用粒子成像测速技术（PIV）和稳态法分别测量均相流体在热管生物反应器中湍流时的流场、温度场；
The flow field and temperature field of the uniformity phase fluid were measured by PIV and the steadystate method during the state of onflow.
进行各种电阻温度测量时，建议使用三根导线的热电阻探测器电缆。这样就可降低环境温度对电缆的影响。
With all the resistance-temperature measurements, the use of three conductor RTD cable is recommended. The effect of ambient temperature variations on the cable is thereby minimized.
那个小男孩误解了华氏度和摄氏度在测量温度时的标准不同，导致他相信他达到了接近死亡的高温。
The small boy's misunderstanding of the difference in measuring temperature on a Fahrenheit and a Celsius scale causes him to believe that he is dying of a high fever.
给出了应变传感器进行应变测量时的温度补偿公式与工程实施方案。
The formula of temperature compensation and the project of construction during strain measuring are presented.
当输入为单波长信号光时，可以通过测量探测器输出的电信号来获得光纤光栅所承受的温度和应变信息。
The amount of the temperature or strain imposed on this device was obtained by measuring the electric signals changing with the shift of resonant wavelength.
测量了在不同的一次风旋流数下，气体的时均温度、O2、CO2、CO和NO浓度的分布。
The distributions of gas temperature, O2, CO2, CO, and NO concentrations were measured under different swirl numbers for the primary air.
在单道多层熔覆中测量了熔覆不同层时熔池温度的变化，分析了结合面的金相和熔覆层的组织结构。
The change of molten pool temperature of different layers was measured, and the Metallographic and Microstructures in combined interface were analyzed.
介绍了用电荷交换分析器测量了HT-6M托卡马克离子回旋共振频率加热时的氢离子能谱，观察到离子温度的增加。
The hydrogen energy spectra during ICRF heating were measured with neutral particle analyzer in the HT-6M Tokamak lon temperature increase are observed.
采用绞状缠绕式的热电偶计工作在打火功率以下时，测量了不同反应压强下的微波等离子体空间温度。
Under striking power, the temperature of microwave plasmas interspace with different reaction pressure was measured by the intertwined thermocouple.
本文叙述了石油探矿与开采时测量温度所需要的仪器。
This paper reported the temperature measuring instrument used in petroleum prospecting and production.
在现场测量了破碎机破碎烧结矿时其齿冠的表面温度和环境温度。
The surface and ambient temperatures of the crown of crusher in crushing sintering ore were measured in situ.
介绍了一种以555时基集成电路和单片机构成的全数字化温度测量电路及其工作原理。
A kind of totally digitized temperature measuring circuit consisted of 555 time base integrated circuit and MCU and its operation principle are introduced.
因此，在被动式测量时，要密切注意发射源温度以及发射源发射信号大小，以便获得最佳仪器响应函数校正结果。
So, during passive FTIR measurement, the temperature and the emission signal amplitude of the source must be observed carefully in order to get satisfactory instrument response function.
利用空气焓值测量方法对热泵的制热量进行测量时，通常采用测流量法测量空气的流量和截面平均温度。
When we measure the heat capacity of heat pump by enthalpy measuring method, we use flow rate measuring method to measure flow rate and sectional mean temperature of air.
而在钻孔测量温度时，由于地下水流动的影响，钻孔温度曲线将发生异常变化。
Moreover, influenced by the movement of groundwater, there will be abnormality in temperature distribution curve in borehole.
但是当科学家测量出行星的夜间温度时，他们都惊呆了！夜间温度仅有500度。
But when scientists measured the planet's nighttime temperature, they were shocked to find that it was only 500 degrees cooler.
目前的热流计在测量热量时需要测量供热管道的流量以及进出口温度，然后再对其进行积分计算。
The flux and the temperature difference between inlet and outlet of the heat-supply system must be measured when measuring heat flux by heat meter, and then the result can be calculated.
利用热电偶在微波环境中测量温度时，存在着明显的温度响应波动。
It was found that there was a distinct response fluctuation when temperature was measured by thermocouple in a microwave field.
利用空气焓差法进行热泵空气侧换热量测量时，通常采用测流量法测量风的流量和截面平均温度。
When we measure the air heat capacity of heat pump by enthalpy potential method, the flow rate measuring method was used to measure flow rate and sectional mean temperature of air.
同时对晶须增韧陶瓷刀具在不同速度下切削航空镍基合金GH761时的切削温度进行了测量。
The temperatures of whisker ceramic tool JX-1 when machining air-nickel based alloy GH761 at a range of speeds were measured.
在对温度敏感的器件，如热敏电阻，进行温度测量时，要考虑器件的加热问题。
Device heating can be a consideration when making resistance measurements on temperature-sensitive devices such as thermistors.
测量蒸汽或其它高温介质时，注意不要使变送器的工作温度超限。
While measuring the high temperature mediums, please do not exceed the temperature limitation.
当靶到阴极距离为几十厘米时，也可用于测量爆推靶内爆中子能谱多普勒展宽，从而确定等离子体离子温度。
The neutron streak image tube also can be used to determine the temperature of the plasma of the implosion of DT-filled targets by measuring the Doppler broadening.
在使用温度脉动仪测量温度结构常数时，平均时间长度的选择会影响其测量结果。
To measure the atmospheric optical turbulence, the micro-temperature sensor is often used. But statistic average time can affect the measuring results of temperature structure constants.
实验结果表明该方法能提高OCT测量准确度和稳定性，使得二次部分在同样的温度范围内时，OCT能满足0.2级准确度的要求。
The experiment results has proven that the method can improve the accuracy and stability of OCT and OCT can satisfy0.2class request when the secondary part is at the same temperature range.
当剪切温度接近或超过反常点时，测量温度下的粘弹性参数基本不随剪切温度变化；
When the shear temperature was close to or higher than abnormal point, the viscoelastic parameters varied little with the shear temperature.
在此系统中我们还采用了报警系统，当温度超过了这个测量范围时就会发出警报。
When the temperature is over the measure range the system will give an alarm.
在设定的速度和温度的测试条件下，测量被检测的沥青样品在分开时的长度。
Measures the distance of elongation of a bitumen sample when a briquet specimen is pulled apart at a specified speed and temperature.
上述数据可供用它作测量不透明材料冲击温度窗口材料时进行阻抗失配和温度失配分析时的依据。
The above data could be used to analyze the impedance and temperature mismatching levels between the non-transparent sample material being studied and the window material as a partly data base.
上述数据可供用它作测量不透明材料冲击温度窗口材料时进行阻抗失配和温度失配分析时的依据。
The above data could be used to analyze the impedance and temperature mismatching levels between the non-transparent sample material being studied and the window material as a partly data base.
应用推荐