我们花了几天的时间，打磨，沙光，涂底漆，上油漆，可是我们竟然上了室内用漆。
We spent days hand scraping and sanding, re-priming and -painting them, but we used indoor paint on them.
介绍农用运输车磷化、喷涂底漆、涂刮原子灰、喷涂聚氨酯磁漆等工艺流程及注意事项。
Application of polyurethane enamel on farmer trucks with key points in the processes of phosphating, priming, atomic ash puttying and enamel spraying is described.
还描述了通过提供预涂底漆或预封闭的水泥基基材和施用包括粉末涂料的顶涂层制造产品的方法。
Also described is a method of making a product by providing a pre-primed or pre-sealed cement-based substrate and applying a topcoat layer including a powder coating.
若溶液制备和使用合适，将为所有类型的底漆提供完好的刷漆基底，并容许延迟涂底漆的时间长达24小时。
When properly prepared and applied, these solutions provide a sound foundation for all types of primers and application of primers may be delayed as long as 24 hours.
在第一次应用或涂底漆之前，较小的裂缝、孔及表面缺陷应采用浆、水混合填料或水泥浆和砌浆进行填塞及填充。
Minor cracks holes and surface defects shall be made good with exterior grade water-mixed filler or masonry cement before application of the primer or first coat of paint.
清洗、打磨新零件并为其涂底漆，必要时，预先为不再接触的内部表面、接缝和边缘喷漆，或者如果这样做效果不佳，则在安装零件后就喷漆。
Cleaning new part sanding priming and if necessary pre-painting inner surfaces seams and edges that will no longer be accessible or insufficiently so after installation of the part.
在施工期间，车间底漆表面的任何损坏应该用电力工具进行清除，根据涂装计划直接涂第一度漆而不用进行底漆修补。
During construction, any damage to the shop primed surface shall be cleaned by power tools and directly painted with the first coat primer according to paint scheme without touch up of shop primer.
镀锌舾装件保护、车间底漆刷涂、预涂及其他要求同压载舱一致；
Protection of galvanization fittings, shop primer, stripe coat and other requirement etc. should be same as water ballast tank.
如在镀锌铁或其它金属表面使用，最好是先涂一道EMME P 401的水性防锈金属底漆，再涂刷emmeE442效果会更佳。
If it's to be painted on zincification or steeling or other metal surfaces, it's better to paint a film of EMME P401 water rust prevention metal primer before apply EMME E442.
分别对材料选择、底材处理、底着色、涂一道底漆、涂二道底漆、面修色、涂面漆工艺进行了处理。
The coating procedure thereof is described in terms of the material selection, substrate treatment, stain primer, binding primer, surface primer, finishing and et al.
研究发现底漆涂膜的机械性能和外观由改性醇酸树脂的配比、酯化温度以及工业底漆配比所决定的。
Mechanical properties and appearance of the cast film formed by this paint mainly depend on the addition of alkyd and industrial primer paint, as well as the esterization temperature.
研究发现底漆涂膜的机械性能和外观由改性醇酸树脂的配比、酯化温度以及工业底漆配比所决定。
Mechanical properties and appearance of the cast film formed by this paint mainly depended on the addition of alkyd and industrial primer paint, as well as the esterization temperature.
试制了环氧底漆用于复涂实验，考察了不同PVC含量对于复涂实验结果的影响。
The epoxy primer used in the recoating test was trial-produced and the effect of different content of the PVC on the result of recoating test was examined.
结果表明，在PV C含量高于CPVC的环氧底漆上复涂时，会引起所复涂涂料起泡的漆膜缺陷。
The result indicated when the epoxy primer in which the content of the PVC was higher than that of the CPVC was recoated, it would cause blistering on the paint film.
提出了一种新的天然石材饰面方法，即先用自干底漆预涂石材表面，然后用紫外光固化涂料罩面。
A new finishing method for the decoration of natural stone surface has been developed, which apply an air drying primer on the surface of natural stones, then a UV-curable clear top coat.
底漆是涂布路面标线用热熔涂料时使用的粘结材料，底漆起着防止涂膜剥落，提高涂膜和路面粘着力的作用。
Primer, a bonding material is used when making the heat fusion road markings. The prime can prevent the film from coming off and strengthen the adhesive force between the film and the road surface.
产品简介。 用于非浸泡区域钢材表面的厚涂型氯化橡胶防锈底漆 …
PRODUCT DESCRIPTION. A high-build general purpose rust … for steel in non-immersion areas.
产品简介。 用于非浸泡区域钢材表面的厚涂型氯化橡胶防锈底漆 …
PRODUCT DESCRIPTION. A high-build general purpose rust … for steel in non-immersion areas.
应用推荐