湿面和应用，避免眼睛周围。
湿面和工作产品的泡沫。
湿糯米粉粘性极强，只好用手揪一小团湿面，挤压成圆片形状。
Extremely wet sticky glutinous rice flour, a small group had to hand-pulling the wet surface, extruded into a wafer shape.
用螺旋式挤压机生产鲜湿面，对其生产工艺及产品质量进行了探讨。
Some studies were made on the processing and quality of fresh - noodle produced by screw extrusion machine.
用法：温水湿面后取适量本品，加水轻柔按摩于面部，以清水洗净即可。
Usage:Take suitable amount of goods after wetting face with warm water, gently massage with water on the face, thoroughly rinse off with pure water.
使用方法：湿面后，取适量本品均匀涂于脸，轻轻按摩片刻，再以清水洗净。
Usage: After wetting the face, apply proper amount of this product onto face and massage for a moment. Then wash off with clean water.
使用方法：湿面后，取适量本品均匀涂于脸，轻轻按摩片刻，再以清水洗净。
Usage: After skin wetting, apply right amount onto the face, gently massage for a while, then rinse off with clear water.
它可改良面条组织的粘结力，减少断头率和湿面回头率，提高正品率，还对挂面的酸度有抑制作用。
It can eliminate adhesion stress of noodle organization, reduce rate of broken and wetted flour, enhance rate of quality goods; furthermore, it can restrain the acid of noodle.
用法：湿面后，取适当直接涂于面部，用手轻轻搓按，然后用净水冲刷干净。也可以用于浑身其他部位。
Usage: After skin wetting, directly apply proper amount onto face, gently massage skin and then rinse off with clear water. It is also applicable for body.
雨水和湿土那厚重的味道透过敞开的窗子袭面而来。
The rich scent of rain and wet earth was blowing through the open window.
在胎面胶研究配方中，SSBR 2305可实现高抗湿滑性和低滚动阻力的良好平衡。
Thus the balance between the wet - skid resistance and rolling resistance of tire tread could be achieved by SSBR 2305.
将该复合材料加入载重轮胎胎面胶中，可提高胎面胶的抗湿滑性。
The wet-skid resistance of tread stock was improved when the compound was added to tread stock.
如板材处于较差的环境下使用，例如：办的两表面处于较大的温差及湿差情况下，为使板材使用效果更好，当一面涂上处理层时，另一面也应涂上相同的材料。
When in poor environment, for instance, when the temperature difference between two surfaces is large, both sides should be coated with processing layer for the cause of effectiveness.
干燥裸地边界层内的逆湿现象是由于下垫面非均匀的湿度场与中尺度平流的共同作用的结果。
A phenomenon called humidity inversion is caused by the joint of the heterogeneous humidity Pattern and mesoscale advection over the underlying surface.
采用正交试验方法，对胶料各组分进行优化，使胎面胶滚动阻力降低，同时又能保持良好的抗湿滑性能。
The various ingredients in tread compound were optimized with the orthogonal experimental method to lower the rolling resistance of tire tread without sacrificing its wet traction.
对高温、高湿矿井机采面环境参数进行测定，同时对矿工的劳动负荷进行跟踪监测，并对测得的数据进行计算机处理。
The environmental parameters are measured at mines mechanical work site with high temperature and humidity, the miners labour load is monitored and the obtained data is processed by computer .
使用室内磨耗试验机LAT100研究含NR、SBR、BR及不同品种炭黑胎面胶的耐磨性和抗湿滑性。
The abrasion resistance and wet traction of NR, SBR and BR vulcanizates with different carbon blacks respectively were investigated by LAT100 abrasion tester.
提出了一个通过任意谈成面叶棚的湿蒸汽平衡态流动的简化模型。
A simplified model of wet steam equilibrium flow past cascade of arbitrary airfoils on general surface of revolution is presented.
煤层注水预湿是采煤工作面防尘的治本措施，添加湿润剂是改善煤层注水效果的重要途径。
Prewetting of coal seams by water infusion is an essential measure for dust control at working faces.
煤层注水预湿是采煤工作面防尘的治本措施，添加湿润剂是改善煤层注水效果的重要途径。
Prewetting of coal seams by water infusion is an essential measure for dust control at working faces. Adding of wetting agent is an important approach for improving water infusion.
轻卡系列轮胎采用了加宽胎面，配以流线型加深花纹沟、曲折型细花纹刀槽，使轮胎具有优越的抗湿滑抓地性能。
LTR tires adopt widened tread, match with streamlined to deepen decorative pattern ditch and twist faconne groove pattern type, which makes tire own excellent performance for wet griping resistance.
黏结面为湿饱和状态的黏结试件黏结强度高于黏结面为干燥状态的黏结试件；
The bonding strengths of the specimens with saturated interface are higher than those with drying interface.
黏结面为湿饱和状态的黏结试件黏结强度高于黏结面为干燥状态的黏结试件；
The bonding strengths of the specimens with saturated interface are higher than those with drying interface.
应用推荐