当利用这一配置测量漏流时，通过每个继电器的常闭触点同时向所有的二极管施加偏压。
When measuring the leakage current with this setup, the voltage bias is applied to all the diodes simultaneously through the normally closed contact of each relay.
输出触发可被连接到一个测量装置，例如伏特计。这样能够确保在开关触点完全稳定之后再进行测量。
The output trigger may be connected to a measuring device, such as a voltmeter. This will ensure the measurement is not made until the switch contacts have fully settled.
用动态接触电阻测量系统进行了电磁继电器失效检测试验，监测了其触点闭合过程的接触压降。
The contacts voltage of counterpart contacts in the close course of electromagnetic relay is observed and recorded in its failure tests using dynamic contact resistance measurement system.
用动态接触电阻测量系统进行了电磁继电器失效检测试验，检测了其触点闭合过程的接触压降。
The contact voltage-drop of counterpart contacts in the closing course of electromagnetism relay is observed and recorded in its failure test using dynamic contact resistance measurement system.
一维尺寸在线检测方法中，设计了柱形触点电感测头、自动上料机构和在线测量软件。
An inductance appearance with a pole probe, automation feed framework and mode of measurement on-line are designed in the single dimension checking.
这种方法在测量非常小的样品时特别有用，因为这时样品的尺寸和接触点的距离并不重要。
This method is particularly useful for measuring very small samples because the dimensions of the sample and the spacing of the contacts are unimportant.
应用自行设计的实验模型，在室温条件下，并在电阻性电路和电感性电路中，测量了金合金触点的电弧电压和电弧电流波形；
The experimental model designed was used to measure arc voltage and current waveforms of alloyed contact in resistive load circuit and inductive load circuit on the condition of room temperature;
方法测量11例骨性下颌前突伴偏斜患者治疗前模型，将上颌腭中缝作为中线标准，测量牙弓两侧同名牙接触点到腭中缝的距离，观测牙弓的对称性。
Methods Measurement of 11 dental models was performed, midline of palate was defined as central line, the distance of every contact point to the midline was measured in each side.
用于检查套管尺寸的多触点井径测量工具管串，采用结实的、安放位置经过优化的、弹簧加载的滚子及刚性臂扶正器进行居中。
The multifinger caliper tool string to be used for casing inspection was centralized using the combination of a strong, optimally placed, spring loaded roller and stiff arm centralizers.
本文采用两种实验方法对比测量可知通常的导线连接其接触点的电阻，并由此进行分析，阐述在双电桥测量低电阻实验中四端扭接法的必要性。
Henceforth, the article analyzes the necessity of the mode of the 4-terminal connection in the experiment of low resistance measurement using the double bridge.
本文采用两种实验方法对比测量可知通常的导线连接其接触点的电阻，并由此进行分析，阐述在双电桥测量低电阻实验中四端扭接法的必要性。
Henceforth, the article analyzes the necessity of the mode of the 4-terminal connection in the experiment of low resistance measurement using the double bridge.
应用推荐