然后平稳下降测量继电器的返回值。
Then steady decline measuring the return value of measuring relays.
电磁式继电器其动作值应测量继电器的冲击动作值。
Electromagnetic relay operating value shall be the impact operating value.
设计了测量继电器动作时间与释放时间的自动测试系统。
The automatic test system which can measure action time and release time of the relay is designed.
这类测量是在诸如连接器、继电器和开关等元件上进行的。
These types of measurements are made on components such as connectors, relays, and switches.
例如，在通过一个开关进行测量时，如果在继电器有足够的时间得到稳定之前读取读数，则该读数将是错误的。
For example, an erroneous reading will occur if a measurement is taken through a switch before the relay has had sufficient time to settle.
很多低电阻测量是在诸如开关、连接器和继电器接点等器件上进行的。
Many low resistance measurements are made on devices such as switches, connectors, and relay contacts.
当利用这一配置测量漏流时，通过每个继电器的常闭触点同时向所有的二极管施加偏压。
When measuring the leakage current with this setup, the voltage bias is applied to all the diodes simultaneously through the normally closed contact of each relay.
在继电器被闭合后，在进行测量之前要留有足够的稳定时间，这点非常重要。
After a relay is closed, it's important to allow sufficient settling time before taking a measurement.
提出一种串联电池组电压测量新方法：光电继电器取代机械继电器选通各节电池电压；
The paper puts forward a new method to measure series battery voltage, mechanical relay is replaced by photoelectric relay to select each battery voltage.
许多电子测试系统采用继电器切换的方式将多个装置连接到源和测量仪器。
Many electronic test systems use relay switching to connect multiple devices to sources and measurement instruments.
用动态接触电阻测量系统进行了电磁继电器失效检测试验，检测了其触点闭合过程的接触压降。
The contact voltage-drop of counterpart contacts in the closing course of electromagnetism relay is observed and recorded in its failure test using dynamic contact resistance measurement system.
用动态接触电阻测量系统进行了电磁继电器失效检测试验，监测了其触点闭合过程的接触压降。
The contacts voltage of counterpart contacts in the close course of electromagnetic relay is observed and recorded in its failure tests using dynamic contact resistance measurement system.
从理论上分析了同杆并架双回线跨线不接地故障时距离继电器测量阻抗的变化规律。
This paper analyses the rule of variations measuring impedance of distance relay when phase to phase fault occurs between two lines on double circuit line on the same pole (DLSP).
利用高精度激光位移传感器测量直流继电器触头弹跳的特征参数，通过实验研究其影响因素。
An experimental investigation of influencing factors on contact bounce of DC relay by using a high-precision laser displacement sensor was presented.
该仪器是专为简单的测量开关接触电阻，继电器，插头，连接器，或腿之间的电解铅和电极。
The instrument is specially designed for simplicity in measuring the contact resistance of switch, relay, plug, connector, or between electrolytic lead leg and electrode.
使用者可将继电器接地故障跳闸电流设置为高于最高值几毫安，以准确测量系统充电。
User is able to set the ground fault trip current of the relay just milliamps above the highest level, to accurately measure the system charging.
偏移特性阻抗继电器常用于小电流或大电流接地系统中作为输电线路距离保护的测量元件。
LZ-22 partial impedance relay usually used as measuring element on distance protection of the line at small or big current power system.
说明了阻抗继电器是建立在测量阻抗概念上的一类继电器；距离继电器是建立在补偿电压特点基础上的一类继电器。
It shows that impedance relay is a kind of relay based on the concept of measuring impedance and distance relay is a relay which is typical of compensating voltage.
介绍测量对地导纳原理的LD 3型发电机转子一点接地继电器的保护原理。
The paper introduces the principle of LD-3 rotor one-point grounding relay that measures the admittance against the ground.
提出了采用测量线路零序导纳进行接地保护的新原理，讨论了直线式导纳继电器的接地保护判据。
New principle for feeder grounding fault protection based on zero sequence admittance is presented in this paper. Criterions for the line ground relay with zero sequence admittance are also discussed.
铁路安全继电器是铁路系统中的重要执行元件，必须定期对其电气特性进行测量。
The railway safety relay is an important executable component in railway system, whose electrical characteristics must be tested timely.
接下来的检测工作。就是耍对继电器的电源输出状况进行测量。
The next testing. Is playing on the relay the status of the power output measurement.
把距离保护测量元件划分为阻抗继电器与距离继电器两大类。
In this article, the measuring elements of distance relay are divided into two main sorts, which are impedance relay and distance relay.
该校验仪通过步进电机对密度继电器压力进行调节，并通过模数转换电路采集压力传感器的输出，实现对密度继电器报警及闭锁压力的测量。
It can control the stepper motor to change the pressure of the relay, and the A/D circuit samples the signal of the pressure sensor and then acquires the lock or alarm value after processing.
结果表明，SSSC在故障范围之内时对阻抗继电器的测量阻抗产生了很大的影响，应该采取措施减小SSSC对阻抗继电器的影响；
The result shows the measured impedance is greatly influenced when SSSC is present in the fault loop, therefore measures should be taken to reduce the impacts of SSSC on the impedance relay.
该系统除了能够测量时间继电器时间段外，还可以测试信号的频率等。
In addition the system not only can test time of the time relay, but also can test the signal frequency.
详细分析了继电器抖动测试试验过程，以及在此试验过程中瞬时通断测量仪的作用。
This paper summarizes the relay twitter test in details, and explains the function of instantaneous switching instrument during this test.
详细分析了继电器抖动测试试验过程，以及在此试验过程中瞬时通断测量仪的作用。
This paper summarizes the relay twitter test in details, and explains the function of instantaneous switching instrument during this test.
应用推荐