当晶体管测温器接到后板上并且其温度在-20度到60度之间时，这盏灯就亮了。
The lamp lights when the transistor temperature probe is connected to the rear panel and its temperature is between -20~60’C.
而焊管生产的特点和某些不稳定因素，只能采用非接触的辐射测温方法。
Only adopt non contacting radiation temperature measurement method is determined due to the characteristic and certain instability factors of welded pipe manufacture.
为了观察由板流引起的灯丝温度下降现象，利用红外测温仪对理想二极管灯丝温度作了精密测量。
In order to observe the phenomenon of the filament temperature drop caused by the board-current, the ideal diode filament temperature was detected precisely with an infrared thermometer.
双数码管直接显示实测温度和设定温度。
Dual digital display shows the actual temperature and the setting temperature.
介绍了符合热电偶热电势的红外测温探头、复合管型铠装热电偶等新型温度传感器。
Some of the novel temperature transducers which meet the thermal potential of thermocouples, e. g. the infrared temperature probe and compound armored thermocouple are introduced.
本文提出了采用带保护管热电偶的一种动态测温方法，可大大提高普通热电偶的测温上限。
A method for dynamic measurement of thermocouples protected by metal tube is developed, and by using it we can greatly raise the upper limit value of thermocouples.
本文针对转管炮炮壁温度测试过程中存在的测试环境恶劣、干扰多等特点，设计了基于K型热电偶的离线式测温系统。
So an based on the K-type thermocouple temperature measurement system of the off-line is designed in the article.
该护管将该温度计的测温端挡住。
The protecting tube block the temperature measuring end of the thermometer.
基于数字温度传感器ds18b20的测温仪设计，三位数码管显示温度值，保留小数点后一位。
Digital temperature sensor based on the thermometer DS18B20 design, the three digital display temperature, keep one decimal place.
碳化硅保护管热电偶常用于各种金属液的测温，工业用装配式热电偶作为测量温度的传感器，通常和显示仪表、记录仪表、调节器、PLC和DCS系统配套使用。
As a sensor for measuring temperature, industrial assembly thermocouple are usually compatible with display instrument, recording instrument, actuator, PLC and DCS system.
碳化硅保护管热电偶常用于各种金属液的测温，工业用装配式热电偶作为测量温度的传感器，通常和显示仪表、记录仪表、调节器、PLC和DCS系统配套使用。
As a sensor for measuring temperature, industrial assembly thermocouple are usually compatible with display instrument, recording instrument, actuator, PLC and DCS system.
应用推荐