系统以超声波作为检测信号源，采用多探头多方位扫描、液浸法的方式对齿轮进行检测。
The system uses ultrasonic wave as signal source, with the multi-probe multi-directions sweep, and fluid soak method test the gear.
以液固相反向凝固法生产的包铜钢线为研究对象，利用有限差分法分析了铜在钢线芯体上的浸覆过程；
The paper presents an study of copper clad steel wire produced by liquid and solid bonding method. Using the finite difference equation, the dipping process is analyzed.
在中药五倍子浸提液中用标准加入法进行回收实验，其平均回收率为100.6%。
Recovery tests of standard addition in Chinese gallnut samples showed an average recovery of 100. 6%.
该法简单、方便．方便工厂对浸锌液的维护。
The method is simple, convenient, which is suitable for factory to maintain zinc dipping solution.
采用酸浸法浸出废催化剂中的钼、镍、铋、镁，将浸出液沉钼酸后，对钼酸母液中的镍、铋、镁经过多级沉淀处理后加以综合回收。
Nickel bismuth magnesian is recycled by multiprecipitate after molybdenum is deposited from molybdenum-leaching solution and industrial production is realized.
文章综述了番茄红素的提取方法，包括直接粉碎法、有机溶剂浸提法、超临界流体萃取法、制备高压液相色谱及酶反应法等。
In this paper, the ways of lycopene production was reviewed, including extract by chemicals, supercritical fluid extraction, HPLC, enzyme extraction, and so on.
方法采用细胞毒性试验中的琼脂覆盖法，通过直接放置样品和放置样品浸提液载片两种方法，对三批不同生产日期的奥美定进行测试研究。
Methods Using NCTC 929 clone and agar diffusion method, the three products of different producing dates were evaluated by both methods of laying specimens directly and only laying its extraction.
冷冻冻干后，对支架材料进行组织学及扫描电镜观察，测定支架孔径和孔隙率、吸水率，并采用MTT法分析支架浸提液毒性。
The scaffolds were investigated by histological staining, SEM observation and porosity measurement, water absorption rate analysis. MTT test was also done to assess cytotoxicity of the scaffolds.
冷冻冻干后，对支架材料进行组织学及扫描电镜观察，测定支架孔径和孔隙率、吸水率，并采用MTT法分析支架浸提液毒性。
The scaffolds were investigated by histological staining, SEM observation and porosity measurement, water absorption rate analysis. MTT test was also done to assess cytotoxicity of the scaffolds.
应用推荐