给出了不同电输入条件下的音圈和磁体的温度公式。
The temperature expressions of voice coil and magnet structure under different electric input conditions are given.
本文介绍了由切比雪夫多项式逼近的标准电阻温度公式。
This paper describes the approximate resistance-temperature formula of standard resistors by Tchebysheff polynomial.
应用热负荷修正系数，对变流量质调节供回水温度公式进行了修正。
Applying the correction coefficient of heat load, the formula on supply and return water temperature in variable temperature control with varied flow is corrected.
用叠加原理求解多层非均匀内热源组合平板稳态导热微分方程组，得出热流量分布公式和温度公式。
The steady heat-conduction differential simultaneous equations of multicomposite plate with nonuniform generation are solved by the superposition principle.
但是，需要怎样的关于气体的公式和数据才能预测温度会上升多少呢？
What are the physics equations and data on gases that predict just how far the temperature will rise?
然后，根据现有的文献资料，提出混凝土在收缩应力以及温度应力作用下板角应力公式。
Then, according to the existing cultural heritage data, put forward formula of stress in the case of the shrink stress and temperature stress.
本文提出的预应力结构中考虑温度效应的经验公式，可用于指导设计与施工。
The experiential formulas of temperature effect on prestressed structures can guide design and construction.
为了得到加热产品的更合适的温度梯度，具体的计算间距的公式见图3。
The formula for computing the recommended spacing to obtain an even temperature gradient on the product being heated is shown in Figure 3.
得出磁滞损耗功率与频率、磁通密度及温度的经验公式。
An empirical formula describing the dependence of the power of hysteresis loss on frequency, magnetic flux density and temperature was derived.
通过间距计算公式得知加热产物温度梯度，具体详见图4。
The formula for computing the recommended Element spacing to obtain an even temperature gradient on the product being heated is shown in Figure 4.
给出了应变传感器进行应变测量时的温度补偿公式与工程实施方案。
The formula of temperature compensation and the project of construction during strain measuring are presented.
提出主流区风口模型计算气流温度和速度的特性公式，并研究其在工程中的实际应用情况。
The characteristic equations for temperature and velocity of air flow in jet main region specification model were put forward and validated in a case study.
本文给出了一种新的水力压裂裂缝的缝中温度计算公式。
In this paper, a new formula for calculating the temperature in hydraulic fractures is given.
采用集总参数模型，推导了脉冲堆燃料元件瞬态温度场的计算公式；
The formula for calculating transient temperature field in pulse reactor fuel element is derived with lumped parameter models.
此测量方法已通过实验验证，并得到了用于计算堆芯冷却剂出口温度的经验公式。
This measuring method has been tested by experiments, an empirical formula is for evaluating the core coolant temperature has been obtained.
第二篇就在这些公式的基础上讨论了拱坝温度荷载的计算。
Based on these formulas, computations of the temperature load in arch DAMS are discussed in the second part.
给出了定域势情形下，有限温度半经典方法的主要公式。
The main formulae of finite temperature semiclassical method are presented for a local potential.
此近似公式和温度迭代法组成了主动式红外空间扫描的近似反演。
The inversion of the active infrared scanning equations is formed by combining the concentration formulae and the temperature iteration.
喷墨过程的数值建模是建立在一维热传导公式，温度-压强关系式和能量、物质转换关系的平衡的基础上的。
This model is based on a one - dimensional heat conduction equation, an equilibrium press- temperature relation, energy and mass conservation relations.
在分析和测试数据基础上，给出了包括地温和“约束度”因素在内的埋地管道温度应力的修正公式。
On the ground of analytical and test data, it gives out the revision formulas for buried pipeline temperature stress which take into account such factors as soil temperature and "constrain limit".
基于这种近似，人们导出了椭圆高斯光束辐照温度场计算公式，并获得广泛应用。
On the basis of approximate effect, the calculation formula of temperature field with elliptic Gaussian beam radiation has been deduced and widely applied.
本文根据热弹理论，提出了组合厚壁圆筒温度应力的计算公式。
Formulas based on the thermoelastic theory for computing temperature stresses in the composite hollow cylinder are presented in this paper.
由傅里叶定律导出了考虑导热各向异性时的温度场有限元计算公式。
The FEM formula for computing temperature field is deduced based on Fourier law.
笔者运用吴宏鑫提出的全系数自适应控制方法及经验公式，对啤酒发酵温度进行控制。
By means of the all-coefficient adaptive control method presented in literature and an empirical formula, the authors are capable of controlling the fermentation temperature of beer brewery.
通过对混凝土温度裂缝分类、成因与控制机理的分析，总结了混凝土温度应力的公式。
The paper gives the formula of temperature stress by analyzing the cause, classification and control mechanism of the the thermal crack control of concrete.
抬升和剥蚀对温度梯度的联合效应可以根据公式3。86进行估定。
The combined effect of uplift and denudation upon the temperature gradient can be obtained by formula3.86.
通过对混凝土温度裂缝机理的分析，总结了混凝土温度应力的公式。
The formula of temperature stress by analyzing the cause of the the thermal crack control of concret is given.
得到在随时间变化的通道半径和固定输入总功率表面热源条件下的温度场计算公式。
Analytic solution of temperature pattern of round heat sources is presented under the changing discharge channel radius with time and fixed input total power.
该仪器具有显示温度波形曲线、热电偶标定、确定切削温度指数公式、判定切削状态的能力。
It is capable of displaying temperature flexuous curve, calibrating thermocouple, establishing the cutting temperature exponential formulation and predicating the state of cutting.
该仪器具有显示温度波形曲线、热电偶标定、确定切削温度指数公式、判定切削状态的能力。
It is capable of displaying temperature flexuous curve, calibrating thermocouple, establishing the cutting temperature exponential formulation and predicating the state of cutting.
应用推荐