leak current tester and withstand voltage tester .
这些效能改进的原因可以归之于经过表面处理后，闸极漏电流的降低以及载子注入的减少。
The improvements are most likely due to the reduction of the gate leakage current and the charge injection effect.
虽然利用金属氧化物电极可以提高其抗疲劳性，但是这种电极不易制备并且会增加漏电流。
Although using metal oxide electrodes can solve the fatigue problem, it is not easy to synthesize and the leakage current can increase.
由于流过齐纳二极管的泄漏电流会在电阻器上产生电压降，所以希望使用低漏电的齐纳二极管。
Since the leakage current through the zener diodes results in a voltage drop across the resistor, low leakage zener devices are desirable.
为了降低泄漏电流，应当使用高质量的绝缘材料，降低测试环境中的湿度，以及采用保护技术。
To reduce leakage currents, use good quality insulators, reduce the level of humidity in the test environment, and use guarding.
本文介绍了绝缘子污染的测量方法，表面电阻测量装置和泄漏电流检测装置，并取得一些结果。
This paper introduces the method of insulation pollution testing, including surface resistance device and Vent current testing device, with correct results.
本文介绍了绝缘子污染的测量方法，表面电阻测量装置和泄漏电流检测装置，并取得一些结果。
This paper introduces the method of insulation pollution testing, including surface resistance device and Vent current testing device, with correct results.
应用推荐