在空分装置改造时，卧螺离心机在主换热器的每个板式单元的各个通道的进出口管线上增设了温度测量点。
When the air separation device is reformed, the temperature measuring point is added to the inlet and outlet pipeline of each plate unit of the main heat exchanger.
其中的一个方法是测量行为类似于针对某个点的单元，并记录辐射率温度读取器。
One way is to measure a cell that behaves similarly with a point and shoot emissivity temperature reader.
温度的记录间的细微差别的原因还有一点是不同研究所运用的测量温度的参考不一样。
The temperature records also differ slightly because the point of reference that each group uses to calculate global temperature is different.
双支铂热电阻主要用于需要由两个显示仪表同时测量和调节同一地点温度的场合。
Two-branch platinum thermal resistance mainly used in occasion of the same place temperature was measured and adjusted by two display instrument.
通过检查炉子内部控制设备点位置的操作温度，证实马弗炉的测量和控制电路的准确性。
Verify the accuracy of the measuring and controlling circuitry of the muffle furnace by checking the positions in the furnace at the control set point temperature of intended use.
通过正交试验对预冻时间和升华干燥时间进行了分析，测量了黄瓜的共晶点温度和干燥时间。
With the help of the orthogonal experimentation we analyse the academic number of the Pre-freezing and sublimation-drying time, measure co-crystal temperature and the drying time.
本文介绍了用示波器测量铁磁物质居里点的方法，形象地展示了铁磁物质的磁性随温度的变化。
A method of measuring the Curie temperature of ferromagnetic substance by oscilloscope is presented in this paper, showing vividly that the magnetic of ferromagnetic substance varies with temperature.
测量流过某一截面上的对流热流量，可以归结为测量流过该截面上各点介质的温度和速度。
The measurement of heat flux in convection through a cross section can be made by measuring the temperature and the velocity of flow of the medium at certain point of the cross section.
用热线风速仪、铜—康铜热电偶分别测量出不同送风量下的室内各个测点的速度和温度。
We used anemometers and copper constantan thermocouple respectively to measure velocities and temperatures of all measuring points under various air volumes within the room.
采用“固定冷浴温度、局部过冷、密封样品管、机械搅拌”的方法进行溶剂或溶液凝固点测量，与传统方法相比，它具有操作简单、结果准确、重现性好的优点。
In this paper, a method of determination of the freezing point with "a ice water bath of lower and unchanged temperature, lower cold in part, airtight tube, stirring with a machinery" is reported.
本课题设计了一种具有多个测点的智能温度测量控制应用系统。
This topic designed one kind to have many measuring point intelligence temperature survey control application systems.
当测量温度中使用电阻式温度检测器，励磁电流本身这个温度产生I2r，或焦耳热化，产生一个比指示温度稍微高一点的温度标准。
When measuring temperature using an RTD, the excitation current itself produces I 2r, or Joule heating, producing an indicated temperature somewhat higher than the temperature being measured.
虽然低温限制未进行测量，我们能适当地推定FOXY传感器在低于水的凝固点的温度下运行也良好。
Though the low temperature limit has not been tested, we can reasonably deduce that the FOXY Sensor operates successfully well below the freezing point of water.
模式主要输入的参数有气温、地表面温度、湿度、风速及测量点高度。
The main input parameters are air temperature, surface temperature, humidity, wind speed and the measurement height of these variables.
建立光谱测温模型，推导光谱测温方程，实现温度场中测量点温度的实时计算。
Establish a spectroscopic measurement of temperature model, derive radiation transport equation and realize real time temperature computation of the measured point.
当剪切温度接近或超过反常点时，测量温度下的粘弹性参数基本不随剪切温度变化；
When the shear temperature was close to or higher than abnormal point, the viscoelastic parameters varied little with the shear temperature.
众所周知，内点温度的测量误差往往导致导热逆问题计算的不稳定。
It is known that the measurement error for the interior temperature always causes the numerical solution of the inverse heat conduction problem unstable.
软件校准测量电路的零点和满度，软件校正温度传感器和测量电路的非线性。
The method of software is applied to calibrate zero and full scale of the circuit and nonlinear approach for sensor and circuit.
A大副，每一个舱的空距要连续测量三次，温度要测量上、中、下三个点，并且这些数据取平均值作为空距及温度结果。
Chief mate, we would like to take ullage three times in each tank, and check temperature at upper, middle and lower spots, average figures would be available.
由于现有的电子水平仪随时间、温度的变化会产生零点漂移，测量前需进行手动调零。
Change of time and temperature will bring zero shift to electronic gradienter nowadays.
该装置可测量36个温度点和一个环境温度并具打印和报警功能。
This device can measure 36 temperature points and an atmospheric temperature. It has functions of printing and giving an alarm.
本课题设计了一种具有多个测点的高精度、宽量程的智能温度测量应用系统。
This subject involves a high-precision and wide-range application system on intelligent temperature measurement with many measuring points.
如需测量的对象温度变化范围很小，或需要测量临界点温度，则可应用热敏元件。
When the temperature measurement is made on low variations or to detect a threshold, a thermistor can also be used.
通过对比两个热电偶的温度获得每个实验温度点下的温度差，在每一个温度点上重复测量5次，取其平均值。
By comparing the two thermocouple temperature was the temperature at each experimental temperature difference in each temperature measurement point to repeat 5 times less on average.
使用数字测温仪测量针尖、皮肤进针点及二者中点的温度。
Temperature of needle tips, the puncture spots on skin and midpoints of needles were measured with semi-conductor thermistor digital thermometer.
本设计重点解决初馏点、10%~90%馏出温度、干点测量以及油体馏出速度控制两大问题。
This project forced on resolve the measure of the Initial boiling point, 10%~90% distillation temperature, Final boiling point and the distillation rate problem.
本设计重点解决初馏点、10%~90%馏出温度、干点测量以及油体馏出速度控制两大问题。
This project forced on resolve the measure of the Initial boiling point, 10%~90% distillation temperature, Final boiling point and the distillation rate problem.
应用推荐