讨论了工业腐蚀测量中测量探头的设计。
The design of probe applied in corrosion measurement was discussed in this paper.
一个内置的RTD温度测量探头，实时测量测量室的温度。
A built-in temperature detector (RTD) senses actual temperature in the measurement chamber.
此外，所述测量探头包括多个传感器，分别用于获取不同的类型数据参数。
In addition, the measuring probe consists of a plurality of sensors, which are respectively used for acquiring different types of data parameters.
分析了测量探头对耦合函数测量的影响，验证了耦合函数随入射电场方向变化的公式。
This paper analyses the effect of the probe on the measurements of coupling function, and verifies the formulation of coupling function for different incident electric field directions.
由于淬火过程中探头表面传热行为的复杂性，所示直接测量探头表面温度是非常困难的。
It is difficult to directly measure the surface temperature of the probe due to the complexity of heat transfer behavior on the probe surface in quench process.
SPMA使用的定制和可扩展的通信和数据表达模型和部署基于代理技术自动测量探头。
SPMA makes use of a customized and extensible model for communication and data expression and deploys measurement probes automatically based on agent technique.
文章对各种测量探头的原理进行了分析，理论结合实际，将原理图和现场安装图进行对照，通俗易懂。
The principle of kinds of measuring probe was analyzed, and elementary diagram and site installation drawing were compared for better understanding.
电流测量探头采用自积分的罗柯夫斯基线圈，自积分电阻的电感、电容要尽可能的小，并采用同轴结构。
The Rogowski coil ranged in the same axis was used as current sensor, in which the self-integral resistance should has smaller inductance and smaller capacitance as possible.
对于A型生物测量探头，通过在声束定向、测量位置和声速设置等方面的设计思想，有效提高测量精度。
For an a mode biometric probe, ultrasonic beam orientation, measuring position and speed setting ensured the precision of the measurement.
当电压表测量探头2和探头3之间的电压降时，该交流电流在r3上产生的电压降就会引起错误的结果。
The resulting voltage drop across r3 will cause erroneous results when the voltmeter measures the voltage drop between probes 2 and 3.
二是设计出全新的流动成像测量探头，通过设置屏蔽电极和聚焦电流，可以有效克服“软场”效应影响。
Secondly, a new type of flow image logging sensor has been designed, which is set with shielding and focusing electrodes and capable of reducing the influence caused by "soft field" property.
此次设计的关键之处是设计了一种避免油污污染测量探头的结构，从而使污水含油率检测能够实现真正的在线。
It is the key of the paper to design a type of detecting structure, which can avoid being contaminated by smeary oil, so that the on-line test of oil content in the wastewater can be realized in deed.
本文建立了有血管存在的生物分层组织模型，在此基础上首次分析了血液的存在及流动对测量探头反射系数的影响。
Simulation results show that: a the blood vessels in layered tissues may have a great influence on the reflection coefficient.
介绍一套基于四电极测量原理的中低频液体阻抗测量系统，采用四电极的测量探头用于电导性液体中低频阻抗谱的测量。
An impedance spectroscopy measurement system for conductive aqueous solution at medium to low frequencies is designed using the four-electrode measurement theory.
本实用新型公开了一种用于紫外光照强度检测的无线测量装置，该装置由测量探头（1）和接收主机（2）两部分构成。
The utility model discloses a wireless measuring device for detecting ultraviolet illumination intensity, which comprises a measuring probe (1) and a main receiver (2).
探头误差分析和修正是时域近场测量中的关键技术。
Probe errors analysis and correction are the key technique in time domain near field measurement.
从本质上看，探头是示波器测量链中的首要环节。
In essence, the probe is the first link in the oscilloscope measurement chain.
对于高频或低幅值测量﹐探头的地应接到测试电路中的适当位置。
For high frequency, or low amplitude measurement, probe ground shall be connected to appropriate points in the circuit under test.
已经设计出专门的探头来测量半导体晶圆片和半导体棒的电阻率。
Special probes have been designed for making resistivity measurements on semiconductor wafers and bars.
本文提出了一种基于电涡流传感器的双探头测量电机硅钢片轧板厚度以控制铁心叠厚的方法。
This paper presents a feasible solution of motor core height control based on silicon steel sheet thickness measuring with double eddy current sensors.
探头以增量光栅为基础，确保在整个测量范围中最好的空间精度。
The probe is based on an incremental glass scale insuring the best dimensional accuracy over the whole measuring span.
结果表明，LDA探头非垂直布置时，测量控制体具有与垂直布置时不同的性质。
The results show that the measurement volume with off-axis of the LDA-probe has different performance from that with on-axis probe.
通过带有触发与协议同步的波形输出到记录仪的激活探头，人们可以测量运行中的设备。用户可以获得用于。
Due to its active probe heads including a trigger output for protocol-synchronous recording at the oscilloscope reactionless measuring under operating conditions of your plant can be executed.
用示波器和探头对信号进行测量，是对信号进行分析和采样的手段之一。
Measuring signals with an oscilloscope and its probes is one of signal analyzing and sampling means.
结果表明：探头线圈满足测量范围及灵敏度的要求，且具有良好的线性度。
The test results show that the probe coil provides the desired measurement range and sensitivity with good linearity.
近场测量的准确度很大程度上取决于探头的精确定位。
The accuracy of near field measurement largely depends on precise location of probe antenna.
该系统以菜单形式实现地质探头的系数标定、土层压力的测量。
This system implemented factor demarcation of geological sensor, data measurement of earth pressure in the menu form.
该问题属不定问题，即根据探头测量的微小磁场所建立的方程组求得的未知脑磁源有无穷组解。
This question belongs to the indeterminate problem, that is, infinite solutions can be obtained from the equations of the measured small magnetic fields on the detector.
该文提出了一种修正平面近场测量中探头位置误差的算法，并进行了计算机模拟。
An algorithm for correcting probe position errors in planar near-field measurements is presented and simulated.
该文提出了一种修正平面近场测量中探头位置误差的算法，并进行了计算机模拟。
An algorithm for correcting probe position errors in planar near-field measurements is presented and simulated.
应用推荐