本文根据模拟系统的概念和网络分析的一般原理，介绍了液体管路系统网络分析方法。
In this paper, based upon the concept of analogous systems and the general principle of network analysis, a network analysis method in Liquid tube system is presented.
当由于某种原因使输送液体管路中的调节阀迅速开闭，就可能引起水击，对设备和管道造成损坏。
The control valves in liquid pipelines shutting or opening fast due to some causes may result in pressure surge, which is dangerous to equipment and pipelines.
分析了平衡阀的特点，认为为改善液体管路系统的调节功能，用平衡阀取代截流孔板、闸阀及截止阀势在必行。
Discusses the feature of balance valves, considers that balance valves should be used in place of the orifice, gate valves and stop valves in order to improve regulating function of liquid pipe.
操作时，泵实际所能输送的液体量还与管路阻力及所需压力有关。
Operation, the actual pump to transfer the liquid in line with the resistance and the necessary pressure on.
介绍客车燃油液体加热器的特点、供暖量的计算及管路的连接方法。
This is an introduction of features of fuel fluid heater, calculation of heating quantity, and method of pipeline connection for buses and coaches.
管路中积存液体最小，流体阻力小，可以运送泥浆。
Least Liquid Stock in Pipeline, Small Flow Resistance Force, Can Delivery Slurry.
BSEN 10289岸上和海上管路钢管及配件加有环氧树脂和改性环氧树脂胶的外用液体。
BS EN 10289 Steel tubes and fittings for onshore and offshore pipelines-External liquid applied epoxy and epoxy-modified coatings.
当没有液体流经管路时，起初的反应是由于周围的温降和阀门打开时产生的。
When no fluid is flowing through the pipe, the initial response is due to an ambient temperature drop and the valve begins to open.
流体的液动力和管路工作压力及液体密度引起的压力三者叠加而形成管内压力。
In the pipe, the pressure consists of three parts of fluid dynamic, pipe operation pressure and fluid density pressure.
清洗时由管路阀门控制液体倒流，十分方便。
When cleaning, the valve of the pipeline controls the backflow of the liquid with convenience.
闭式系统中，液压泵的进油管直接与执行元件的回油管相连，工作液体在系统的管路中进行封闭循环。
Closed system, the hydraulic pump directly into the pipe return pipe connected to the implementation of components, working fluid in the system for closed loop pipeline.
电磁阀是用于液体和气体管路的一种开关控制，一般用于管道的控制。
Solenoid Valve is a kind of switching control applied in the liquid and gas pipelines, generally used for the control of pipes.
指出前者适合于大管路中的液体喷洒，不易发生气体短路；后者特别适用于大流量、高流速气体管路中的液体喷洒。
The former is used for liquid spraying in thick pipes to ensure against gas short-cut and the latter is particularly fit into the pipes with large flux and high velocity of gases passing through.
当这个异常压力达到隔膜式释压阀所设定的压力时，液体会由此阀回流，以达到保护泵浦及管路的目的。
If the liquid reaches the preload pressure of the relief valve, the liquid flows through it to prevent pumps and pipes from damaged.
在病人输液治疗过程中通常会有输液管路堵塞、液体输完和换瓶接续输液的情况发生。
During transfusion treatment, several situation would be faced, such as jam in the transfusion tube, drug driptup and changing the bottle.
在病人输液治疗过程中通常会有输液管路堵塞、液体输完和换瓶接续输液的情况发生。
During transfusion treatment, several situation would be faced, such as jam in the transfusion tube, drug driptup and changing the bottle.
应用推荐