用于标准系统双值和单值压力测量仪器,是为了满足带有压缩空气式制动器车辆压力测量,而专门研发的。
The double and single pressure measuring instruments in the standard systems were developed specially for the measurement of pressure in vehicles with a compressed air brake.
本仪器是一般是用标准器(如量块)以比较法测量工件的尺寸。
The optimeter is widely used to precisely measure external size of workpiece by comparison with a gauge block or standard part.
该标准采用了自动反馈和辅助加热器技术,大大缩短了测量时间,提高了校准速度。
Because the automatic feedback and auxiliary heater techniques are used in this standard, the measuring time is greatly reduced, and a high calibration speed is gotten.
按照国家标准,充油变压器的油中气体浓度至少是3个月测量一次,另外,测量过程十分复杂。
According to National Criteria, the measuring period for gas in oil concentrations of oil filled transformer is 3 months at least, and besides, the measuring procedure is complicated.
用于标准系统双值和单值压力测量仪器,是为了满足带有压缩空气式制动器车辆压力测量,而专门研发的。
The double and single pressure measuring instruments in the standard systems were developed specially for the measurement of pressure in vehicles with a compressed air brake .
在这种情况下会产生横波首波,因此可以使用基于单极子传感器的标准技术测量地层横波。
In such conditions a shear head wave is generated, so that standard techniques based on monopole transducers can be used to measure formation shear velocity.
而相关标准及导则的制订,直流金属氧化物电阻片的制造与检验,多柱(或只)避雷器的电流分布测量是其国产化的关键。
So, the key techniques for development of MOA domestics are correlation standards, making and test of elements for DC MOA, and the measurement of non-uniform current between multi-column arresters.
文章以2885型功率转换器为例,详细分析了其各标准不确定度分量并给出了功率转换器测量结果不确定度的评定方法。
The paper analyzes the standard uncertainties for the input estimates of the power converter and gives evaluation method on the uncertainty of measurement result by using the power converter 2885?
当测量温度中使用电阻式温度检测器,励磁电流本身这个温度产生I2r,或焦耳热化,产生一个比指示温度稍微高一点的温度标准。
When measuring temperature using an RTD, the excitation current itself produces I 2r, or Joule heating, producing an indicated temperature somewhat higher than the temperature being measured.
该系统通过JFD-301校准脉冲发生器对标准波形进行校准及比较法,可测量出局部放电的视在电荷量。
Owe system the amounts adjusting a circuit carrying out calibration and comparison method on standard wave form , may measure out part discharging looking at in electric charge by JFD-301.
该分压器现已作为标准测量设备在我国国家高电压计量站投入使用。
Now, this divider is already put in service at the Chinese National High Voltage Metrological Station as a standard measuring device.
视觉判断、在固定标志点弹性带子测量、解剖标志点固定通用量角器和CROM量角器比较,CROM量角器测量认为是一种参考标准。
Visual estimation, tape measurement between fixed landmarks, and the UG aligned on fixed and anatomic landmarks were compared with the CROM goniometer, which was used as the reference standard.
我国水面蒸发量观测仪器类型很多,通过不断改进,1988年规范规定E- 601型蒸发器为水面蒸发测量的标准仪器。
Through successive improvement, the E-601 type of evaporimeter was stipulated as a standard measuring instrument in China for water-surface evaporation capacity in 1988.
系统地分析了容重器的容积测量结果标准不确定度的影响因素,并进行了较详细的评定。
The influential factors of the standard uncertainty are analysized systematically and evaluated in detail to the volume of the volume-weight instrument.
通过测量标准样品的绝对相位,为不同角度放置的投影器产生不同的反向条纹。
Through the absolute phase measurement of the master object, different inverse fringes are generated for the different projectors placed in different directions.
不同测量者用方盘量角器在相同人身上测得的数据的标准差明显小于通用量角器。
The standard difference of data taken from the same person with the square goniometer by different examiner were smaller than that with the universal goniometer.
通过对修复后的变压器有载开关偏移电压的测量 ,发现有载开关偏移电压比标准值高了 6 0 %。
The OLTC recovery voltage is measured after reparation. The results show that the recovery voltage is 60% higher than the standard value.
测量与补偿器是一个标准的ASTM标准测试程序2,是一种特别有效的工具,实验室的质量控制明确塑料工业。
Measuring with a compensator is a standard ASTM test procedure 2 and is a particularly effective laboratory tool for quality control of clear plastics.
本文介绍光电探测器相对光谱响应度标准的实验装置、方法及测量结果。
This paper describes the experimental system, measuring method and results of the standard for the relative spectral responsivity of optical radiation detectors.
气泵和水泵使标准海水测量水样循环流过剖面仪传感器。
The gas pump and the water pump enable the flow of the standard sea water measurement water sample over the section instrument sensor.
所述测量系统由电压传感器、电流传感器和标准电能表构成;
The measurement system comprises a voltage sensor, a current sensor and a standard electric energy meter.
同类型的680压阻测量元件的压力变送器的补偿,调整和放大传感器信号,即是标准电压或电流输出可用。
The pressure transmitters of type 680 with piezoresistive measuring elements have compensated, adjusted and amplified sensor signals which are available as standard voltage or current outputs.
同类型的681压阻测量元件的压力变送器的补偿,调整和放大传感器信号,即是标准电压或电流输出可用。
The pressure transmitters of type 681 with piezoresistive measuring elements have compensated, adjusted and amplified sensor signals which are available as standard voltage or current outputs.
针对BUA测量受超声信号的频带及传感器特性影响较大的问题,制定适合目前相关仪器现状的客观标准,提出了一种验证BUA测量系统准确性的方法。
Aiming at the results affected deeply by signal bandwidth and transducer frequency response, we present an objective criteria and method to verify exactitude of the instrument system.
该仪器符合IEC 61672标准,可与声校准器提供的,如果你想验证你的测量 -作为真正应该做的骏凯电子批发英国 Pulsar 噪音计。
The instrument is compliant with IEC 61672 and can be supplied with an acoustic calibrator if you wish to verify your measurements – as really should be done.
该仪器符合IEC 61672标准,可与声校准器提供的,如果你想验证你的测量 -作为真正应该做的骏凯电子批发英国 Pulsar 噪音计。
The instrument is compliant with IEC 61672 and can be supplied with an acoustic calibrator if you wish to verify your measurements – as really should be done.
应用推荐