在温度T下的分压为。
温度要合适，压力要合适，还要压三遍。
Got to have right heat, right pressure, and run 'em through three times.
降低气体氧化产物的分压将有助于降低氧化的转化温度。
Reducing the pressure of the gaseous product would help to lower the transition temperature of oxidation.
本文针对汽轮机转子的脆化现象，运用有限元方法对引进型300MW汽轮机冷态启动过程的高中压转子瞬态温度场进行了分析计算。
To the embrittlement phenomenon of steam turbine rotor, this thesis calculated 300mw steam turbine rotor's transient temperature field of cold start-up using FEA method.
氮气是惰性气体，膨胀系数低，不轻易随环境温度上升而上升，可较长时间维持正常胎压，大大降低爆胎几率。
Nitrogen is the inert gases, low expansion coefficient, not easily with the environmental temperature rise for a long time, can maintain normal tire pressure, greatly reduce the flat tire.
在压缸内的摩擦力和铝锭的流变应力引起温度变化。
The temperature change is caused by the friction in the container and the flow stress of the aluminum.
在炉温和炉压控制回路中，采用了经过改进的模糊控制器，得到了较快的响应特性和较精确的温度、压力控制效果。
A modified fuzzy controller structure which has faster response and higher accuracy is used to control the temperature and the pressure of the furnace.
温度降低时，熔体黏度大，机头压力增加，挤出制品压的较密实，形状稳定性好。
The head pressure increases when the melt viscosity and temperature decreases, so the products will have good shape and favorable stability.
分析了烧结温度和烧结保温时间对压坯密度的影响。
Effect of sintering temperature and sintering holding time on green density was analyzed.
通过改变合成分子和盐的加量得到不同温度下的清洁压裂液配方。
Though altering dosage of synthesized goods and salt, confirmed clear fracturing fluids composes fit for a series of temperatures.
此芯片集成化程度较高，可以补偿硅压阻式压力传感器的温度误差和非线性误差。
It is mainly used to compensate temperature shift and non-linearity error of piezoresistive pressure sensor.
分析了带压安装温度变送器的工艺过程。
The processing of mounting temperature transducer under pressure is mainly described.
应用环境-管路流体介质，温度和最大工作压差。
Service conditions-line media, temperature, and maximum operating differential pressure.
给出了吸附容量、保留量、等温曲线、温度与平衡压的关系曲线。
Absorption capacity, gas retaining, isotherm curves, and relationships between desorption equilibrium pressure and temperature are given.
采用可编程控制器自动控制生产程序、压辊温度、传动速度等技术参数。
It can be equipped with programmable controller to materialize auto monitor production procedure, embossment roller temperature, driving speed and so on.
板片数量由流速流体的物理属性、压降和温度程序决定。
The plate numer is subject to the physical performance of the flow, pressur drop and temperature.
在其它条件不变的情况下，外掺氧化镁混凝土的压蒸膨胀率随着压蒸温度的升高而增大，但增幅随之而减缓。
The autoclave expansion of WECAM goes up and its rate trends to mitigation when autoclave temperature rise under other fixed condition.
理论计算和实验结果表明：压敏电桥输出电压与温度成线性关系。
Theoretic computation and experimental results show that the output voltage is linear with temperature.
得出温度和氢平衡压的关系式。
The relationships between the equilibrium plateau pressure and the temperature were calculated.
提高密闭容器内气体的温度会使气体的内压升高。
An increase in the temperature of a gas confined in a container will lead to higher internal pressure within the gas.
试验结果表明：热压温度、保压时间等工艺参数对梯度合金的热压致密化及梯度组织的形成有着明显的影响；
The results show that a continuous gradient distribution of Co could be obtained by controlling the hot pressing parameters.
分析了放电电压、致密次数、加热温度等因素对压坯致密度的影响。
The effects of the discharge voltage, compacting times and temperature on the relative densities of the compacted specimens are analyzed.
通过数值解算得到系统总压、产品温度(表面温度、中心温度、质量平均温度)、产品质量随时间的变化曲线。
Variation histories of total pressure of the vacuum system, product temperature as well as product mass are achieved by numerical calculation.
流加培养基的方式、胞内酒精积累、温度和渗透压等因素均与酵母的酒精耐性有关。
Factors such as mode of substrate feeding, intracellular ethanol accumulation, temperature and osmotic pressure all contribute to the ethanol tolerance of yeast.
就提高沥青路面压实质量问题，从碾压温度、压实速度与遍数、振频与振幅及混合料特性几个方面进行了阐述。
From compaction temperature, compaction speed and times, oscillation frequency, amplitude as well as mixture performance etc, the paper expounds enhancing the compaction quality of asphalt pavement.
对温度和负压采用专家模糊控制，既能保证系统的安全性，又能提高经济性。
Expert fuzzy control is used on temperature and negative pressure control and a safe and economic result can be obtained.
和传统沥青混合料相比，掺加聚酯纤维沥青混合料主要在拌合时间、施工温度、沥青混合料压实等方面有所区别。
Compared with tradition asphalt mixture, polyester fiber applied in asphalt mixture is different in mix time, construction temperature and mixture compaction.
通过对中压吸收塔改造后的工艺原理分析，提出在开车过程中中压吸收塔温度控制的预防措施。
This article analyses process principle of mp absorber after revamping, and presents the preventive measures for control of mp absorber temperature during its startup.
通过对中压吸收塔改造后的工艺原理分析，提出在开车过程中中压吸收塔温度控制的预防措施。
This article analyses process principle of mp absorber after revamping, and presents the preventive measures for control of mp absorber temperature during its startup.
应用推荐